Sample paper · GCSE Foundation · grades 1–5
GCSE Foundation sample Paper 2 (calculator)
The real Paper 2 is 1.5 hour 30 minutes and 80 marks, calculator, and all three papers carry equal weight. This sample is 20 original questions in the same content proportions as the Foundation qualification — number 25%, algebra 20%, ratio, proportion and rates of change 25%, geometry and measures 15%, probability 7.5%, statistics 7.5% — with a calculator allowed. AO1 / AO2 / AO3 at this tier: 50% / 25% / 25%.
CalculatorGCSE Foundation
Answer key: GCSE Foundation sample Paper 2 (calculator)
MathsUKwww.geekhero.co.uk
- (d) 0.024 cm — Method: significant figures are counted from the first non-zero digit; the zeros in front of it only fix the place value and are not significant. Working: in 0.02384 the first significant figure is 2 and the second is 3, so the rounding is decided by the next digit, 8. As 8 is 5 or more, the second significant figure goes up from 3 to 4, in the same place value. Answer: 0.024 cm. The distractors: 0.023 cm comes from chopping the 84 off instead of rounding it; 0.02 cm comes from counting the leading zeros as significant figures, so the 2 is taken as the second figure and the rounding stops there; 0.0238 cm is 0.02384 correct to 3 significant figures, one figure too many.
- (a) 5 — Method: apply the machine's operation to the input, and treat zero as an input like any other. Working: the machine gives 0 + 5, and counting on 5 from zero leaves the 5 unchanged. Answer: 5. The distractors: 0 comes from assuming that an input of 0 must give an output of 0, which is true for a machine that multiplies but not for one that adds; −5 comes from subtracting 5 instead of adding it; 6 comes from treating the input as 1 rather than 0 and working out 1 + 5.
- (a) £9.00 — Rate of pay = total pay ÷ number of hours. £54 ÷ 6 = £9.00 per hour. £324.00 comes from multiplying the pay by the hours instead of dividing (£54 × 6). £0.11 comes from dividing the hours by the pay instead of the pay by the hours (6 ÷ 54). £48.00 comes from subtracting the hours from the pay (£54 − 6) instead of dividing.
- (c) 62° — Co-interior (allied) angles on parallel lines sum to 180°, so the co-interior angle is 180° − 118° = 62°. 118° comes from treating the angles as corresponding angles, which are equal, instead of co-interior angles, which sum to 180°. 59° comes from halving the given angle. 236° comes from doubling the given angle.
- (d) 124/125 — The probability that a seed germinates is 1 − 1/5 = 4/5, so the probability that all three seeds fail to germinate is 1/5 × 1/5 × 1/5 = 1/125. The probability that at least one germinates is 1 − 1/125 = 124/125. Choosing 4/5 comes from giving the probability that a single seed germinates, forgetting to combine all three seeds. Choosing 64/125 comes from working out the probability that ALL three seeds germinate, 4/5 × 4/5 × 4/5 = 64/125, instead of at least one. Choosing 12/125 comes from working out the probability that EXACTLY one seed germinates, 3 × 4/5 × 1/5 × 1/5 = 12/125, instead of at least one.
- (b) All 2,000 members of the sports centre. — Method: in a survey, the population is the whole group the survey is trying to find out about, and the sample is the smaller group actually asked. Working: this survey wants to know what the sports centre's members think, so the population is every one of the 2,000 members — whether or not they were personally asked. Saying the population is the 100 members who were asked names the sample, not the population; the sample is drawn FROM the population, so it is smaller than it, not the same as it. Saying the population is everybody who lives in Ipswich widens the group far beyond who the survey is actually about — plenty of Ipswich residents are not members of the sports centre at all, so they are outside this survey altogether. Saying the population is the members who say they are unhappy confuses the population with a result of the survey: whether a member turns out to be happy or unhappy is something the survey finds out, not part of the definition of who is being studied. The population is always the whole group the question is about, before any sampling or any results come in.
- (d) 6 — Method: the square root of a product can be found either by multiplying first and then rooting, or by rooting each factor and multiplying the two roots together. Working: 4 × 9 = 36, and 6 × 6 = 36, so the root is 6; the same value comes from √4 × √9 = 2 × 3. Answer: 6. The distractors: 36 comes from multiplying inside the root and then leaving the root untaken; 5 comes from rooting each factor and adding the results, 2 + 3, instead of multiplying them; 18 comes from rooting the 4 only and leaving the 9 untouched, giving 2 × 9.
- (a) 2x + 24 — Method: multiply each term inside the bracket by the 2 in front of it. Working: 2 × x = 2x and 2 × 12 = 24, and the products are added because the bracket contains an addition. Answer: 2x + 24. The distractors: 2x + 12 comes from multiplying only the x by 2 and copying the 12 across unchanged; 24x comes from multiplying 2 by 12 and then attaching the letter to that product, as though the two terms inside the bracket could be joined into one; 2x + 14 comes from adding 2 and 12 instead of multiplying them.
- (d) 30 — Method: 50% is one half, so 50% of a quantity is the quantity divided by 2. Working: 60 ÷ 2 = 30. Answer: 30. The distractors: 120 comes from multiplying by 2 instead of dividing; 3000 comes from multiplying by 50 without dividing by 100; 6 comes from finding 10% instead of 50%.
- (a) 3 squares — Method: the plan view shows only the floor positions that have at least one cube standing on them; height does not add extra squares to the plan. Working: the base row occupies three floor positions in a line. The two extra cubes stand on top of two of those same three positions, so they do not create any new floor position. Answer: 3 squares. The distractors: 5 squares comes from adding the total number of cubes used (3 + 2 = 5) instead of counting distinct floor positions. 2 squares comes from counting only the raised two-cube section and ignoring the single cube at the other end of the row. 4 squares comes from counting one of the shared positions twice.
- (a) 160 — Expected number = probability × number of trials = 0.08 × 2,000 = 160. Moving the decimal point one place too far, using 0.008 instead of 0.08, gives 2,000 × 0.008 = 16. Working out the expected number of customers who do NOT buy a bag, using the complement 1 − 0.08 = 0.92, gives 2,000 × 0.92 = 1,840. Rounding 0.08 up to 0.1 before multiplying gives 2,000 × 0.1 = 200.
- (a) 7/8 — Method: write the decimal over the power of ten that matches the number of digits after the point, then divide the numerator and the denominator by their highest common factor. Working: 0.875 has three digits after the point, so it is 875 thousandths and can be written as 875/1000; the highest common factor of 875 and 1000 is 125, and 875 ÷ 125 = 7 with 1000 ÷ 125 = 8. Answer: 7/8. The distractors: 8/7 comes from cancelling correctly but writing the two parts the wrong way round; 9/10 comes from rounding 0.875 to one decimal place as 0.9 before converting; 7/80 comes from counting four decimal places instead of three and using a denominator of 10000, giving 875/10000.
- (a) 216 — The cube numbers are formed by cubing 1, 2, 3, 4, 5, ..., so the next one is 6³ = 216. A candidate who squares 6 instead of cubing it gets 6² = 36. A candidate who assumes the sequence doubles each time gets 125 × 2 = 250. A candidate who uses 5 × 6² instead of 6 × 6 × 6 gets 180.
- (a) 4:3 — Multiply both parts by the lowest common denominator, 6: (2/3) × 6 = 4 and (1/2) × 6 = 3, giving the ratio 4 : 3, which is already in simplest form.
- (a) 143° — Angles on a straight line add up to 180°. Set up 37° + x = 180°. Subtract: x = 180° − 37° = 143°. 53° comes from using 90° as the total, as if the two angles made a right angle, instead of the 180° of a straight line.
- (a) 0.55, 58%, 3/5 — Converting all three to decimals: 3/5 = 0.6, 0.55 stays as 0.55, and 58% = 0.58. In order from smallest to largest, this is 0.55, then 58%, then 3/5. Writing the numbers in the reverse order, largest to smallest, gives 3/5, 58%, 0.55. Misconverting 3/5 as 0.5 instead of 0.6 makes it appear smaller than both other values, giving the order 3/5, 0.55, 58%. Misconverting 58% as 0.058 instead of 0.58, by moving the decimal point two extra places, makes it appear smallest of the three, giving the order 58%, 0.55, 3/5.
- (d) 4y — Method: the perimeter is the total distance round the outside of the shape, and a square has four sides all of the same length. Working: the four sides are y, y, y and y, so the perimeter is y + y + y + y, which is written as 4y. Answer: 4y. The distractors: 2y comes from adding only two of the four sides, as if the square were being treated like a rectangle with one length and one width; y² comes from working out the area of the square, y × y, instead of its perimeter; y + 4 comes from adding 4 to the side length instead of multiplying the side length by 4.
- (d) 35 — Method: in direct proportion the ratio y : x is the same for every pair, so find the constant and substitute the new value of x. Working: k = 20 ÷ 8 = 2.5, so y = 2.5x; when x = 14, y = 2.5 × 14 = 35. Answer: 35. The distractors: 26 comes from additive thinking — x rises by 6, so 6 is added to y — which would keep the difference constant rather than the ratio; 28 comes from rounding the constant 2.5 down to 2 and working out 2 × 14, which loses the half in the constant; 5.6 comes from using the constant upside down, 8 ÷ 20 = 0.4, and working out 0.4 × 14.
- (b) −18 — Method: the multiplication is carried out before the addition, and a negative multiplied by a positive is negative. Working: (−4) × 3 = −12, so the calculation becomes (−6) + (−12) = −18. Answer: −18. The distractors: −30 comes from adding first and multiplying afterwards, giving (−6 + −4) × 3 = −10 × 3 = −30; 6 comes from treating (−4) × 3 as +12 on the grounds that a minus sign makes a product positive, giving −6 + 12 = 6; 18 comes from ignoring both minus signs and working out 6 + 4 × 3 = 18.
- (a) 20 litres per minute — Method: the gradient is the change in the vertical value divided by the change in the horizontal value, and its units are the vertical unit for each one of the horizontal unit. Working: from (2, 50) to (6, 130) the volume changes by 130 − 50 = 80 litres and the time changes by 6 − 2 = 4 minutes, so the gradient is 80 ÷ 4 = 20, measured in litres for each minute. Answer: 20 litres per minute. The distractors: 25 litres per minute comes from using one point on its own, 50 ÷ 2, which assumes the line starts at the origin when the tank already held 50 litres at 2 minutes; 0.05 litres per minute comes from dividing the change in time by the change in volume, 4 ÷ 80, which gives the time for each litre but is then labelled as litres for each minute; 20 minutes for each litre has the right value with the units the wrong way round, and a tank that needed 20 minutes to gain a single litre would be filling far more slowly than this one.
How the 20 questions are shared out
- Number — 5 questions (25% of the qualification)
- Algebra — 4 questions (20% of the qualification)
- Ratio, proportion and rates of change — 5 questions (25% of the qualification)
- Geometry and measures — 3 questions (15% of the qualification)
- Probability — 2 questions (7.5% of the qualification)
- Statistics — 1 question (7.5% of the qualification)
Where an area has fewer printable questions than its share, the shortfall is filled from the other areas. These are original questions, not past papers.