Sample paper · GCSE Foundation · grades 1–5
GCSE Foundation sample Paper 2 (calculator)
The real Paper 2 is 1.5 hour 30 minutes and 80 marks, calculator, and all three papers carry equal weight. This sample is 20 original questions in the same content proportions as the Foundation qualification — number 25%, algebra 20%, ratio, proportion and rates of change 25%, geometry and measures 15%, probability 7.5%, statistics 7.5% — with a calculator allowed. AO1 / AO2 / AO3 at this tier: 50% / 25% / 25%.
CalculatorGCSE Foundation
Answer key: GCSE Foundation sample Paper 2 (calculator)
MathsUKwww.geekhero.co.uk
- (a) 8 × 10³ — Method: divide the capacity of the card by the size of one photograph, dividing the coefficients and subtracting the indices, then bring the coefficient back into the range 1 to 10. Working: 3.2 ÷ 4 = 0.8 and 10 − 6 = 4, which gives 0.8 × 10⁴; a coefficient of 0.8 is smaller than 1, so the decimal point moves one place to the right and the index falls by 1. Answer: 8 × 10³. The distractors: 8 × 10⁴ comes from correcting 0.8 to 8 without reducing the index, which makes the answer ten times too large; 1.28 × 10¹⁷ comes from multiplying the two numbers instead of dividing them, since 3.2 × 4 = 12.8 and 10 + 6 = 16; 8 × 10¹⁵ comes from dividing the coefficients but adding the indices instead of subtracting them.
- (d) 5x² — 5x² is a single term: a product of a number and a power of a letter, with no + or − sign attached to anything else. A candidate who picks 5x² + 3x is choosing the expression that contains that term, rather than the term on its own. A candidate who picks 5x² = 20 is drawn in by the equals sign and misses that this makes it an equation. A candidate who picks A = 5x² thinks any statement with a letter and a number combined must be a formula.
- (c) £4.00 — Find the cost of one pen: £6.40 ÷ 8 = £0.80. Then multiply by 5 pens: £0.80 × 5 = £4.00. Dividing £6.40 by 5 and multiplying by 8 gives £10.24 — that uses the ratio the wrong way round, scaling as if 5 pens were more expensive than 8. Stopping at £0.80 only gives the price of one pen. Multiplying the price of one pen by the difference in the number of pens, (8 − 5) × £0.80, gives £2.40 — the cost of the pens NOT bought, not the cost of the 5 pens bought. 5 pens cost £4.00.
- (d) 600 cm² — Enlarging by scale factor 2 makes the new dimensions 10 × 2 = 20 cm and 15 × 2 = 30 cm, so the poster's area = 20 × 30 = 600 cm². A pupil who scales the original area, 150 cm², by the scale factor itself instead of by its square gets 150 × 2 = 300 cm². A pupil who adds the scale factor to each dimension instead of multiplying gets (10 + 2) × (15 + 2) = 204 cm². A pupil who forgets to enlarge the postcard at all just uses the original area, 150 cm². The correct area of the poster is 600 cm².
- (c) 10 — There are 5 possible cards and 2 possible coin results, so listing every pair gives 5 × 2 = 10 equally likely outcomes. Choosing 5 comes from listing only the card outcomes and forgetting the coin flip adds a second stage to each one. Choosing 7 comes from adding the two stages instead of combining them, 5 + 2 = 7, rather than pairing every card with every coin result. Choosing 20 comes from counting each coin result twice for every card, 5 × 2 × 2 = 20, effectively pairing every card with the coin twice over.
- (c) The data show a link only; a third factor may affect both — Method: a study of this kind measures two quantities and reports how they change together; deciding that one of them produces the other is a further claim, and it needs evidence that the measurements alone cannot give. Working: the study shows that more coffee goes with better concentration, which is a positive correlation; but a third factor that was never measured, such as how motivated someone is, could raise both the coffee drinking and the concentration, and the concentration could equally be what leads to the extra coffee. Answer: the data show a link only, because a third factor may be affecting both quantities, so no claim about cause can be made. The distractors: calling the conclusion safe because the correlation is positive treats the direction of a correlation as proof of cause, which no direction can give; calling it wrong because the correlation is negative misreads the direction of the relationship, since the study reports both quantities rising together; saying the two quantities are not linked denies the correlation the study actually found, when what fails is only the claim about cause.
- (a) 11:20 — Method: find the flight time using time = distance ÷ speed, then add this to the departure time. Working: 2340 ÷ 780 = 3 hours; 08:20 + 3 hours = 11:20. Answer: 11:20. 08:40 comes from dividing speed by distance instead of distance by speed, giving a flight time of 1/3 hour (20 minutes) rather than 3 hours. 11:00 comes from adding the 3-hour flight time to the hour of the departure time only, 8 + 3 = 11, and losing the 20 minutes. 03:00 comes from finding the flight time correctly but giving it as a clock time on its own, forgetting to add it to the departure time.
- (b) c = k/6 — k = 6c means c has been multiplied by 6, so to make c the subject, divide both sides by 6: c = k/6. Writing c = 6k multiplies by 6 again instead of undoing the multiplication. Writing c = k − 6 mistakes multiplying for adding, and subtracts 6 rather than dividing. Writing c = 6 − k reverses the order as well as the operation. The correct rearrangement is c = k/6.
- (a) 3.375 — Method: the volume scale factor between similar shapes is the length scale factor cubed, not the length scale factor itself. Working: the length scale factor is 12 ÷ 8 = 1.5, and 1.5³ = 3.375. Answer: 3.375. Jayden's answer, 1.5, is only the LENGTH scale factor — he never cubed it to get the volume scale factor. 2.25 comes from squaring the length scale factor instead of cubing it, which would give the area scale factor. 4.5 comes from multiplying the length scale factor by 3 (the number of dimensions) instead of cubing it.
- (a) 2 — Gradient = (change in y) ÷ (change in x) = (11 − 3) ÷ (6 − 2) = 8 ÷ 4 = 2. "0.5" comes from dividing the change in x by the change in y the wrong way round: 4 ÷ 8. "8" is only the change in y, forgetting to divide by the change in x at all. "−2" comes from a sign error, as if the y-coordinate had decreased rather than increased.
- (a) 0.15 — Let P(water) = x, so P(coffee) = 3x. The four outcomes are exhaustive: 0.36 + 0.04 + x + 3x = 1, so 0.4 + 4x = 1, giving 4x = 0.6 and x = 0.15. So P(water) = 0.15. Reporting 3x, the coffee probability, instead of water gives 0.45. Splitting the remaining 0.6 evenly between coffee and water, ignoring the 3:1 ratio, gives 0.30. Stopping once the remaining probability 0.6 is found, without dividing by the four equal shares, gives 0.60.
- (a) 0.5, 0.55, 0.56, 0.6, 0.601 — Compare the decimals by giving them all the same number of decimal places first: 0.600, 0.550, 0.601, 0.500, 0.560. Ordering these from smallest to largest gives 0.500, 0.550, 0.560, 0.600, 0.601, which is 0.5, 0.55, 0.56, 0.6, 0.601. Comparing the digits as though they were whole numbers, reading 0.601 as "601" and 0.5 as "5", without padding to the same number of decimal places, gives the wrong order 0.5, 0.6, 0.55, 0.56, 0.601, because it ignores the place value of each digit. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 0.601, 0.6, 0.56, 0.55, 0.5. Misreading the close values 0.55 and 0.56 and swapping them gives 0.5, 0.56, 0.55, 0.6, 0.601. So the correct order, smallest to largest, is 0.5, 0.55, 0.56, 0.6, 0.601.
- (c) 5 — Method: gradient = change in y ÷ change in x between the two points. Working: change in y = 9 − 4 = 5, change in x = 1 − 0 = 1, so gradient = 5 ÷ 1 = 5. Answer: the gradient is 5. 13 comes from adding the y-values instead of subtracting them. 4 comes from using the y-value at x = 0 instead of the change in y between the two points. 1/5 comes from inverting the gradient, dividing the change in x by the change in y instead of the other way round.
- (d) 30 cm — Convert 300 m to centimetres: 300 m = 30 000 cm. The scale 1 : 1000 means the map length is the real length divided by 1000: 30 000 ÷ 1000 = 30, giving 30 cm. Dividing the unconverted 300 (metres, not centimetres) by 1000 gives 0.3 cm, far too small to be a real map measurement. Dividing by 10 000 instead of 1 000 gives 3 cm, ten times too small. Multiplying instead of dividing, 300 × 1000 = 300 000, gives 300 000 cm — using the scale the wrong way round, as if the map were bigger than real life.
- (a) 6 left, 2 up — In a column vector $\binom{x}{y}$, the top number gives the horizontal movement (negative means left) and the bottom number gives the vertical movement (positive means up), so $\binom{-6}{2}$ means 6 units left and 2 units up. '6 right, 2 up' ignores the negative sign on the top number. '2 left, 6 up' swaps the top and bottom numbers. '6 left, 2 down' ignores the positive sign on the bottom number.
- (a) 42.5 ≤ t < 47.5 — Rounding to the nearest 5 minutes means the actual time can be up to half of 5 minutes, 2.5 minutes, below or above 45 before it would round to a different multiple of 5. The lower bound is 45 − 2.5 = 42.5 and the upper bound is 45 + 2.5 = 47.5. A time of exactly 47.5 minutes would round up to 50, not 45, so 47.5 is excluded while 42.5 does still round to 45. Writing 42.5 ≤ t ≤ 47.5 wrongly includes 47.5. Writing 40 ≤ t < 50 uses a whole rounding unit, 5, either side instead of half of it. Writing 44.5 ≤ t < 45.5 treats the rounding unit as 1 minute instead of 5 minutes.
- (a) x + 14 — Expand each bracket separately: 3(x + 4) = 3x + 12, and −2(x − 1) = −2x + 2 (multiply −2 by both x and −1). Combine: 3x + 12 − 2x + 2 = x + 14. Writing x + 10 comes from taking −2(x − 1) as −2x − 2, not flipping the sign of the −1 inside the bracket. Writing 5x + 10 comes from treating the second bracket as +2(x − 1) instead of subtracting it, so the x-terms are added rather than subtracted. Writing x + 13 comes from only multiplying the 2 by the x, and carrying the −1 across unmultiplied.
- (b) 80% — Percentage = (40 ÷ 50) × 100 = 80%.
- (a) 4,000 nanometres — Method: the number of nanometres is the diameter divided by the length of one nanometre, and dividing powers of ten means subtracting the indices. Working: −6 − (−9) = 3, so 10⁻⁶ ÷ 10⁻⁹ = 10³, and the diameter is 4 × 10³ nanometres. Answer: 4,000 nanometres. The distractors: 400 nanometres comes from taking the difference between the indices as 2 instead of 3; 4 nanometres comes from changing the name of the unit without converting, leaving the coefficient untouched; 0.004 nanometres comes from dividing by 10³ instead of multiplying by it, as though a nanometre were the larger of the two units.
- (a) 4 — The length scale factor, cubed, gives the volume scale factor: L³ = 64, so L = the cube root of 64 = 4, since 4 × 4 × 4 = 64. 64 comes from using the volume scale factor itself as the length scale factor, without taking a root at all. 8 comes from taking the square root of 64 instead of the cube root — that would be the correct root for an area scale factor, not a volume one. 32 comes from halving the volume scale factor (64 ÷ 2), instead of cube-rooting it.
How the 20 questions are shared out
- Number — 5 questions (25% of the qualification)
- Algebra — 4 questions (20% of the qualification)
- Ratio, proportion and rates of change — 5 questions (25% of the qualification)
- Geometry and measures — 3 questions (15% of the qualification)
- Probability — 2 questions (7.5% of the qualification)
- Statistics — 1 question (7.5% of the qualification)
Where an area has fewer printable questions than its share, the shortfall is filled from the other areas. These are original questions, not past papers.