Sample paper · GCSE Foundation · grades 1–5
GCSE Foundation sample Paper 2 (calculator)
The real Paper 2 is 1.5 hour 30 minutes and 80 marks, calculator, and all three papers carry equal weight. This sample is 20 original questions in the same content proportions as the Foundation qualification — number 25%, algebra 20%, ratio, proportion and rates of change 25%, geometry and measures 15%, probability 7.5%, statistics 7.5% — with a calculator allowed. AO1 / AO2 / AO3 at this tier: 50% / 25% / 25%.
CalculatorGCSE Foundation
Answer key: GCSE Foundation sample Paper 2 (calculator)
MathsUKwww.geekhero.co.uk
- (c) 6 — Method: the first significant figure is the first non-zero digit; round using the digit after it to decide whether to round up or down. Working: the first significant figure of 6.283 is the 6; the next digit is 2, which rounds down, so 6.283 rounds to 6. 6.3 comes from rounding to 2 significant figures instead of 1. 10 comes from rounding up to the nearest 10 instead of finding 1 significant figure of the number itself. 0.6 comes from misplacing the decimal point after rounding. Answer: 6.
- (a) 4n + 1 — Method: find the increase in cost per hour, then find the constant by adjusting the 1-hour cost. Working: the cost goes up by £4 for each extra hour (9 − 5 = 4), so the coefficient of n is 4. The constant is the 1-hour cost minus the common difference: 5 − 4 = 1. Answer: the nth term is 4n + 1. 4n + 5 comes from using the 1-hour cost, 5, as the constant without subtracting the common difference. 4n − 3 comes from a slip in working out the constant, subtracting the common difference twice (5 − 4 − 4 = −3) instead of once. n + 4 comes from swapping the hourly increase and the constant.
- (d) 1:12 — Write the ratio model : real bus using the numbers in the question: 5 : 60. Divide both parts by their highest common factor, 5: 5÷5 = 1, 60÷5 = 12, giving 1 : 12. (12:1 comes from writing the ratio the wrong way round, real bus : model. 1:55 comes from dividing the first part correctly, 5÷5 = 1, but subtracting on the second part, 60 − 5 = 55, instead of dividing it by 5 as well. 5:12 comes from dividing only the real length by 5 and leaving the model length unchanged — both parts of a ratio must be divided by the same number.)
- (c) 36 cm² — The area of a parallelogram is base × height = 9 × 4 = 36 cm². 26 cm² is 2 × (9 + 4), the perimeter you would get by treating the perpendicular height as though it were a side length — and a perimeter is a length, not an area. 18 cm² uses the triangle formula, half of base × height, by mistake. 72 cm² doubles the correct area.
- (b) 8/52 — Method: a card cannot be an ace and a king at the same time, so the two events are mutually exclusive and their probabilities are added, keeping the denominator the same. Working: P(ace) = 4/52 and P(king) = 4/52, so P(ace or king) = 4/52 + 4/52, and 4 + 4 = 8 fifty-seconds. Answer: 8/52. The distractors: 4/52 comes from giving the probability of just one of the two events and forgetting to add the other; 16/52 comes from multiplying the two counts, 4 × 4, instead of adding them; 1/52 comes from giving the probability of one particular named card rather than any of the eight.
- (d) 25 — In order, the nine ages are 14, 18, 20, 23, 25, 29, 31, 36 and 42, and with 9 values the median is the 5th one, which is 25. Choosing 23 takes the 4th value instead of the 5th. Choosing 29 takes the 6th value instead of the 5th. Choosing 26 comes from averaging the 4th and 6th values, 23 + 29 = 52, and 52 ÷ 2 = 26, a method that is only needed when there is an even number of values.
- (a) 2 — Method: systematically try each possible number of 20p coins, starting from one, and check whether the amount left over can be made exactly using whole 10p coins. Working: one 20p coin leaves 40p, made from four 10p coins — valid. Two 20p coins leave 20p, made from two 10p coins — valid. Three 20p coins leave 0p, which needs zero 10p coins — not valid, since at least one 10p coin is required. So there are 2 different ways. Answer: 2. 3 comes from counting the case of three 20p coins and no 10p coins as if it were allowed, even though at least one 10p coin is required. 4 comes from ignoring the 'at least one of each' condition altogether and counting every way of making 60p, including three 20p coins with no 10p coins and six 10p coins with no 20p coins. 1 comes from finding only one of the two valid combinations and stopping the systematic list too early.
- (c) 27 days — The campaign starts at d = 3 and ends at d = 30, so it runs for 30 − 3 = 27 days. Getting 33 days comes from adding the two values, 3 + 30 = 33, instead of subtracting them. Getting 30 days uses only the end day and ignores that the campaign did not start at day 0. Getting 24 days comes from subtracting the start day twice, 30 − 3 − 3 = 24, instead of once.
- (c) £480.00 — To decrease by 20%, multiply by 0.80 (100% − 20%). £600 × 0.80 = £480.00. £120.00 comes from working out only the decrease (£600 × 0.20) and forgetting to subtract it from the original value. £580.00 comes from subtracting 20 directly instead of 20% of £600. £720.00 comes from multiplying by 1.20, adding the percentage instead of subtracting it.
- (d) 6 — The plan view shows every square of the base footprint, whether or not there is a taller stack above it — the base layer alone already covers a 3 by 2 rectangle of cubes, which is 6 squares. The extra cube on top of a corner cube sits directly above a square that is already counted, so it adds no NEW square to the plan — height does not show up in a plan view, only footprint does. "7" comes from wrongly counting the extra cube as an additional square. "5" comes from missing one square of the base rectangle, perhaps forgetting a corner. "3" comes from counting only one row of the base rectangle and forgetting that the base is two rows deep.
- (d) 19/30 — Exactly one means only fiction or only non-fiction, not both: 21 + 17 = 38 out of the 60 readers, which simplifies to 19/30. Including the 14 who read both as well gives 21 + 17 + 14 = 52, so 52/60 = 13/15 — that is at least one, not exactly one. Using only the both-count, 14, as the numerator gives 14/60 = 7/30, the probability of reading both, not exactly one. Using 52, the number who read at least one type, as the denominator instead of the full 60 readers surveyed gives 38/52 = 19/26.
- (a) 2, 3, 4, 5 — Method: work out which whole numbers satisfy both parts of the inequality. Working: n ≥ 2 means n can be 2 or more; n < 6 means n must be less than 6, so 6 itself is not included. The whole numbers that fit both conditions are 2, 3, 4 and 5. Answer: 2, 3, 4, 5. 2, 3, 4, 5, 6 treats < 6 as ≤ 6 and wrongly includes 6. 3, 4, 5 treats ≥ 2 as > 2 and wrongly leaves out 2. 1, 2, 3, 4, 5 wrongly includes 1, which does not satisfy n ≥ 2.
- (c) Yes; x = (y + 5)/2 is right — Sam's method is correct throughout: adding 5 to both sides gives y + 5 = 2x, and dividing both sides by 2 gives x = (y + 5)/2, so Sam is right. The option giving x = (y − 5)/2 assumes 5 should be subtracted again, but 2x − 5 = y means 5 has already been subtracted, so it must be added back, not taken away a second time. The option giving x = y/2 + 5 divides only the y term by 2 and leaves the 5 unhalved, which is not a valid rearrangement. The option agreeing Sam is correct but changing step 2 to x = 2(y + 5) confuses '2x' with 'x divided by 2' — since x is multiplied by 2, the inverse is division, not multiplication. Sam's working, and his final formula x = (y + 5)/2, are both correct.
- (c) 7.6 — Density = mass ÷ volume, so 356.5 ÷ 47 = 7.585..., which rounds to 7.6 g/cm³ (1 d.p.). (0.1 comes from dividing the volume by the mass instead of the mass by the volume, the wrong way round. 7.5 comes from rounding 7.585 down instead of up to 1 decimal place. 403.5 comes from adding the mass and the volume instead of dividing.)
- (b) (7, 3) — Reflecting in the line y = x swaps the x- and y-coordinates: (3, 7) → (7, 3). A pupil who reflects in the x-axis instead gets (3, −7). A pupil who reflects in the y-axis instead gets (−3, 7). A pupil who confuses y = x with y = −x, swapping the coordinates and changing both signs, gets (−7, −3). The correct image is (7, 3).
- (b) 5² — Method: multiplying two powers of the same base adds their indices, and a negative index is added as a negative number. Working: −2 + 4 = 2, so 5⁻² × 5⁴ = 5². Answer: 5². The distractors: 5⁶ comes from adding the sizes of the indices, 2 + 4, and ignoring the minus sign; 5⁻⁸ comes from multiplying the indices, −2 × 4, instead of adding them; 5⁻⁶ comes from subtracting the indices, −2 − 4, as though the powers were being divided.
- (d) 1 — Method: find the step in the outputs for each step of 1 in the input, write the rule from that step and from one pair of values, then apply the rule to the last input. Working: the outputs −5, −3, −1 rise by 2 while x rises in ones, so x is multiplied by 2; at x = 1, 2 × 1 = 2 while y = −5, so 7 is subtracted, giving y = 2x − 7; at x = 4 the rule gives 2 × 4 = 8 and 8 − 7 = 1. Answer: y = 1. The distractors: 3 comes from carrying the outputs on one step too far, to x = 5; 0 comes from assuming the outputs −5, −3, −1 carry on by adding 1 rather than by adding 2; 8 comes from doubling the input and forgetting to subtract the 7.
- (c) 1.6 — The multiplier from tins to pounds is found by dividing the cost by the number of tins: £8 ÷ 5 = 1.6. 0.625 comes from dividing the wrong way round, tins ÷ cost (5 ÷ 8), which is the multiplier from pounds back to tins. 3 comes from subtracting the number of tins from the cost (8 − 5), instead of dividing. 40 comes from multiplying the cost by the number of tins (8 × 5), instead of dividing.
- (b) 245 ≤ m < 255 — Method: a mass given to the nearest 10 g lies within half of 10 g, that is 5 g, of the figure written down. The lower limit is included because it rounds up to that figure, and the upper limit is excluded because it rounds up to the next multiple of 10. Working: 250 − 5 = 245 and 250 + 5 = 255, and a mass of 245 g rounds to 250 g while a mass of 255 g rounds to 260 g. Answer: 245 ≤ m < 255. The distractors: 240 ≤ m < 260 goes a whole 10 g either side instead of half of it; 245 < m ≤ 255 has the two limits the wrong way round; 240 ≤ m < 250 treats the stated 250 g as the largest mass possible, as though rounding were always upwards.
- (b) 15 — Find the multiplier connecting y to x: 10 ÷ 4 = 2.5. Then apply it to the new value of x: 2.5 × 6 = 15. Working out 10 + (6 − 4) = 12 adds the change in x straight onto y instead of scaling proportionally. Working out 10 × 6 = 60 multiplies the given y-value by the new x-value directly, without finding the multiplier first. Writing 10 keeps y the same as before, not realising it must change with x. When x = 6, y = 15.
How the 20 questions are shared out
- Number — 5 questions (25% of the qualification)
- Algebra — 4 questions (20% of the qualification)
- Ratio, proportion and rates of change — 5 questions (25% of the qualification)
- Geometry and measures — 3 questions (15% of the qualification)
- Probability — 2 questions (7.5% of the qualification)
- Statistics — 1 question (7.5% of the qualification)
Where an area has fewer printable questions than its share, the shortfall is filled from the other areas. These are original questions, not past papers.