Sample paper · GCSE Foundation · grades 1–5
GCSE Foundation sample Paper 2 (calculator)
The real Paper 2 is 1.5 hour 30 minutes and 80 marks, calculator, and all three papers carry equal weight. This sample is 20 original questions in the same content proportions as the Foundation qualification — number 25%, algebra 20%, ratio, proportion and rates of change 25%, geometry and measures 15%, probability 7.5%, statistics 7.5% — with a calculator allowed. AO1 / AO2 / AO3 at this tier: 50% / 25% / 25%.
CalculatorGCSE Foundation
Answer key: GCSE Foundation sample Paper 2 (calculator)
MathsUKwww.geekhero.co.uk
- (c) 2/3 — Method: fractions with the same denominator are added by adding the numerators and leaving the denominator alone, because the parts are already the same size. Working: 1/3 + 1/3 has numerators 1 + 1 = 2 and the denominator stays as 3, giving 2/3. Answer: 2/3. The distractors: 2/6 comes from adding the denominators as well as the numerators, 1 + 1 over 3 + 3; 2/9 comes from adding the numerators but multiplying the denominators, 1 + 1 over 3 × 3; 1/9 comes from multiplying throughout instead of adding, 1 × 1 over 3 × 3.
- (b) One turning point. — Every quadratic graph, one with an x² term and no higher power of x, has exactly one turning point, since it is a single U-shaped or n-shaped curve. Saying two turning points describes a cubic graph, which can rise, turn, then turn again. Saying no turning points describes a straight line, which has none. Saying four turning points greatly overestimates how many times a simple quadratic curve changes direction — that would need a much higher power of x.
- (d) y = 3x/4 — y : x = 3 : 4 means y/x = 3/4. Rearranging to make y the subject gives y = (3/4)x = 3x/4. A student who mixes up which quantity goes on top gets y = 4x/3. A student who treats the ratio numbers as the coefficient and constant of a linear equation instead of a proportional relationship gets y = 3x + 4. A student who mistakes the relationship for inverse proportion gets y = 3/(4x).
- (a) 118° — When two straight lines cross, the angles that are vertically opposite each other are always equal. So the angle vertically opposite 118° is also 118°. A candidate who instead finds the angle next to it on the straight line, using 180° − 118° = 62°, has found the adjacent angle, not the vertically opposite one. A candidate who answers 180° has confused the rule with angles on a straight line. A candidate who doubles the angle, giving 236°, has applied no valid angle rule at all. The vertically opposite angle is 118°.
- (a) 5/9 — Method: a bead cannot be two colours at once, so white and purple are mutually exclusive and their probabilities are added over the common total. Working: there are 1 + 4 + 4 = 9 beads, so P(white) = 1/9 and P(purple) = 4/9; adding gives 1/9 + 4/9, and 1 + 4 = 5 ninths. Answer: 5/9. The distractors: 4/9 comes from giving the probability of a purple bead alone and forgetting to include the white one; 5/8 comes from counting 5 favourable beads but using 8 as the total, leaving the single white bead out of the count of the box; 5/18 comes from adding 1/9 and 4/9 by adding the denominators as well as the numerators.
- (a) A vertical line chart (discrete numerical data) — The number of pets is discrete numerical data — whole-number values such as 0, 1, 2, 3 or 4 — recorded for one variable, so a vertical line chart is the chart specified for this kind of data. A bar chart is used for categorical data, such as favourite colour, not numerical values counted like this. A pie chart shows proportions of a whole and does not show the frequency of each separate value. A scatter graph compares two different variables against each other, and only one variable, the number of pets, is recorded here.
- (d) 11 mm — Method: for a square, the side length is the square root of the area. Working: 11 × 11 = 121, so the side length is 11 mm. 60.5 mm comes from working out 121 ÷ 2 = 60.5, halving the area instead of finding its square root. 242 mm comes from working out 121 × 2 = 242, doubling the area instead of finding its square root. 22 mm comes from working out 11 × 2 = 22, doubling the correct side length. Answer: 11 mm.
- (c) t = 1 second and t = 5 seconds — The ball is at ground level when h = 0, which happens when either bracket is zero. t − 1 = 0 gives t = 1, and 5 − t = 0 gives t = 5. The option with t = −1 makes a sign error solving the first bracket. The option with t = −5 makes a sign error solving the second bracket, treating 5 − t = 0 as if it gave a negative solution. The option with t = 4 seconds is an arithmetic slip in solving 5 − t = 0.
- (a) 6 — Method: for inverse proportion the product xy is the same for every pair, so find that product and use it to work back to the missing value. Working: xy = 2 × 15 = 30, so when x = 5 the equation 5y = 30 gives y = 30 ÷ 5 = 6. Answer: 6. The distractors: 37.5 comes from treating the pair as direct proportion and scaling y up with x, 15 × 5 ÷ 2, although in inverse proportion y falls as x rises; 30 is the constant product itself, given as a value of y rather than used to find one; 12 comes from additive thinking — x rises by 3, so 3 is taken off y — which would make the two quantities differ by a constant instead of multiplying to one.
- (a) A smaller circle — Since the cutting plane is parallel to the circular base, the cross-section is also a circle, but smaller than the base because the cone narrows as it rises towards the apex, so 'a smaller circle' is correct. 'A triangle' wrongly describes the outline seen from the side of the cone, not a horizontal cross-section. 'An ellipse' would only result from a cut made at an angle to the base, not one parallel to it. 'The same size circle as the base' wrongly ignores that the cone tapers, so any parallel cross-section above the base must be smaller.
- (b) 0.55 — Method: it is easier to find the probability that Ffion wins NEITHER stage, then subtract that from 1. Working: P(lose stage 1) = 1 − 0.4 = 0.6, and P(lose stage 2) = 1 − 0.25 = 0.75. P(neither) = 0.6 × 0.75 = 0.45. P(at least one) = 1 − 0.45 = 0.55. Answer: 0.55. Watch out: adding the two win probabilities, 0.4 + 0.25 = 0.65, treats winning both as impossible and overcounts — that is not how independent probabilities combine. Multiplying the two win probabilities, 0.4 × 0.25 = 0.1, gives the probability of winning BOTH stages, not at least one. And stopping at 0.45, the probability of winning neither stage, forgets the final step of subtracting from 1.
- (c) 150 m — Method: a fraction acts as an operator, so finding 3/7 of a length means dividing by the denominator and multiplying by the numerator. Working: 350 ÷ 7 = 50, so one seventh of the route is 50 m, and three sevenths is 50 × 3 = 150 m. Answer: 150 m. The distractors: 50 m comes from finding one seventh and stopping there instead of multiplying by 3; 1050 m comes from multiplying by the numerator without dividing by the denominator, giving 350 × 3 = 1050; 200 m comes from working out the stretch of the route the footpath does not run alongside, which is 4/7 of 350 m, instead of the stretch it does.
- (a) −5 — Method: apply the machine's operation to the input, and carry the sign of the input through the multiplication. Working: the machine gives 5 × (−1); a positive number multiplied by a negative number gives a negative result, and 5 × 1 = 5, so the output is 5 below zero. Answer: −5, which is one lot of −1 taken five times. The distractors: 5 comes from working out 5 × 1 and losing the minus sign of the input; 4 comes from adding 5 to −1 instead of multiplying; −6 comes from subtracting 5 from −1 instead of multiplying.
- (c) 90 cm² — The perimeter ratio is 30 : 45, which simplifies to 2 : 3, so the larger frame is 1.5 times the perimeter of the smaller one. Areas scale with the square of this length scale factor: 1.5² = 2.25. 40 × 2.25 = 90, so the larger frame has an area of 90 cm². Giving 60 cm² uses the scale factor, 1.5, without squaring it (40 × 1.5 = 60). Giving 135 cm² cubes the scale factor, 1.5³ = 3.375, as if area scaled like a volume (40 × 3.375 = 135). Giving 2.25 cm² is the squared scale factor on its own, without multiplying by the smaller frame's area of 40 cm².
- (a) Trapezium — A trapezium is defined as a quadrilateral with exactly one pair of parallel sides. A parallelogram has two pairs, and a kite and rhombus are defined by side lengths, not by having only one pair of parallel sides.
- (d) 0.3 — Converting the fractions to decimals, 1/4 = 0.25 and 2/5 = 0.4, so any decimal between 0.25 and 0.4 is a valid answer, and 0.3 fits. Confusing 1/4 with 1/5 and converting it as 0.2 instead of 0.25 gives a value below the true lower bound. Confusing 2/5 with 1/2 and converting it as 0.5 instead of 0.4 gives a value above the true upper bound. Converting the fractions correctly but choosing a decimal above the true upper bound of 0.4 instead of between the two values gives 0.45.
- (c) (2, 5) — Reflecting in the x-axis keeps the x-coordinate the same and changes the sign of the y-coordinate: Q = (2, 5). (−2, −5) comes from reflecting in the y-axis instead, which changes the sign of the x-coordinate. (−2, 5) comes from reflecting in both axes. (2, −5) comes from not applying the reflection at all.
- (a) 24 N/m² — Pressure = force ÷ area. 68.4 ÷ 2.85 = 24 N/m². 194.94 N/m² comes from multiplying the force by the area instead of dividing (68.4 × 2.85). 65.55 N/m² comes from subtracting the area from the force (68.4 − 2.85) instead of dividing. 0.04 N/m² comes from dividing the area by the force instead of the force by the area (2.85 ÷ 68.4).
- (a) 7 — Method: BIDMAS deals with the index first, then the multiplication, then the subtraction. Working: (−2)² = (−2) × (−2) = 4, then 3 × 4 = 12, and finally 12 − 5 = 7. Answer: 7. The distractors: −17 comes from squaring only the 2 and keeping the minus sign, giving 3 × (−4) = −12 and then −12 − 5 = −17; 31 comes from multiplying before applying the index, giving (3 × (−2))² = (−6)² = 36 and then 36 − 5 = 31; −3 comes from carrying out the subtraction before the multiplication, giving 3 × (4 − 5) = 3 × (−1) = −3.
- (b) 1500 — The rate is 3 ÷ 2 = 1.5 litres per minute. Converting to cm³: 1.5 × 1000 = 1500 cm³ per minute. Getting 3000 comes from converting 3 litres to cm³ first (3000 cm³) and forgetting to divide by the 2 minutes. Getting 750 comes from dividing by the 2 minutes a second time after converting (1500 ÷ 2). Getting 2000 comes from converting the 2 minutes as if it were litres (2 × 1000) instead of using the correct rate of 1.5 litres per minute.
How the 20 questions are shared out
- Number — 5 questions (25% of the qualification)
- Algebra — 4 questions (20% of the qualification)
- Ratio, proportion and rates of change — 5 questions (25% of the qualification)
- Geometry and measures — 3 questions (15% of the qualification)
- Probability — 2 questions (7.5% of the qualification)
- Statistics — 1 question (7.5% of the qualification)
Where an area has fewer printable questions than its share, the shortfall is filled from the other areas. These are original questions, not past papers.