⏱️ Ten-minute starters — Foundation

Answer key

1. (c) 6/8 — Method: two fractions can only be compared directly when they share a denominator, so rewrite 3/4 in eighths and then compare the numerators. Working: 5/8 is already in eighths, and 3/4 = (3 × 2)/(4 × 2) = 6/8. Comparing the numerators, 6 > 5, so Oliver eats the larger share. Answer: 6/8. The distractors: 5/8 comes from skipping the conversion altogether and assuming that a bar cut into eighths must give the bigger share because it has more pieces; once both shares are written over the same denominator, 5 eighths is one eighth less than 6 eighths. 1/8 comes from working out how much more Oliver eats, 6/8 − 5/8, instead of writing down the greater of the two shares. 7/8 comes from adding 4 to the numerator and 4 to the denominator of 3/4 instead of multiplying both by 2.
2. (b) 3.65 ≤ n < 3.75 — Rounding to 1 decimal place means n can be up to half of one decimal place, 0.05, below or above 3.7 before it would round to a different value. This gives a lower bound of 3.7 − 0.05 = 3.65 and an upper bound of 3.7 + 0.05 = 3.75. A value exactly at 3.75 would round up to 3.8, not 3.7, so the upper bound is excluded while the lower bound, 3.65, does still round to 3.7. Writing 3.65 ≤ n ≤ 3.75 wrongly includes 3.75. Writing 3.6 ≤ n < 3.8 uses a whole decimal place, 0.1, either side instead of half of one, 0.05. Writing 3.65 < n < 3.75 wrongly excludes 3.65, which does round to 3.7.
3. (c) 6.3 m — By Pythagoras' theorem, the height = √(7² − 3²) = √(49 − 9) = √40 = 6.32...≈ 6.3 m. "6.4 m" rounds 6.32...m up to 6.4 instead of correctly rounding it down to 6.3. "4.0 m" comes from subtracting the two given lengths directly, 7 − 3 = 4, instead of subtracting their squares. "10.0 m" comes from adding the two given lengths, 7 + 3 = 10, instead of using Pythagoras' theorem at all.
4. (c) 5 m — The scale 1 : 100 means 1 cm on the map represents 100 cm in real life. The path is 5 cm on the map, so the real length is 5 × 100 = 500 cm. Convert to metres: 500 cm = 5 m. Dividing instead of multiplying, 5 ÷ 100 = 0.05, gives 0.05 m — the scale must be used to make the real object bigger than the map, not smaller. Leaving the answer as 500 without converting to metres and calling it 500 m mistakes centimetres for metres. Using a scale of 1 : 1000 instead of the given 1 : 100 gives 5 × 1000 = 5000 cm = 50 m, ten times too large.
5. (c) A straight line through the origin, rising from left to right — Two quantities are in direct proportion when one is a constant multiple of the other, so their graph is a straight line through the origin: when one quantity is 0 the other is 0 as well, and doubling one doubles the other. A straight line crossing the vertical axis at 5 has a fixed amount added on, so when the horizontal quantity is 0 the vertical quantity is 5, not 0 — a straight line on its own is not enough for direct proportion. A curve that falls steeply and then levels off without touching either axis shows inverse proportion: one quantity grows as the other shrinks, and their product stays the same. A horizontal line at a height of 3 shows a quantity that does not change at all as the other one grows, so it is not proportional to it.
6. (b) 8 — The gradient of a line through the origin is the y-value divided by the x-value at any point on the line. Using (10, 80): gradient = 80 ÷ 10 = 8.
7. (a) 32 m — The scale factor from the larger pond to the smaller pond is 4 ÷ 11, so the smaller perimeter is 88 × 4 ÷ 11 = 32 m. The distractor 242 m comes from using the ratio the wrong way round, 88 × 11 ÷ 4 = 242. The distractor 84 m comes from subtracting the smaller ratio number, 88 − 4 = 84, instead of scaling. The distractor 121 m comes from multiplying 11 × 11 = 121, ignoring the given perimeter altogether.
8. (c) 22 kg — Method: multiply the mean by the number of parcels to rebuild the total mass, then subtract the masses that are known. Working: four parcels with a mean mass of 17 kg have a total mass of 17 × 4 = 68 kg; the three known parcels total 12 + 16 + 18 = 46 kg; so the fourth parcel has mass 68 − 46 = 22 kg. Answer: 22 kg. The distractors: 68 kg comes from stopping at the total mass of all four parcels; 17 kg comes from assuming the missing parcel must have the mean mass; 5 kg comes from multiplying the mean by 3, the number of parcels whose mass is given, leaving 51 − 46 = 5.
9. (a) 55 − 5n — The number of chairs decreases by 5 in each row after the first, so the common difference is d=−5, and the first term is a=50. The nth term is a+(n−1)d = 50+(n−1)(−5) = 50−5n+5 = 55−5n. A candidate who uses the common difference as the constant term instead of correctly finding 55, giving the constant as −5 instead, would write −5n−5. A candidate who uses the first term, 50, as the coefficient of n instead of the common difference, would write 50n−5. A candidate who does not multiply the common difference by n at all, treating the nth term as n+d instead of dn+c, would write n−5.
10. (d) 120 g — Mass = density × volume, so 0.8 × 150 = 120 g. Working out 150 ÷ 0.8 = 187.5 divides by the density instead of multiplying, the wrong way round for finding a mass. Working out 150 × 8 = 1200 misplaces the decimal point in the density, treating 0.8 g/cm³ as 8 g/cm³. Working out 150 − 0.8 = 149.2 simply subtracts the density from the volume, which does not give a mass. The piece of wood has a mass of 120 g.
11. (c) a formula — A statement that shows how to calculate one quantity from others, using an equals sign, is a formula. P = 2l + 2w tells us how to work out the perimeter, P, from the length and width, so it is a formula. Distractor origins: 'an equation' confuses a formula linking several letters with an equation solved for one unknown value; 'an identity' confuses a formula with a statement that is true for every value of a single variable; 'an expression' forgets that an expression has no equals sign at all.
12. (b) Right angle, equal hypotenuse, one more side — RHS requires a right angle in each triangle, equal hypotenuses, and one further pair of equal sides, so 'right angle, equal hypotenuse, one more side' is correct. 'Right angle, hypotenuse, one more angle' is wrong because it asks for an extra equal angle instead of an extra equal side, which RHS does not check. 'Two sides and the angle between them' describes SAS, not RHS, so it is wrong. 'Right angle and all three sides equal' describes SSS with an extra right-angle condition, asking for more information than RHS actually needs, so it is wrong.