Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.Work out how many factors 36 has.
- 2.A box stands on a table. The box exerts a force of 240 N on the table, and the base of the box has an area of 0.8 m². Work out the pressure the box exerts on the table, in N/m².
- 3.A semicircle has a diameter of 8 cm. Work out the exact area of the semicircle, in terms of π.
- 4.Work out 35% of 180.
- 5.A grain of fine sand has a mass of 0.001 grams. Write this mass in standard form.
- 6.In the number 3.472, work out the value of the digit 7.
- 7.Write down the reciprocal of 0.2
- 8.A machine fills bags of sugar and shows the mass of each bag to the nearest 10 g. A checker rejects any bag whose actual mass is less than 996 g. One bag shows a mass of 1,000 g on the machine. Decide whether this bag could be rejected, and give a reason for your answer.
- 9.A number, n, is equal to 3.7 when rounded to 1 decimal place. Write down the error interval for n.
- 10.A concert hall has 300 seats. 20% of the seats are in the balcony. Work out how many of the seats are in the balcony.
- 11.Hannah works out 3.1 × 19.6 on her calculator and writes down 6.076. Work out an estimate for 3.1 × 19.6, by rounding each number to 1 significant figure.
- 12.Write '3.2 million' as a number in figures.
- 13.Work out 1/2 of 1/4 of 80.
- 14.Work out the value of 6² − 4³.
- 15.Which of these statements about −0.7 and −0.25 is true?
Answer key
- (d) 9 — List all the factors of 36 in pairs that multiply to give 36: 1 × 36, 2 × 18, 3 × 12, 4 × 9, and 6 × 6. This gives the factors 1, 2, 3, 4, 6, 9, 12, 18 and 36 — nine factors in total, with 6 counted only once even though it appears in a pair with itself. Forgetting that 36 is itself a factor of 36 and leaving it off the list gives 8. Counting the number of factor pairs, five of them, rather than the number of individual factors gives 5. Treating the repeated pair 6 × 6 as two separate factors, 6 and 6 again, gives 10 instead of 9. So 36 has 9 factors.
- (a) 300 N/m² — Pressure is force ÷ area, and the unit N/m² says so: newtons divided by square metres. The calculation is 240 ÷ 0.8. Multiplying both numbers by 10 clears the decimal: 2400 ÷ 8 = 300 N/m². 192 N/m² multiplies the force by the area instead of dividing, 30 N/m² divides by 8 and so loses the decimal point, and 3000 N/m² multiplies only the force by 10 when clearing the decimal.
- (b) 8π cm² — A diameter of 8 cm gives a radius of 4 cm. The area of a full circle would be π × r² = π × 4² = 16π cm², and a semicircle is exactly half of this, giving 16π ÷ 2 = 8π cm². Forgetting to halve the area for the semicircle gives 16π cm², the area of the whole circle. Halving the diameter twice, using a radius of 2 instead of 4, gives π × 2² = 4π cm². Using the diameter itself as the radius, so π × 8² = 64π, and then halving that for the semicircle gives 32π cm².
- (b) 63 — 10% of 180 = 18, so 5% = 9. 35% = (3 × 18) + 9 = 54 + 9 = 63. A candidate who uses 25% instead of 35% gets 45. A candidate who doubles 35% to get 70% by mistake gets 126. A candidate who subtracts 35 from 180 instead of finding a percentage gets 145.
- (d) 1 × 10⁻³ — Method: for a number smaller than 1 the index is negative, and it counts the places the decimal point moves to the right to leave a coefficient between 1 and 10. Working: the only significant digit is 1, so the coefficient is 1; the decimal point in 0.001 moves three places to the right to reach that 1, so the index is −3. Answer: 1 × 10⁻³. The distractors: 1 × 10³ comes from taking the index as positive, which describes one thousand grams rather than one thousandth of a gram; 0.1 × 10⁻² is the same mass written with a coefficient of 0.1, which is smaller than 1 and so is not standard form; 1 × 10⁻⁴ comes from counting the zero in front of the decimal point as well as the places after it.
- (c) 0.07 — Each digit after the decimal point has a place value: the first digit is tenths, the second is hundredths, the third is thousandths. In 3.472, the 4 is in the tenths place and the 7 is in the hundredths place, so it is worth 0.07. Reading it as 7 ignores place value altogether, treating it as if it were a whole number. Reading it as 0.7 puts it one place too big, in the tenths place. Reading it as 0.007 puts it one place too small, in the thousandths place. The digit 7 in 3.472 is worth 0.07.
- (c) 5 — 0.2 = 1/5, and turning the fraction upside down gives the reciprocal 5/1 = 5. Writing −0.2 mistakes the reciprocal for the negative of the number. Working out 1 − 0.2 = 0.8 mistakes the reciprocal for subtracting the number from 1. Writing 0.5 is the reciprocal of 2, not of 0.2 — a place-value slip that drops the decimal, since 1 ÷ 0.2 = 5 while 1 ÷ 2 = 0.5.
- (b) Yes — the actual mass could be as low as 995 g — Method: a mass shown to the nearest 10 g lies within half of 10 g, that is 5 g, of the figure on the display, so compare the smallest mass the bag can have with the checker's limit of 996 g. Working: 1,000 − 5 = 995, so the actual mass of the bag can be as low as 995 g, and 995 g is below the 996 g limit, so a bag showing 1,000 g on the machine can still be rejected. Answer: Yes — the actual mass could be as low as 995 g. The distractors: 990 g comes from going a whole 10 g below the display instead of half of it; 999.5 g comes from treating the display as being to the nearest gram, when it is to the nearest 10 g; the claim that the mass is exactly 1,000 g treats a rounded display as an exact measurement.
- (b) 3.65 ≤ n < 3.75 — Rounding to 1 decimal place means n can be up to half of one decimal place, 0.05, below or above 3.7 before it would round to a different value. This gives a lower bound of 3.7 − 0.05 = 3.65 and an upper bound of 3.7 + 0.05 = 3.75. A value exactly at 3.75 would round up to 3.8, not 3.7, so the upper bound is excluded while the lower bound, 3.65, does still round to 3.7. Writing 3.65 ≤ n ≤ 3.75 wrongly includes 3.75. Writing 3.6 ≤ n < 3.8 uses a whole decimal place, 0.1, either side instead of half of one, 0.05. Writing 3.65 < n < 3.75 wrongly excludes 3.65, which does round to 3.7.
- (d) 60 — Method: a percentage acts as an operator, so finding 20% of an amount means multiplying it by 20/100, which cancels to 1/5. Working: 20% = 20/100 = 1/5, and 300 ÷ 5 = 60. Answer: 60 seats. The distractors: 15 comes from reading 20% as one twentieth and working out 300 ÷ 20 = 15; 30 comes from finding 10% of 300 and stopping there instead of doubling it; 6 comes from converting 20% to 0.02 rather than 0.2, giving 0.02 × 300 = 6.
- (d) 60 — Method: round each number to 1 significant figure and multiply; the estimate then shows whether the calculator answer is sensible. Working: 3.1 rounds to 3 and 19.6 rounds to 20, so the estimate is 3 × 20 = 60. Answer: 60. Hannah's 6.076 is about ten times too small, which is what happens when 19.6 is keyed in as 1.96. The distractors: 62 comes from rounding 19.6 only and leaving 3.1 as it stands, giving 3.1 × 20 = 62; 6 comes from trusting the calculator display rather than checking it against an estimate; 600 comes from rounding 19.6 to 200 instead of to 20, a place-value slip, giving 3 × 200 = 600.
- (d) 3,200,000 — 1 million = 1,000,000, so 3.2 million = 3.2 × 1,000,000 = 3,200,000. A candidate who moves the decimal point one place too many gets 32,000,000. A candidate who moves it one place too few gets 320,000. A candidate who writes the .2 as extra thousands instead of hundred-thousands gets 3,002,000.
- (b) 10 — First find 1/4 of 80, which is 20, then find 1/2 of that: 20 ÷ 2 = 10. Adding the two fractions together instead of applying them one after the other, 1/2 + 1/4 = 3/4, and finding 3/4 of 80 gives 60. Finding 1/4 of 80 = 20 correctly but stopping before applying the second fraction leaves 20 as the final answer. Finding 1/2 of 80 = 40 first but forgetting to then find 1/4 of that leaves 40 as the final answer.
- (c) −28 — 6² = 36 and 4³ = 64. Work out 36 − 64 = −28. A candidate who subtracts in the wrong order gets 64 − 36 = 28. A candidate who adds instead of subtracting gets 36 + 64 = 100. A candidate who multiplies the base by the exponent instead of raising the power (6 × 2 − 4 × 3 = 12 − 12) gets 0.
- (b) −0.7 < −0.25 — Method: compare the two negative decimals by their distance from zero on a number line. Working: −0.7 is 0.7 away from zero and −0.25 is 0.25 away from zero, so −0.7 is further from zero in the negative direction, making it the smaller number. Answer: −0.7 < −0.25 is true. "−0.7 > −0.25" comes from comparing 0.7 and 0.25 as if both numbers were positive, ignoring the negative signs. "−0.7 = −0.25" comes from assuming the two numbers are equal because they are both negative decimals. "−0.7 ≥ −0.25" combines the false statement "−0.7 > −0.25" with the false statement "−0.7 = −0.25".
Build your own mix at the worksheet builder.