Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.The mass of a radioactive sample, in grams, n years after it was first weighed is modelled by M = 200 × (1/2)ⁿ. Work out the mass the model gives after 3 years.
- 2.Work out 2 × (−3 + 7)
- 3.A length, L cm, has the error interval 24.5 ≤ L < 25.5. Write down the degree of accuracy to which the length was measured.
- 4.Work out 18 − 4 × 2
- 5.Write these numbers in order, starting with the largest: −0.6, 0.45, −0.15, 0.5, −0.09
- 6.A plumber charges a call-out fee of £45 and then £28 for each hour she works. She is at a house from 09:15 until 12:45. Work out the total charge.
- 7.Which of these is written correctly in standard form?
- 8.Write these decimals in order, starting with the smallest: 0.6, 0.55, 0.601, 0.5, 0.56
- 9.A number, n, is a multiple of both 6 and 9. Work out the smallest possible value of n that is greater than 20.
- 10.The number 36 can be written as 2² × 3², and the number 84 can be written as 2² × 3 × 7. Work out the highest common factor of 36 and 84.
- 11.Round 6.283 to 1 significant figure.
- 12.Work out the value of ∛8.
- 13.Round 24,681 to the nearest 1,000.
- 14.Petrol costs £1.48 per litre. Sam buys 35 litres and pays with three £20 notes. Work out his change.
- 15.Write 45,000 in standard form.
Answer key
- (b) 25 g — Method: substitute the number of years into the model, raise the fraction to that power first, then multiply by the starting mass. Working: with n = 3 the model gives M = 200 × (1/2)³. Since (1/2)³ = 1/8, the mass is 200 ÷ 8 = 25. Answer: 25 g. The distractors: 12.5 g comes from halving four times instead of three, counting the first weighing as a year; 300 g comes from multiplying by 1/2 × 3 = 1.5 instead of raising 1/2 to the power 3; 0.125 g comes from working out (1/2)³ = 0.125 and stopping there, without multiplying by the starting mass.
- (d) 8 — Method: whatever is inside the brackets is worked out first, and the multiplication is carried out afterwards. Working: inside the brackets, −3 + 7 = 4, and then 2 × 4 = 8. Answer: 8. The distractors: 1 comes from ignoring the brackets and multiplying first, giving 2 × (−3) = −6 and then −6 + 7 = 1; −20 comes from reading −3 + 7 as −(3 + 7) = −10, so that 2 × (−10) = −20; 6 comes from working the brackets out correctly and then adding the 2 instead of multiplying by it, giving 2 + 4 = 6.
- (a) to the nearest centimetre — Method: the error interval of a rounded measurement runs from half a unit below the stated value to half a unit above it, so the width of the interval is one whole unit of the accuracy used. Working: the interval runs from 24.5 to 25.5, a width of 25.5 − 24.5 = 1, so the unit of accuracy is 1 cm; the stated value is the midpoint, 25 cm, and 25 correct to the nearest centimetre is exactly what gives 24.5 ≤ L < 25.5. Answer: to the nearest centimetre. To the nearest 0.5 cm comes from reading the half-unit, 0.5, as the accuracy itself instead of doubling it back to the full unit. To 1 decimal place comes from seeing the bounds written with one decimal place and taking that as the accuracy, but the bounds of a value given to 1 decimal place would be only 0.05 either side. To the nearest 10 cm comes from confusing the size of the value, about 25, with the unit it was rounded to; rounding to the nearest 10 cm would give an interval 5 cm either side of the stated value.
- (c) 10 — Method: the multiplication is carried out before the subtraction. Working: 4 × 2 = 8, so the calculation becomes 18 − 8 = 10. Answer: 10. The distractors: 28 comes from working from left to right, giving (18 − 4) × 2 = 14 × 2 = 28; −10 comes from subtracting the 18 from the 8 rather than the 8 from the 18, giving 8 − 18 = −10; 12 comes from reading 4 × 2 as 4 + 2 = 6 and then working out 18 − 6 = 12.
- (c) 0.5, 0.45, −0.09, −0.15, −0.6 — Method: compare the decimals by their position on a number line, remembering that with negative decimals the one closer to zero is larger. Working: 0.5 and 0.45 are positive, so they come first, with 0.5 the larger of the two. Among the negatives, −0.09 is closest to zero, then −0.15, then −0.6 is furthest from zero and so the smallest. Answer: 0.5, 0.45, −0.09, −0.15, −0.6. 0.5, 0.45, −0.15, −0.09, −0.6 swaps −0.09 and −0.15, treating the negative decimal with more digits after the point as closer to zero. −0.6, −0.15, −0.09, 0.45, 0.5 lists the numbers from smallest to largest instead of largest to smallest. 0.5, 0.45, −0.6, −0.15, −0.09 orders the negative decimals by the size of the digit (0.6 > 0.15 > 0.09) as if they were positive, instead of recognising that a bigger negative decimal is further from zero and so smaller.
- (d) £143 — From 09:15 to 12:45 is 3 hours 30 minutes, which is 3.5 hours. The charge for the time is 3.5 × £28 = £98, and the call-out fee is added on once: £98 + £45 = £143. £98 leaves out the call-out fee altogether, £129 charges for 3 hours instead of 3.5 hours, and £255.50 adds the fee to the hourly rate before multiplying, which charges the £45 for every hour.
- (a) 7.5 × 10⁴ — Standard form is A × 10ⁿ, where A is between 1 and 10 (1 ≤ A < 10) and n is an integer — 7.5 × 10⁴ satisfies all of this. 12 × 10³ fails because 12 is not below 10. 0.5 × 10⁴ fails because 0.5 is not at least 1. 6.2 × 4⁵ fails because standard form always uses a power of 10, not a power of 4.
- (a) 0.5, 0.55, 0.56, 0.6, 0.601 — Compare the decimals by giving them all the same number of decimal places first: 0.600, 0.550, 0.601, 0.500, 0.560. Ordering these from smallest to largest gives 0.500, 0.550, 0.560, 0.600, 0.601, which is 0.5, 0.55, 0.56, 0.6, 0.601. Comparing the digits as though they were whole numbers, reading 0.601 as "601" and 0.5 as "5", without padding to the same number of decimal places, gives the wrong order 0.5, 0.6, 0.55, 0.56, 0.601, because it ignores the place value of each digit. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 0.601, 0.6, 0.56, 0.55, 0.5. Misreading the close values 0.55 and 0.56 and swapping them gives 0.5, 0.56, 0.55, 0.6, 0.601. So the correct order, smallest to largest, is 0.5, 0.55, 0.56, 0.6, 0.601.
- (a) 36 — Method: find the lowest common multiple of 6 and 9, then move up the list of common multiples until one is greater than 20. Working: the common multiples of 6 and 9 are 18, 36, 54 …. 18 is not greater than 20, so the next one, 36, is the smallest value of n that is greater than 20. 18 is the lowest common multiple itself, but it fails the 'greater than 20' condition. 54 is the common multiple after 36, one step too far. 27 is a multiple of 9 but not of 6, since 27 ÷ 6 is not a whole number. Answer: 36.
- (a) 12 — Compare the powers of each prime that appears in both factorisations. In 2² × 3² and 2² × 3 × 7, the prime 2 appears with power 2 in both, and the prime 3 appears with power 2 in one and only power 1 in the other — take the lower power, 3¹. Multiplying the shared primes at their lower powers, 2² × 3, gives 12. Using power 1 for both primes instead of comparing the powers properly, 2 × 3, gives 6, which misses that 2 is common at power 2, not power 1. Multiplying the primes at their higher powers and including 7, which only appears in 84, gives 2² × 3² × 7, which comes to 252 — this is the lowest common multiple, not the highest common factor. Only spotting that 3 is a common prime and overlooking that 2 is common as well gives 3. So the highest common factor of 36 and 84 is 12.
- (c) 6 — Method: the first significant figure is the first non-zero digit; round using the digit after it to decide whether to round up or down. Working: the first significant figure of 6.283 is the 6; the next digit is 2, which rounds down, so 6.283 rounds to 6. 6.3 comes from rounding to 2 significant figures instead of 1. 10 comes from rounding up to the nearest 10 instead of finding 1 significant figure of the number itself. 0.6 comes from misplacing the decimal point after rounding. Answer: 6.
- (b) 2 — Method: the cube root of a number is the value that multiplies by itself three times to give that number. Working: 2 × 2 × 2 = 8, so ∛8 = 2. 4 comes from working out 8 ÷ 2 = 4, halving the number instead of finding its cube root. 24 comes from working out 8 × 3 = 24, multiplying by 3 instead of cube-rooting it. 64 is 8², the square of 8, not its cube root. Answer: 2.
- (d) 25,000 — Method: to round to the nearest 1,000, look at the hundreds digit; 5 or more sends the thousands digit up, less than 5 leaves it where it is, and every digit below the thousands becomes zero. Working: 24,681 has 4 in the thousands place and 6 in the hundreds place. As 6 is 5 or more, the 4 thousands go up to 5 thousands and the hundreds, tens and units are replaced by zeros. Answer: 25,000. The distractors: 24,000 comes from cutting the last three digits off instead of rounding, which leaves the thousands digit untouched; 24,700 is 24,681 rounded to the nearest 100, a finer degree of accuracy than the question asks for; 20,000 is 24,681 rounded to the nearest 10,000, a coarser degree of accuracy.
- (c) £8.20 — Method: find the total cost, then subtract from the amount paid. Working: 35 × £1.48 = £51.80. Amount paid = 3 × £20 = £60.00. Change = £60.00 − £51.80 = £8.20. Answer: £8.20. (£58.52 comes from forgetting to multiply the price by the 35 litres and subtracting only £1.48 from £60. £7.50 comes from rounding £1.48 up to £1.50 before multiplying, giving a total of £52.50 instead of £51.80. £9.20 comes from miscarrying in the pence column when subtracting £51.80 from £60.00.)
- (a) 4.5 × 10⁴ — 45,000 = 4.5 × 10,000 = 4.5 × 10⁴, with the coefficient between 1 and 10 as standard form requires. Writing 45 × 10³ keeps the coefficient too large — 45 is not between 1 and 10. Writing 4.5 × 10³ undercounts the places moved, giving only 4,500. Writing 4.5 × 10⁵ overcounts the places moved, giving 450,000.
Build your own mix at the worksheet builder.