Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) 0.3, 32%, 7/20 — Method: convert every number to a decimal so they can be compared on the same scale. Working: 7/20 = 0.35, 0.3 stays as 0.3, and 32% = 0.32. Comparing 0.3, 0.32 and 0.35 in size gives the order 0.3, then 0.32, then 0.35. Answer: 0.3, 32%, 7/20. 7/20, 32%, 0.3 lists the numbers from largest to smallest instead of smallest to largest. 0.3, 7/20, 32% swaps 32% and 7/20, treating the fraction 7/20 as smaller even though 7/20 = 0.35 is bigger than 32% = 0.32. 32%, 0.3, 7/20 comes from moving the digits one place too far when converting the percentage, giving 0.032 instead of 0.32, which makes 32% look far smaller than it really is.
- (a) 8,350 — Rounding to the nearest 100 means the true number can be up to half of 100, which is 50, below the recorded figure before it would round down to a lower hundred. The smallest possible number is therefore 8,400 − 50 = 8,350. Adding 50 instead of subtracting it gives 8,450, which is the upper end of the interval rather than the smallest value, and 8,450 is not itself possible because it would round up to 8,500. Subtracting a whole 100 instead of half of it gives 8,300, going too far below the recorded value. Subtracting 10 instead of half of the rounding unit gives 8,390, treating the rounding unit as 100 but the tolerance as only 10.
- (a) 4,000 nanometres — Method: the number of nanometres is the diameter divided by the length of one nanometre, and dividing powers of ten means subtracting the indices. Working: −6 − (−9) = 3, so 10⁻⁶ ÷ 10⁻⁹ = 10³, and the diameter is 4 × 10³ nanometres. Answer: 4,000 nanometres. The distractors: 400 nanometres comes from taking the difference between the indices as 2 instead of 3; 4 nanometres comes from changing the name of the unit without converting, leaving the coefficient untouched; 0.004 nanometres comes from dividing by 10³ instead of multiplying by it, as though a nanometre were the larger of the two units.
- (c) £0.45 — Method: find the total cost, then subtract from £20. Working: 4 × £3.20 = £12.80. £12.80 + £6.75 = £19.55. Change = £20.00 − £19.55 = £0.45. Answer: £0.45. (£7.20 comes from forgetting to include the compost and subtracting only the plants' cost from £20. £1.45 comes from dropping the carry when adding the pence: 80p + 75p = £1.55, but only the 55p is written down, giving £18.55 instead of £19.55. £10.05 comes from buying only one plant instead of four, using £3.20 + £6.75.)
- (b) 30 — Method: 12% of an amount is 12/100 of it, so find 1% by dividing by 100 and then multiply by 12. Working: 1% of 250 is 250 ÷ 100 = 2.5, and 12% is 2.5 × 12 = 30. Answer: 30 seats. The distractors: 3 comes from writing 12% as 0.012 instead of 0.12, giving 0.012 × 250 = 3; 25 comes from finding 10% of the seats and stopping there; 24 comes from counting 12 seats for each whole hundred, 12 + 12 = 24, and ignoring the remaining 50 seats.
- (b) £45.90 — The cost is 18 × £3.45 = £62.10. Profit = £108 − £62.10 = £45.90. A candidate who does not borrow in the tenths column, doing 1 − 0 = 1 instead of borrowing to make 10 − 1 = 9 and so leaving the units as 8 − 2 = 6, gets £46.10. A candidate who adds the cost to the selling price instead of subtracting gets £108 + £62.10 = £170.10. A candidate who gives the cost instead of the profit gets £62.10.
- (b) 245 ≤ m < 255 — Method: a mass given to the nearest 10 g lies within half of 10 g, that is 5 g, of the figure written down. The lower limit is included because it rounds up to that figure, and the upper limit is excluded because it rounds up to the next multiple of 10. Working: 250 − 5 = 245 and 250 + 5 = 255, and a mass of 245 g rounds to 250 g while a mass of 255 g rounds to 260 g. Answer: 245 ≤ m < 255. The distractors: 240 ≤ m < 260 goes a whole 10 g either side instead of half of it; 245 < m ≤ 255 has the two limits the wrong way round; 240 ≤ m < 250 treats the stated 250 g as the largest mass possible, as though rounding were always upwards.
- (b) 90 km/h — To convert metres per second to kilometres per hour, multiply by 3.6 (there are 3600 seconds in an hour and 1000 metres in a kilometre, and 3600 ÷ 1000 = 3.6): 25 × 3.6 = 90 km/h. Dividing by 3.6 instead of multiplying gives 25 ÷ 3.6 = 6.9 km/h (to 1 d.p.). Multiplying by 60 instead of 3.6, confusing the conversion from seconds to minutes with the conversion to hours, gives 25 × 60 = 1500 km/h. Multiplying by 3600 to convert seconds to hours but forgetting to convert metres to kilometres gives 25 × 3600 = 90000, which is a speed in metres per hour, not kilometres per hour.
- (a) 28.8 km/h — A compound unit is converted one part at a time. There are 3600 seconds in an hour, so in one hour the cyclist travels 8 × 3600 = 28 800 metres. There are 1000 metres in a kilometre, so 28 800 m = 28 800 ÷ 1000 = 28.8 km/h. 28 800 km/h leaves the distance in metres, 0.48 km/h converts the seconds to minutes rather than to hours, and 2.22 km/h divides by 3.6 instead of multiplying.
- (c) 20p — Turn each price into the same rate before comparing. The small bag is 400 g = 0.4 kg, so it costs £1.12 ÷ 0.4 = £2.80 per kg. The large bag costs £3.90 ÷ 1.5 = £2.60 per kg. The saving is £2.80 − £2.60 = £0.20, which is 20p per kg. 2p compares the prices per 100 g rather than per kilogram, £2.78 subtracts one bag price from the other without turning either into a rate, and £2.60 is the large bag's price per kilogram rather than the saving.
- (a) 8 litres per minute — Method: write the time as a decimal number of minutes, then divide the volume by the time. Working: 30 seconds = 30/60 minute = 0.5 minute, so 2 minutes 30 seconds = 2.5 minutes. Rate = 20 ÷ 2.5 = 8 litres per minute. Answer: 8 litres per minute. (10 litres per minute comes from ignoring the extra 30 seconds and dividing by 2 minutes only. 8.7 litres per minute comes from misreading 2 minutes 30 seconds as 2.3 minutes instead of 2.5 minutes. 0.125 litres per minute comes from dividing the time by the volume instead of the volume by the time.)
- (a) 0.5, 0.55, 0.56, 0.6, 0.601 — Compare the decimals by giving them all the same number of decimal places first: 0.600, 0.550, 0.601, 0.500, 0.560. Ordering these from smallest to largest gives 0.500, 0.550, 0.560, 0.600, 0.601, which is 0.5, 0.55, 0.56, 0.6, 0.601. Comparing the digits as though they were whole numbers, reading 0.601 as "601" and 0.5 as "5", without padding to the same number of decimal places, gives the wrong order 0.5, 0.6, 0.55, 0.56, 0.601, because it ignores the place value of each digit. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 0.601, 0.6, 0.56, 0.55, 0.5. Misreading the close values 0.55 and 0.56 and swapping them gives 0.5, 0.56, 0.55, 0.6, 0.601. So the correct order, smallest to largest, is 0.5, 0.55, 0.56, 0.6, 0.601.
- (d) −1.4, −6/5, 0, 5/4, 1.3 — Method: convert the fractions 5/4 and −6/5 to decimals so every number is written the same way, then compare all five decimals. Working: 5/4 = 1.25 and −6/5 = −1.2. Comparing −1.4, −1.2, 0, 1.25 and 1.3 in size gives the order −1.4, −1.2, 0, 1.25, 1.3. Answer: −1.4, −6/5, 0, 5/4, 1.3. −6/5, −1.4, 0, 5/4, 1.3 swaps the two negative numbers, treating −6/5 as more negative than −1.4 even though −1.2 is closer to zero than −1.4. 1.3, 5/4, 0, −6/5, −1.4 lists the numbers from largest to smallest instead of smallest to largest. −1.4, −6/5, 0, 1.3, 5/4 swaps 5/4 and 1.3, comparing the numerator 5 directly with 1.3 instead of converting 5/4 to the decimal 1.25 first.
- (b) 3.65 ≤ n < 3.75 — Rounding to 1 decimal place means n can be up to half of one decimal place, 0.05, below or above 3.7 before it would round to a different value. This gives a lower bound of 3.7 − 0.05 = 3.65 and an upper bound of 3.7 + 0.05 = 3.75. A value exactly at 3.75 would round up to 3.8, not 3.7, so the upper bound is excluded while the lower bound, 3.65, does still round to 3.7. Writing 3.65 ≤ n ≤ 3.75 wrongly includes 3.75. Writing 3.6 ≤ n < 3.8 uses a whole decimal place, 0.1, either side instead of half of one, 0.05. Writing 3.65 < n < 3.75 wrongly excludes 3.65, which does round to 3.7.
- (b) 1.45 ≤ m < 1.55 — The flour's mass is labelled 1.5 kg, correct to the nearest 0.1 kg, so half of 0.1 kg is added to and subtracted from 1.5 kg to find the interval: 1.5 − 0.05 = 1.45 and 1.5 + 0.05 = 1.55, giving 1.45 ≤ m < 1.55. '1.4 ≤ m < 1.6' comes from taking the whole 0.1 kg as the margin either side, instead of half of it. '1.45 < m ≤ 1.55' comes from writing the inequality signs the wrong way round — the lower bound should be included and the upper bound excluded, not the other way round. '1.45 ≤ m ≤ 1.55' comes from including the upper bound, when the convention is that the upper bound is never actually reached.
Build your own mix at the worksheet builder.