Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) 90 km/h — To convert metres per second to kilometres per hour, multiply by 3.6 (there are 3600 seconds in an hour and 1000 metres in a kilometre, and 3600 ÷ 1000 = 3.6): 25 × 3.6 = 90 km/h. Dividing by 3.6 instead of multiplying gives 25 ÷ 3.6 = 6.9 km/h (to 1 d.p.). Multiplying by 60 instead of 3.6, confusing the conversion from seconds to minutes with the conversion to hours, gives 25 × 60 = 1500 km/h. Multiplying by 3600 to convert seconds to hours but forgetting to convert metres to kilometres gives 25 × 3600 = 90000, which is a speed in metres per hour, not kilometres per hour.
- (d) 6,000,000 — Method: round each number to 1 significant figure, then subtract. Working: 8,340,000 rounds to 8,000,000 (1 s.f.); 1,950,000 rounds to 2,000,000 (1 s.f.); 8,000,000 − 2,000,000 = 6,000,000. Answer: 6,000,000. 6,390,000 is the exact difference, found without rounding the numbers first. 8,000,000 comes from rounding the population correctly but forgetting to subtract the capital's population at all. 6,300,000 comes from rounding 8,340,000 to the nearest hundred thousand, 8,300,000, instead of to 1 significant figure, then subtracting the correctly rounded 2,000,000.
- (b) £96.90 — Method: multiply the number of units by the cost per unit, then convert the result from pence to pounds. Working: 340 × 28.5p = 9690p; converting to pounds, 9690p ÷ 100 = £96.90. Answer: £96.90. £969.00 comes from misplacing the decimal point when converting pence to pounds, dividing by 10 instead of 100. £9.69 comes from misplacing the decimal point the other way, dividing by 1000 instead of 100. £102.00 comes from rounding the rate to 30p per unit before multiplying.
- (a) 8.35 ≤ L < 8.45 — Method: a length rounded to 1 decimal place lies within half of 0.1 cm, that is 0.05 cm, of the value written down. The lower limit is included because it rounds up to that value, and the upper limit is excluded because it rounds up to the next value instead. Working: 8.4 − 0.05 = 8.35 and 8.4 + 0.05 = 8.45, so a length of 8.35 cm still rounds to 8.4 cm while a length of 8.45 cm rounds to 8.5 cm. Answer: 8.35 ≤ L < 8.45. The distractors: 8.3 ≤ L < 8.5 goes a whole 0.1 cm either side instead of half of it; 8.35 < L ≤ 8.45 has the two limits the wrong way round, excluding the length that does round to 8.4 cm and including the one that does not; 8.4 ≤ L < 8.5 is the interval for a length truncated to 1 decimal place, not one rounded to it.
- (a) 11:20 — Method: find the flight time using time = distance ÷ speed, then add this to the departure time. Working: 2340 ÷ 780 = 3 hours; 08:20 + 3 hours = 11:20. Answer: 11:20. 08:40 comes from dividing speed by distance instead of distance by speed, giving a flight time of 1/3 hour (20 minutes) rather than 3 hours. 11:00 comes from adding the 3-hour flight time to the hour of the departure time only, 8 + 3 = 11, and losing the 20 minutes. 03:00 comes from finding the flight time correctly but giving it as a clock time on its own, forgetting to add it to the departure time.
- (a) 7.5 × 10⁴ — Standard form is A × 10ⁿ, where A is between 1 and 10 (1 ≤ A < 10) and n is an integer — 7.5 × 10⁴ satisfies all of this. 12 × 10³ fails because 12 is not below 10. 0.5 × 10⁴ fails because 0.5 is not at least 1. 6.2 × 4⁵ fails because standard form always uses a power of 10, not a power of 4.
- (c) 4 × 10⁴ — 8 ÷ 2 = 4, and 6 − 2 = 4, so each project receives 4 × 10⁴ pounds. Multiplying the exponents instead of subtracting them gives 6 × 2 = 12, so 4 × 10¹². Adding the exponents instead of subtracting them gives 6 + 2 = 8, so 4 × 10⁸. Subtracting the coefficients instead of dividing them gives 8 − 2 = 6, so 6 × 10⁴.
- (c) £8.20 — Method: find the total cost, then subtract from the amount paid. Working: 35 × £1.48 = £51.80. Amount paid = 3 × £20 = £60.00. Change = £60.00 − £51.80 = £8.20. Answer: £8.20. (£58.52 comes from forgetting to multiply the price by the 35 litres and subtracting only £1.48 from £60. £7.50 comes from rounding £1.48 up to £1.50 before multiplying, giving a total of £52.50 instead of £51.80. £9.20 comes from miscarrying in the pence column when subtracting £51.80 from £60.00.)
- (a) 42.5 ≤ t < 47.5 — Rounding to the nearest 5 minutes means the actual time can be up to half of 5 minutes, 2.5 minutes, below or above 45 before it would round to a different multiple of 5. The lower bound is 45 − 2.5 = 42.5 and the upper bound is 45 + 2.5 = 47.5. A time of exactly 47.5 minutes would round up to 50, not 45, so 47.5 is excluded while 42.5 does still round to 45. Writing 42.5 ≤ t ≤ 47.5 wrongly includes 47.5. Writing 40 ≤ t < 50 uses a whole rounding unit, 5, either side instead of half of it. Writing 44.5 ≤ t < 45.5 treats the rounding unit as 1 minute instead of 5 minutes.
- (c) £4.05 — The total cost is 7 × 85p = £5.95. Josh's change is £10.00 − £5.95 = £4.05. Taking off the pounds and then only the 5p digit, £10.00 − £5.00 = £5.00 followed by £5.00 − £0.05, ignoring the 90p altogether, gives £4.95. Rounding the cost up to £6.00 and never accounting for the extra 5p at all gives £4.00. Multiplying 7 × 85 incorrectly as 605 (a slip in 7 × 5) gives a total cost of £6.05, and correctly subtracting that from £10.00 gives £3.95.
- (a) 300 N/m² — Pressure is force ÷ area, and the unit N/m² says so: newtons divided by square metres. The calculation is 240 ÷ 0.8. Multiplying both numbers by 10 clears the decimal: 2400 ÷ 8 = 300 N/m². 192 N/m² multiplies the force by the area instead of dividing, 30 N/m² divides by 8 and so loses the decimal point, and 3000 N/m² multiplies only the force by 10 when clearing the decimal.
- (c) Sam is correct — The leading zeros in 0.070268 are not significant, so the first three significant figures are 7, 0 and 2. The next digit along is 6, and since 6 is 5 or more, the third significant figure rounds up from 2 to 3, giving 0.0703. This means Sam's answer is correct. Writing 0.070 keeps only 2 significant figures, one short of what was asked. Writing 0.0702 ignores the digit 6 that follows and leaves the third figure unrounded. Writing 0.0704 rounds the third figure up twice, as if a later digit had also pushed it up.
- (a) The tape can only give the length to the nearest centimetre — Method: a measurement should never be written to a finer degree of accuracy than the instrument used can read. Working: the tape is marked in centimetres, so the smallest division Leah can read is 1 cm, which is 0.01 m and two decimal places in metres; writing 7.3157 m claims the length to the nearest tenth of a millimetre, four decimal places, which the markings cannot support. A record of 7.32 m, to the nearest centimetre, is what this tape justifies. Answer: The tape can only give the length to the nearest centimetre. The distractors: the nearest millimetre contradicts the markings described in the question, which are centimetres, and would still claim more accuracy than the tape offers; the rule that a length in metres must be written to 2 decimal places borrows the habit of writing money to the penny, when the accuracy of a length depends on the instrument; rounding to the nearest metre would throw away accuracy the tape genuinely provides.
- (c) 3 × 10⁶ — Daily revenue = (4 × 10³) × 2.5 = 1 × 10⁴ (£10,000). Multiplying by the number of days, (3 × 10²), gives annual revenue = (1 × 10⁴) × (3 × 10²) = 3 × 10⁶ (£3,000,000). A candidate who forgot to multiply by the price and just multiplied the number of items by the number of days worked out (4 × 10³) × (3 × 10²) = 1.2 × 10⁶. A candidate who added the number of days to the daily revenue instead of multiplying worked out 1 × 10⁴ + 3 × 10² = 1.03 × 10⁴. A candidate who misread £2.50 as £25 worked out a daily revenue of (4 × 10³) × 25 = 1 × 10⁵, giving an annual total of (1 × 10⁵) × (3 × 10²) = 3 × 10⁷.
- (d) −1.4, −6/5, 0, 5/4, 1.3 — Method: convert the fractions 5/4 and −6/5 to decimals so every number is written the same way, then compare all five decimals. Working: 5/4 = 1.25 and −6/5 = −1.2. Comparing −1.4, −1.2, 0, 1.25 and 1.3 in size gives the order −1.4, −1.2, 0, 1.25, 1.3. Answer: −1.4, −6/5, 0, 5/4, 1.3. −6/5, −1.4, 0, 5/4, 1.3 swaps the two negative numbers, treating −6/5 as more negative than −1.4 even though −1.2 is closer to zero than −1.4. 1.3, 5/4, 0, −6/5, −1.4 lists the numbers from largest to smallest instead of smallest to largest. −1.4, −6/5, 0, 1.3, 5/4 swaps 5/4 and 1.3, comparing the numerator 5 directly with 1.3 instead of converting 5/4 to the decimal 1.25 first.
Build your own mix at the worksheet builder.