Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 62.35 ≤ r < 62.45 — Method: with a value rounded to 1 decimal place, the error interval reaches half of 0.1 either side. Working: half of 0.1 is 0.05, so the interval runs from 62.4 − 0.05 to 62.4 + 0.05. Answer: 62.35 ≤ r < 62.45. (62 ≤ r < 63 comes from rounding to the nearest whole number instead of 1 decimal place. 62.35 ≤ r ≤ 62.45 comes from including the upper bound with ≤ instead of excluding it with <. 62.3 ≤ r < 62.5 comes from using 0.1 either side instead of half of it.)
- (c) 7 × 10⁻⁸ — '100 times smaller' means dividing by 100 = 10². Dividing 7 × 10⁻⁶ by 10² means subtracting 2 from the exponent: −6 − 2 = −8, giving 7 × 10⁻⁸. A candidate who multiplied by 100 instead of dividing added 2 to the exponent, getting 7 × 10⁻⁴. A candidate who divided by 10 instead of 100 subtracted only 1 from the exponent, getting 7 × 10⁻⁵. A candidate who did not apply the scale factor at all left the diameter as 7 × 10⁻⁶, the same as the red blood cell.
- (c) 22 — Without restriction there are 6 × 4 = 24 combinations. Two specific combinations are not available, so subtract 2: 24 − 2 = 22. 24 comes from ignoring the restriction completely. 23 comes from subtracting only 1 of the 2 excluded combinations. 18 comes from removing the whole sport trim level, 6 × 3 = 18, instead of removing just the two excluded combinations.
- (d) −1.4, −6/5, 0, 5/4, 1.3 — Method: convert the fractions 5/4 and −6/5 to decimals so every number is written the same way, then compare all five decimals. Working: 5/4 = 1.25 and −6/5 = −1.2. Comparing −1.4, −1.2, 0, 1.25 and 1.3 in size gives the order −1.4, −1.2, 0, 1.25, 1.3. Answer: −1.4, −6/5, 0, 5/4, 1.3. −6/5, −1.4, 0, 5/4, 1.3 swaps the two negative numbers, treating −6/5 as more negative than −1.4 even though −1.2 is closer to zero than −1.4. 1.3, 5/4, 0, −6/5, −1.4 lists the numbers from largest to smallest instead of smallest to largest. −1.4, −6/5, 0, 1.3, 5/4 swaps 5/4 and 1.3, comparing the numerator 5 directly with 1.3 instead of converting 5/4 to the decimal 1.25 first.
- (c) 65 cm — Method: the upper bound is half the rounding unit above the given value. Working: half of 10 cm is 5 cm, so the upper bound is 60 + 5 = 65 cm. Answer: 65 cm. (70 cm comes from adding the whole rounding unit, 10, instead of half of it. 60 cm comes from giving the rounded value itself rather than the upper bound. 55 cm comes from subtracting the half unit instead of adding it, giving the lower bound.)
- (d) 64 — Method: each time the power increases by 1, the value doubles, since one more 2 is multiplied in. Working: 2⁶ = 2⁵ × 2 = 32 × 2 = 64. Answer: 64. (37 comes from adding the power to the value, 32 + 5, instead of multiplying by the base. 192 comes from multiplying 32 by the new power, 6, instead of by the base, 2. 34 comes from adding the base to the value, 32 + 2, instead of multiplying.)
- (d) 1.2 × 10⁵ — 4 × 3 = 12, and 3 + 1 = 4, giving 12 × 10⁴ — but 12 is not between 1 and 10, so this must be rewritten as 1.2 × 10⁵. Stopping at 12 × 10⁴ without rewriting it leaves the coefficient out of range. Rewriting 12 as 1.2 but leaving the exponent at 4 instead of increasing it to 5 gives 1.2 × 10⁴, which is ten times too small. Adding the coefficients instead of multiplying them gives 4 + 3 = 7, so 7 × 10⁴.
- (c) 0.0065 — Leading zeros are never significant, so counting from the first non-zero digit, the first two significant figures of 0.006482 are 6 and 4. Look at the next digit along, 8, to decide whether the second figure rounds up: since 8 is 5 or more, the 4 rounds up to 5, giving 0.0065. Rounding to 2 decimal places instead of 2 significant figures gives 0.01, which answers a different question. Wrongly counting one of the leading zeros as a significant figure and stopping one figure short gives 0.006. Keeping an extra digit, as in 0.00648, gives 3 significant figures rather than 2.
- (c) 4 × 10⁴ — 8 ÷ 2 = 4, and 6 − 2 = 4, so each project receives 4 × 10⁴ pounds. Multiplying the exponents instead of subtracting them gives 6 × 2 = 12, so 4 × 10¹². Adding the exponents instead of subtracting them gives 6 + 2 = 8, so 4 × 10⁸. Subtracting the coefficients instead of dividing them gives 8 − 2 = 6, so 6 × 10⁴.
- (d) £4.80 — Method: find the error interval, then check which value falls outside it. Working: half of 20p is 10p, so the actual cost, c, satisfies £4.50 ≤ c < £4.70. £4.80 is above £4.70, so it could not be the actual cost. Answer: £4.80. (£4.50 is a genuine possible cost — it sits at the included lower boundary. £4.65 is a genuine possible cost, below the £4.70 upper boundary. £4.55 is a genuine possible cost, well inside the interval.)
- (b) 90 km/h — To convert metres per second to kilometres per hour, multiply by 3.6 (there are 3600 seconds in an hour and 1000 metres in a kilometre, and 3600 ÷ 1000 = 3.6): 25 × 3.6 = 90 km/h. Dividing by 3.6 instead of multiplying gives 25 ÷ 3.6 = 6.9 km/h (to 1 d.p.). Multiplying by 60 instead of 3.6, confusing the conversion from seconds to minutes with the conversion to hours, gives 25 × 60 = 1500 km/h. Multiplying by 3600 to convert seconds to hours but forgetting to convert metres to kilometres gives 25 × 3600 = 90000, which is a speed in metres per hour, not kilometres per hour.
- (a) 300 N/m² — Pressure is force ÷ area, and the unit N/m² says so: newtons divided by square metres. The calculation is 240 ÷ 0.8. Multiplying both numbers by 10 clears the decimal: 2400 ÷ 8 = 300 N/m². 192 N/m² multiplies the force by the area instead of dividing, 30 N/m² divides by 8 and so loses the decimal point, and 3000 N/m² multiplies only the force by 10 when clearing the decimal.
- (d) 10 — Method: list the pairs systematically, taking each sweet in turn and pairing it only with the sweets that come after it, so that no pair is written down twice. Working: numbering the sweets 1 to 5, the first sweet pairs with 4 others, the second pairs with 3 sweets that come after it, the third with 2 and the fourth with 1, so the total is 4 + 3 + 2 + 1 = 10. Answer: 10. The distractors: 20 comes from working out 5 × 4 and never halving, which counts each pair twice, once in each order; 25 comes from working out 5 × 5, which allows the same sweet to be chosen twice; 9 comes from adding the 5 choices and the 4 remaining choices instead of combining them as a selection of two.
- (b) 18.5 ≤ T < 18.7 — Method: the error interval reaches half the rounding unit either side of the recorded value. Working: half of 0.2 is 0.1, so the interval runs from 18.6 − 0.1 to 18.6 + 0.1. Answer: 18.5 ≤ T < 18.7. (18.4 ≤ T < 18.8 comes from using the full rounding unit, 0.2, either side instead of half of it. 18.5 ≤ T ≤ 18.7 comes from including the upper bound with ≤ instead of excluding it with <. 18.6 ≤ T < 18.8 comes from treating the recorded value as the start of the interval and adding the whole rounding unit, 0.2, above it.)
- (d) 6 × 10⁷ — 3 × 2 = 6, and 2 + 5 = 7, so (3 × 10²) × (2 × 10⁵) = 6 × 10⁷. Multiplying the exponents instead of adding them gives 2 × 5 = 10, so 6 × 10¹⁰. Adding the coefficients instead of multiplying them gives 3 + 2 = 5, so 5 × 10⁷. Subtracting the exponents instead of adding them gives 5 − 2 = 3, so 6 × 10³.
Build your own mix at the worksheet builder.