Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 150 — Since 90 students represent 3 of the 5 equal parts, one part is 90 ÷ 3 = 30, and the whole year group is five parts: 30 × 5 = 150. Applying the fraction forwards to 90 instead of reversing it, 90 × 3/5 = 54, treats the given number as the whole rather than as three fifths of it. Finding one part correctly as 30 but forgetting to scale up to the whole year group leaves 30 as the final answer. Treating 90 as the whole year group and adding on 2/5 of 90 for the students who do not walk, 90 + (90 × 2/5) = 126, applies the missing fraction to the wrong base amount.
- (c) 2.5 × 10⁶ — Divide the A values: 5 ÷ 2 = 2.5. Subtract the powers of 10: 4 − (−2) = 4 + 2 = 6. So the answer is 2.5 × 10⁶. A candidate who worked out 4 − 2 = 2, treating the subtraction of a negative as an ordinary subtraction, wrote 2.5 × 10². A candidate who subtracted in the wrong order, −2 − 4 = −6, wrote 2.5 × 10⁻⁶. A candidate who multiplied the A values instead of dividing, 5 × 2 = 10, and added the powers, 4 + (−2) = 2, then rewrote 10 × 10² in standard form as 1 × 10³.
- (c) 7 × 10⁻⁸ — '100 times smaller' means dividing by 100 = 10². Dividing 7 × 10⁻⁶ by 10² means subtracting 2 from the exponent: −6 − 2 = −8, giving 7 × 10⁻⁸. A candidate who multiplied by 100 instead of dividing added 2 to the exponent, getting 7 × 10⁻⁴. A candidate who divided by 10 instead of 100 subtracted only 1 from the exponent, getting 7 × 10⁻⁵. A candidate who did not apply the scale factor at all left the diameter as 7 × 10⁻⁶, the same as the red blood cell.
- (a) 1,500 ≤ m < 2,500 — Method: a four-digit figure written to 1 significant figure has been rounded to the nearest 1,000, so the mass lies within half of 1,000, that is 500, of the figure given. Working: 2,000 − 500 = 1,500 and 2,000 + 500 = 2,500. The lower limit is included, because 1,500 kg rounds up to 2,000 kg to 1 significant figure, while 2,500 kg rounds up to 3,000 kg, so the upper limit is not. Answer: 1,500 ≤ m < 2,500. The distractors: 1,950 ≤ m < 2,050 comes from rounding to the nearest 100 instead of to 1 significant figure; 1,000 ≤ m < 3,000 goes a whole 1,000 either side instead of half of it; 1,500 < m ≤ 2,500 has the two limits the wrong way round.
- (b) £13.48 — Method: an amount of money is written to the nearest penny, which is 2 decimal places, so the calculator display has to be rounded to 2 decimal places. Working: 53.90 ÷ 4 = 13.475, and the digit in the third decimal place is 5, so the penny digit goes up from 7 to 8. Answer: £13.48. The distractors: £13.47 comes from chopping the third decimal place off instead of rounding with it; £13.50 comes from rounding to the nearest 10p rather than to the nearest penny; £13.40 comes from cutting the display short at 1 decimal place, which is both the wrong degree of accuracy and a truncation rather than a rounding.
- (a) 200 g — One quarter of 160 g is 40 g. Increasing the amount means adding this on: 160 + 40 = 200 g. Finding the increase, 1/4 of 160 = 40 g, but stopping there without adding it to the original amount leaves just 40 g. Using 4/5 instead of 5/4 as the scaling fraction, 160 × 4/5 = 128 g, actually decreases the amount rather than increasing it. Increasing by a half instead of a quarter, 160 + 80 = 240 g, uses the wrong fraction of 160.
- (b) 18.5 ≤ T < 18.7 — Method: the error interval reaches half the rounding unit either side of the recorded value. Working: half of 0.2 is 0.1, so the interval runs from 18.6 − 0.1 to 18.6 + 0.1. Answer: 18.5 ≤ T < 18.7. (18.4 ≤ T < 18.8 comes from using the full rounding unit, 0.2, either side instead of half of it. 18.5 ≤ T ≤ 18.7 comes from including the upper bound with ≤ instead of excluding it with <. 18.6 ≤ T < 18.8 comes from treating the recorded value as the start of the interval and adding the whole rounding unit, 0.2, above it.)
- (c) 4 × 10⁴ — 8 ÷ 2 = 4, and 6 − 2 = 4, so each project receives 4 × 10⁴ pounds. Multiplying the exponents instead of subtracting them gives 6 × 2 = 12, so 4 × 10¹². Adding the exponents instead of subtracting them gives 6 + 2 = 8, so 4 × 10⁸. Subtracting the coefficients instead of dividing them gives 8 − 2 = 6, so 6 × 10⁴.
- (a) 0.5, 0.55, 0.56, 0.6, 0.601 — Compare the decimals by giving them all the same number of decimal places first: 0.600, 0.550, 0.601, 0.500, 0.560. Ordering these from smallest to largest gives 0.500, 0.550, 0.560, 0.600, 0.601, which is 0.5, 0.55, 0.56, 0.6, 0.601. Comparing the digits as though they were whole numbers, reading 0.601 as "601" and 0.5 as "5", without padding to the same number of decimal places, gives the wrong order 0.5, 0.6, 0.55, 0.56, 0.601, because it ignores the place value of each digit. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 0.601, 0.6, 0.56, 0.55, 0.5. Misreading the close values 0.55 and 0.56 and swapping them gives 0.5, 0.56, 0.55, 0.6, 0.601. So the correct order, smallest to largest, is 0.5, 0.55, 0.56, 0.6, 0.601.
- (d) 10 — Method: picking 3 flowers from 5 leaves 2 flowers behind, so counting the different pairs that could be left out counts the bunches, and those pairs can be listed systematically. Working: number the flowers 1 to 5; the first flower can be left out alongside any of the 4 flowers after it, the second alongside any of the 3 after it, the third alongside any of the 2 after it and the fourth alongside the last one, so the number of pairs left out is 4 + 3 + 2 + 1 = 10. Answer: 10. The distractors: 60 comes from working out 5 × 4 × 3 and treating the three picks as an ordered selection when the order does not matter; 30 comes from dividing that product by 2 instead of by the 6 orders in which three chosen flowers could have been picked; 15 comes from multiplying the 5 flowers by the 3 flowers picked instead of counting the selections.
- (d) 60 mph — Average speed = distance ÷ time, with the time measured in hours. 45 minutes is 45/60 of an hour, which is 0.75 of an hour, so the journey takes 1.75 hours. Speed = 105 ÷ 1.75 = 60 mph. 52.5 mph rounds the time up to 2 hours, 72.4 mph writes 1 hour 45 minutes as 1.45 hours, and 183.75 mph multiplies the distance by the time instead of dividing.
- (a) 11:20 — Method: find the flight time using time = distance ÷ speed, then add this to the departure time. Working: 2340 ÷ 780 = 3 hours; 08:20 + 3 hours = 11:20. Answer: 11:20. 08:40 comes from dividing speed by distance instead of distance by speed, giving a flight time of 1/3 hour (20 minutes) rather than 3 hours. 11:00 comes from adding the 3-hour flight time to the hour of the departure time only, 8 + 3 = 11, and losing the 20 minutes. 03:00 comes from finding the flight time correctly but giving it as a clock time on its own, forgetting to add it to the departure time.
- (a) 1/2, 3/5, 2/3, 5/6 — Convert all four fractions to a common denominator of 30: 2/3 is 20/30, 3/5 is 18/30, 5/6 is 25/30, and 1/2 is 15/30. Ordering by these numerators, smallest to largest, gives 15/30, 18/30, 20/30, 25/30, which is 1/2, 3/5, 2/3, 5/6. Ordering by the size of the numerator in the original fractions, 1, 2, 3, 5, rather than converting to a common denominator, gives the wrong order 1/2, 2/3, 3/5, 5/6, because it ignores that the denominators are different. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 5/6, 2/3, 3/5, 1/2. Using the rule "the bigger the denominator, the smaller the fraction" to place the last two, so that 5/6 is put below 2/3 because 6 is bigger than 3, gives 1/2, 3/5, 5/6, 2/3 — that rule only holds when the numerators are the same, and here 20/30 really is smaller than 25/30. So the correct order, smallest to largest, is 1/2, 3/5, 2/3, 5/6.
- (c) 2000 mm — Put both lengths into the same unit first. There are 1000 mm in a metre, so the ribbon is 2.4 × 1000 = 2400 mm, and there are 10 mm in a centimetre, so the piece cut off is 40 × 10 = 400 mm. The length left is 2400 − 400 = 2000 mm. 2360 mm subtracts 40 mm instead of 400 mm, 200 mm works in centimetres and then labels the result as millimetres, and 2800 mm adds the piece that was cut off instead of subtracting it.
- (b) 235 ≤ n < 245 — Method: the error interval stretches half the rounding unit either side of the rounded value, with the upper bound excluded because it would round up to the next value. Working: half of 10 is 5, so the interval runs from 240 − 5 to 240 + 5. Answer: 235 ≤ n < 245. (230 ≤ n < 250 comes from using the whole rounding unit, 10, either side instead of half of it. 235 ≤ n ≤ 245 comes from including the upper bound with ≤ instead of excluding it with <. 239.5 ≤ n < 240.5 comes from rounding to the nearest whole number instead of the nearest 10, so half of 1 is used in place of half of 10.)
Build your own mix at the worksheet builder.