Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) 7.5 × 10⁴ — Standard form is A × 10ⁿ, where A is between 1 and 10 (1 ≤ A < 10) and n is an integer — 7.5 × 10⁴ satisfies all of this. 12 × 10³ fails because 12 is not below 10. 0.5 × 10⁴ fails because 0.5 is not at least 1. 6.2 × 4⁵ fails because standard form always uses a power of 10, not a power of 4.
- (c) £4.05 — The total cost is 7 × 85p = £5.95. Josh's change is £10.00 − £5.95 = £4.05. Taking off the pounds and then only the 5p digit, £10.00 − £5.00 = £5.00 followed by £5.00 − £0.05, ignoring the 90p altogether, gives £4.95. Rounding the cost up to £6.00 and never accounting for the extra 5p at all gives £4.00. Multiplying 7 × 85 incorrectly as 605 (a slip in 7 × 5) gives a total cost of £6.05, and correctly subtracting that from £10.00 gives £3.95.
- (a) 1,850 — Method: find the error interval, then check which value falls outside it. Working: half of 100 is 50, so the actual number of visitors, v, satisfies 1,750 ≤ v < 1,850. 1,850 sits exactly on the excluded upper boundary, since a value of 1,850 would round to 1,900, not 1,800. Answer: 1,850. (1,750 is a genuine possible value — it sits at the included lower boundary. 1,799 is a genuine possible value, just below the upper boundary. 1,760 is a genuine possible value, well inside the interval.)
- (c) 22 — Without restriction there are 6 × 4 = 24 combinations. Two specific combinations are not available, so subtract 2: 24 − 2 = 22. 24 comes from ignoring the restriction completely. 23 comes from subtracting only 1 of the 2 excluded combinations. 18 comes from removing the whole sport trim level, 6 × 3 = 18, instead of removing just the two excluded combinations.
- (a) 17 — Method: work out each power separately, then combine them as the question asks. Working: $2^3 = 8$ and $3^2 = 9$, and 8 + 9 = 17. 72 comes from working out 8 × 9 = 72, multiplying the two powers instead of adding them. 12 comes from misreading the powers as repeated multiplication of the base by the index, 2 × 3 + 3 × 2 = 6 + 6 = 12. −1 comes from working out 8 − 9 = −1, subtracting the powers instead of adding them. Answer: 17.
- (c) 0.0479 — Method: round each option to 2 significant figures and check which one gives 0.048. Working: for 0.0479, the first two significant figures are 4 and 7; the next digit is 9, so 7 rounds up to 8, giving 0.048. For 0.0485, the first two significant figures are 4 and 8; the next digit is 5, so 8 rounds up to 9, giving 0.049, not 0.048. 0.052 already has exactly 2 significant figures, 5 and 2, so it stays as 0.052 and does not round to 0.048 at all. 0.04 has only 1 significant figure, so it is already less precise than the 2 significant figures asked for. Answer: 0.0479.
- (a) 8 litres per minute — Method: write the time as a decimal number of minutes, then divide the volume by the time. Working: 30 seconds = 30/60 minute = 0.5 minute, so 2 minutes 30 seconds = 2.5 minutes. Rate = 20 ÷ 2.5 = 8 litres per minute. Answer: 8 litres per minute. (10 litres per minute comes from ignoring the extra 30 seconds and dividing by 2 minutes only. 8.7 litres per minute comes from misreading 2 minutes 30 seconds as 2.3 minutes instead of 2.5 minutes. 0.125 litres per minute comes from dividing the time by the volume instead of the volume by the time.)
- (d) 1.2 × 10⁵ — 4 × 3 = 12, and 3 + 1 = 4, giving 12 × 10⁴ — but 12 is not between 1 and 10, so this must be rewritten as 1.2 × 10⁵. Stopping at 12 × 10⁴ without rewriting it leaves the coefficient out of range. Rewriting 12 as 1.2 but leaving the exponent at 4 instead of increasing it to 5 gives 1.2 × 10⁴, which is ten times too small. Adding the coefficients instead of multiplying them gives 4 + 3 = 7, so 7 × 10⁴.
- (c) 62.35 ≤ r < 62.45 — Method: with a value rounded to 1 decimal place, the error interval reaches half of 0.1 either side. Working: half of 0.1 is 0.05, so the interval runs from 62.4 − 0.05 to 62.4 + 0.05. Answer: 62.35 ≤ r < 62.45. (62 ≤ r < 63 comes from rounding to the nearest whole number instead of 1 decimal place. 62.35 ≤ r ≤ 62.45 comes from including the upper bound with ≤ instead of excluding it with <. 62.3 ≤ r < 62.5 comes from using 0.1 either side instead of half of it.)
- (a) 0.5, 0.55, 0.56, 0.6, 0.601 — Compare the decimals by giving them all the same number of decimal places first: 0.600, 0.550, 0.601, 0.500, 0.560. Ordering these from smallest to largest gives 0.500, 0.550, 0.560, 0.600, 0.601, which is 0.5, 0.55, 0.56, 0.6, 0.601. Comparing the digits as though they were whole numbers, reading 0.601 as "601" and 0.5 as "5", without padding to the same number of decimal places, gives the wrong order 0.5, 0.6, 0.55, 0.56, 0.601, because it ignores the place value of each digit. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 0.601, 0.6, 0.56, 0.55, 0.5. Misreading the close values 0.55 and 0.56 and swapping them gives 0.5, 0.56, 0.55, 0.6, 0.601. So the correct order, smallest to largest, is 0.5, 0.55, 0.56, 0.6, 0.601.
- (c) 2.6 × 10⁵ — In standard form, A must satisfy 1 ≤ A < 10. Moving the decimal point in 260,000 to just after the 2 gives A = 2.6, and the decimal point moved 5 places, so 260,000 = 2.6 × 10⁵. A candidate who wrote 26 × 10⁴ used a value of A outside the required range, even though it has the same overall value. A candidate who wrote 2.6 × 10⁶ counted one place too many when moving the decimal point. A candidate who wrote 0.26 × 10⁶ used a value of A below 1, again outside the required range.
- (a) 42.5 ≤ t < 47.5 — Rounding to the nearest 5 minutes means the actual time can be up to half of 5 minutes, 2.5 minutes, below or above 45 before it would round to a different multiple of 5. The lower bound is 45 − 2.5 = 42.5 and the upper bound is 45 + 2.5 = 47.5. A time of exactly 47.5 minutes would round up to 50, not 45, so 47.5 is excluded while 42.5 does still round to 45. Writing 42.5 ≤ t ≤ 47.5 wrongly includes 47.5. Writing 40 ≤ t < 50 uses a whole rounding unit, 5, either side instead of half of it. Writing 44.5 ≤ t < 45.5 treats the rounding unit as 1 minute instead of 5 minutes.
- (d) £6 — First find 30% of £200, which is £60, then find 10% of that: £60 × 0.1 = £6. Adding the two percentages together instead of applying them one after the other, 10% + 30% = 40%, and finding 40% of £200 gives £80. Finding 30% of £200 = £60 correctly but stopping before applying the second percentage leaves £60 as the final answer. Finding only 10% of the original £200, ignoring the 30% entirely, gives £20.
- (d) −1.4, −6/5, 0, 5/4, 1.3 — Method: convert the fractions 5/4 and −6/5 to decimals so every number is written the same way, then compare all five decimals. Working: 5/4 = 1.25 and −6/5 = −1.2. Comparing −1.4, −1.2, 0, 1.25 and 1.3 in size gives the order −1.4, −1.2, 0, 1.25, 1.3. Answer: −1.4, −6/5, 0, 5/4, 1.3. −6/5, −1.4, 0, 5/4, 1.3 swaps the two negative numbers, treating −6/5 as more negative than −1.4 even though −1.2 is closer to zero than −1.4. 1.3, 5/4, 0, −6/5, −1.4 lists the numbers from largest to smallest instead of smallest to largest. −1.4, −6/5, 0, 1.3, 5/4 swaps 5/4 and 1.3, comparing the numerator 5 directly with 1.3 instead of converting 5/4 to the decimal 1.25 first.
- (a) 8.35 ≤ L < 8.45 — Method: a length rounded to 1 decimal place lies within half of 0.1 cm, that is 0.05 cm, of the value written down. The lower limit is included because it rounds up to that value, and the upper limit is excluded because it rounds up to the next value instead. Working: 8.4 − 0.05 = 8.35 and 8.4 + 0.05 = 8.45, so a length of 8.35 cm still rounds to 8.4 cm while a length of 8.45 cm rounds to 8.5 cm. Answer: 8.35 ≤ L < 8.45. The distractors: 8.3 ≤ L < 8.5 goes a whole 0.1 cm either side instead of half of it; 8.35 < L ≤ 8.45 has the two limits the wrong way round, excluding the length that does round to 8.4 cm and including the one that does not; 8.4 ≤ L < 8.5 is the interval for a length truncated to 1 decimal place, not one rounded to it.
Build your own mix at the worksheet builder.