Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) £4.80 — Method: find the error interval, then check which value falls outside it. Working: half of 20p is 10p, so the actual cost, c, satisfies £4.50 ≤ c < £4.70. £4.80 is above £4.70, so it could not be the actual cost. Answer: £4.80. (£4.50 is a genuine possible cost — it sits at the included lower boundary. £4.65 is a genuine possible cost, below the £4.70 upper boundary. £4.55 is a genuine possible cost, well inside the interval.)
- (a) 3.84 × 10⁵ — 384,000 = 3.84 × 100,000 = 3.84 × 10⁵, with the decimal point moved five places and the coefficient kept between 1 and 10. Moving the point six places instead of five gives 3.84 × 10⁶, ten times too large. Leaving the coefficient as 38.4 gives 38.4 × 10⁴, which is not between 1 and 10. Using a negative exponent instead of a positive one gives 3.84 × 10⁻⁵, a number far smaller than 1.
- (d) 64 — Method: each time the power increases by 1, the value doubles, since one more 2 is multiplied in. Working: 2⁶ = 2⁵ × 2 = 32 × 2 = 64. Answer: 64. (37 comes from adding the power to the value, 32 + 5, instead of multiplying by the base. 192 comes from multiplying 32 by the new power, 6, instead of by the base, 2. 34 comes from adding the base to the value, 32 + 2, instead of multiplying.)
- (a) 8.35 ≤ L < 8.45 — Method: a length rounded to 1 decimal place lies within half of 0.1 cm, that is 0.05 cm, of the value written down. The lower limit is included because it rounds up to that value, and the upper limit is excluded because it rounds up to the next value instead. Working: 8.4 − 0.05 = 8.35 and 8.4 + 0.05 = 8.45, so a length of 8.35 cm still rounds to 8.4 cm while a length of 8.45 cm rounds to 8.5 cm. Answer: 8.35 ≤ L < 8.45. The distractors: 8.3 ≤ L < 8.5 goes a whole 0.1 cm either side instead of half of it; 8.35 < L ≤ 8.45 has the two limits the wrong way round, excluding the length that does round to 8.4 cm and including the one that does not; 8.4 ≤ L < 8.5 is the interval for a length truncated to 1 decimal place, not one rounded to it.
- (b) 3.65 ≤ n < 3.75 — Rounding to 1 decimal place means n can be up to half of one decimal place, 0.05, below or above 3.7 before it would round to a different value. This gives a lower bound of 3.7 − 0.05 = 3.65 and an upper bound of 3.7 + 0.05 = 3.75. A value exactly at 3.75 would round up to 3.8, not 3.7, so the upper bound is excluded while the lower bound, 3.65, does still round to 3.7. Writing 3.65 ≤ n ≤ 3.75 wrongly includes 3.75. Writing 3.6 ≤ n < 3.8 uses a whole decimal place, 0.1, either side instead of half of one, 0.05. Writing 3.65 < n < 3.75 wrongly excludes 3.65, which does round to 3.7.
- (b) 0.3, 32%, 7/20 — Method: convert every number to a decimal so they can be compared on the same scale. Working: 7/20 = 0.35, 0.3 stays as 0.3, and 32% = 0.32. Comparing 0.3, 0.32 and 0.35 in size gives the order 0.3, then 0.32, then 0.35. Answer: 0.3, 32%, 7/20. 7/20, 32%, 0.3 lists the numbers from largest to smallest instead of smallest to largest. 0.3, 7/20, 32% swaps 32% and 7/20, treating the fraction 7/20 as smaller even though 7/20 = 0.35 is bigger than 32% = 0.32. 32%, 0.3, 7/20 comes from moving the digits one place too far when converting the percentage, giving 0.032 instead of 0.32, which makes 32% look far smaller than it really is.
- (b) No, the true mass could be as high as 852.5 kg — Method: find the upper bound of the true mass and compare it with the weight limit. Working: the display is correct to the nearest 5 kg, so half of 5 kg is 2.5 kg, and the true mass, m kg, satisfies 847.5 ≤ m < 852.5. Part of that interval lies above 850 kg, so the parcels are not definitely within the limit. Answer: the true mass could be as high as 852.5 kg, which is above the limit. ("Yes, the display reads 850 kg, which is not above the limit" compares the limit with the displayed value instead of with the largest value the true mass could take. "Yes, the true mass is at least 847.5 kg and at most 850 kg" uses the correct half unit below but caps the interval at the limit instead of at 852.5 kg. "No, 850 kg on the display rounds up to 855 kg" wrongly treats the displayed value as if it rounds again.)
- (a) 200 g — One quarter of 160 g is 40 g. Increasing the amount means adding this on: 160 + 40 = 200 g. Finding the increase, 1/4 of 160 = 40 g, but stopping there without adding it to the original amount leaves just 40 g. Using 4/5 instead of 5/4 as the scaling fraction, 160 × 4/5 = 128 g, actually decreases the amount rather than increasing it. Increasing by a half instead of a quarter, 160 + 80 = 240 g, uses the wrong fraction of 160.
- (c) 8 hours 35 minutes — From 21:35 to midnight is 2 hours 25 minutes, and from midnight to 06:10 is a further 6 hours 10 minutes, giving a total of 8 hours 35 minutes. Misreading the departure time as 22:35 instead of 21:35 loses an hour from the calculation and gives 7 hours 35 minutes. Misreading the departure time as 20:35 instead of 21:35 gains an hour and gives 9 hours 35 minutes. Subtracting the times as if both fell on the same day, without crossing midnight, gives 15 hours 25 minutes.
- (c) 0.0479 — Method: round each option to 2 significant figures and check which one gives 0.048. Working: for 0.0479, the first two significant figures are 4 and 7; the next digit is 9, so 7 rounds up to 8, giving 0.048. For 0.0485, the first two significant figures are 4 and 8; the next digit is 5, so 8 rounds up to 9, giving 0.049, not 0.048. 0.052 already has exactly 2 significant figures, 5 and 2, so it stays as 0.052 and does not round to 0.048 at all. 0.04 has only 1 significant figure, so it is already less precise than the 2 significant figures asked for. Answer: 0.0479.
- (a) 1/2, 3/5, 2/3, 5/6 — Convert all four fractions to a common denominator of 30: 2/3 is 20/30, 3/5 is 18/30, 5/6 is 25/30, and 1/2 is 15/30. Ordering by these numerators, smallest to largest, gives 15/30, 18/30, 20/30, 25/30, which is 1/2, 3/5, 2/3, 5/6. Ordering by the size of the numerator in the original fractions, 1, 2, 3, 5, rather than converting to a common denominator, gives the wrong order 1/2, 2/3, 3/5, 5/6, because it ignores that the denominators are different. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 5/6, 2/3, 3/5, 1/2. Using the rule "the bigger the denominator, the smaller the fraction" to place the last two, so that 5/6 is put below 2/3 because 6 is bigger than 3, gives 1/2, 3/5, 5/6, 2/3 — that rule only holds when the numerators are the same, and here 20/30 really is smaller than 25/30. So the correct order, smallest to largest, is 1/2, 3/5, 2/3, 5/6.
- (b) 78 hours — From 10:00 on Monday to 10:00 on Thursday is exactly 3 complete days, which is 3 × 24 = 72 hours. From 10:00 to 16:00 on the Thursday is a further 6 hours, giving a total of 72 + 6 = 78 hours. Counting Monday to Thursday as 4 full calendar days instead of 3 complete 24-hour periods gives 4 × 24 = 96 hours. Undercounting the number of complete days as 2 instead of 3 gives 2 × 24 + 6 = 54 hours. Subtracting the extra 6 hours instead of adding them to the 3 complete days gives 72 − 6 = 66 hours.
- (c) 0.0065 — Leading zeros are never significant, so counting from the first non-zero digit, the first two significant figures of 0.006482 are 6 and 4. Look at the next digit along, 8, to decide whether the second figure rounds up: since 8 is 5 or more, the 4 rounds up to 5, giving 0.0065. Rounding to 2 decimal places instead of 2 significant figures gives 0.01, which answers a different question. Wrongly counting one of the leading zeros as a significant figure and stopping one figure short gives 0.006. Keeping an extra digit, as in 0.00648, gives 3 significant figures rather than 2.
- (a) 42.5 ≤ t < 47.5 — Rounding to the nearest 5 minutes means the actual time can be up to half of 5 minutes, 2.5 minutes, below or above 45 before it would round to a different multiple of 5. The lower bound is 45 − 2.5 = 42.5 and the upper bound is 45 + 2.5 = 47.5. A time of exactly 47.5 minutes would round up to 50, not 45, so 47.5 is excluded while 42.5 does still round to 45. Writing 42.5 ≤ t ≤ 47.5 wrongly includes 47.5. Writing 40 ≤ t < 50 uses a whole rounding unit, 5, either side instead of half of it. Writing 44.5 ≤ t < 45.5 treats the rounding unit as 1 minute instead of 5 minutes.
- (c) 2000 mm — Put both lengths into the same unit first. There are 1000 mm in a metre, so the ribbon is 2.4 × 1000 = 2400 mm, and there are 10 mm in a centimetre, so the piece cut off is 40 × 10 = 400 mm. The length left is 2400 − 400 = 2000 mm. 2360 mm subtracts 40 mm instead of 400 mm, 200 mm works in centimetres and then labels the result as millimetres, and 2800 mm adds the piece that was cut off instead of subtracting it.
Build your own mix at the worksheet builder.