Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) £4.05 — The total cost is 7 × 85p = £5.95. Josh's change is £10.00 − £5.95 = £4.05. Taking off the pounds and then only the 5p digit, £10.00 − £5.00 = £5.00 followed by £5.00 − £0.05, ignoring the 90p altogether, gives £4.95. Rounding the cost up to £6.00 and never accounting for the extra 5p at all gives £4.00. Multiplying 7 × 85 incorrectly as 605 (a slip in 7 × 5) gives a total cost of £6.05, and correctly subtracting that from £10.00 gives £3.95.
- (c) 9π cm² — The area of a circle is π × r². With a radius of 3 cm this is π × 3² = 9π cm², and this is exact because π has not been replaced by any approximation. Writing 28.3 cm² replaces π with a rounded decimal value, 3.14, and then rounds the result again, so it is only an approximation. Writing 28.26 cm² uses π ≈ 3.14 without a final rounding step, but this is still only an approximation of 9π, not the exact value. Writing 27 cm² comes from replacing π with the rough approximation 3, which is even further from the true value.
- (c) 4.1 × 10³, 3.2 × 10⁴, 2.9 × 10⁵ — The exponent decides the size first: 10³ is smaller than 10⁴, which is smaller than 10⁵, so the order is 4.1 × 10³, then 3.2 × 10⁴, then 2.9 × 10⁵. Reversing the whole list gives largest to smallest instead of smallest to largest. Comparing 3.2 × 10⁴ and 4.1 × 10³ by their coefficients alone, 3.2 against 4.1, and swapping them ignores that 10⁴ is bigger than 10³ regardless of the coefficient. Comparing 2.9 × 10⁵ and 3.2 × 10⁴ by their coefficients alone and swapping them makes the same mistake at the top of the list.
- (b) 245 ≤ m < 255 — Method: a mass given to the nearest 10 g lies within half of 10 g, that is 5 g, of the figure written down. The lower limit is included because it rounds up to that figure, and the upper limit is excluded because it rounds up to the next multiple of 10. Working: 250 − 5 = 245 and 250 + 5 = 255, and a mass of 245 g rounds to 250 g while a mass of 255 g rounds to 260 g. Answer: 245 ≤ m < 255. The distractors: 240 ≤ m < 260 goes a whole 10 g either side instead of half of it; 245 < m ≤ 255 has the two limits the wrong way round; 240 ≤ m < 250 treats the stated 250 g as the largest mass possible, as though rounding were always upwards.
- (a) 0.5, 0.55, 0.56, 0.6, 0.601 — Compare the decimals by giving them all the same number of decimal places first: 0.600, 0.550, 0.601, 0.500, 0.560. Ordering these from smallest to largest gives 0.500, 0.550, 0.560, 0.600, 0.601, which is 0.5, 0.55, 0.56, 0.6, 0.601. Comparing the digits as though they were whole numbers, reading 0.601 as "601" and 0.5 as "5", without padding to the same number of decimal places, gives the wrong order 0.5, 0.6, 0.55, 0.56, 0.601, because it ignores the place value of each digit. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 0.601, 0.6, 0.56, 0.55, 0.5. Misreading the close values 0.55 and 0.56 and swapping them gives 0.5, 0.56, 0.55, 0.6, 0.601. So the correct order, smallest to largest, is 0.5, 0.55, 0.56, 0.6, 0.601.
- (a) 4,000 nanometres — Method: the number of nanometres is the diameter divided by the length of one nanometre, and dividing powers of ten means subtracting the indices. Working: −6 − (−9) = 3, so 10⁻⁶ ÷ 10⁻⁹ = 10³, and the diameter is 4 × 10³ nanometres. Answer: 4,000 nanometres. The distractors: 400 nanometres comes from taking the difference between the indices as 2 instead of 3; 4 nanometres comes from changing the name of the unit without converting, leaving the coefficient untouched; 0.004 nanometres comes from dividing by 10³ instead of multiplying by it, as though a nanometre were the larger of the two units.
- (a) 200 g — One quarter of 160 g is 40 g. Increasing the amount means adding this on: 160 + 40 = 200 g. Finding the increase, 1/4 of 160 = 40 g, but stopping there without adding it to the original amount leaves just 40 g. Using 4/5 instead of 5/4 as the scaling fraction, 160 × 4/5 = 128 g, actually decreases the amount rather than increasing it. Increasing by a half instead of a quarter, 160 + 80 = 240 g, uses the wrong fraction of 160.
- (a) £18 — Method: the percentage acts as an operator on the bill, and 15% can be built from 10% and 5%, where 5% is half of 10%. Working: 10% of £120 is £120 ÷ 10 = £12, and 5% is half of that, £6, so the charge is £12 + £6 = £18. Answer: £18. The distractors: £8 comes from reading 15% as one fifteenth and working out £120 ÷ 15 = £8; £12 comes from finding 10% of the bill and stopping there; £138 comes from finding the charge correctly and then giving the new total, £120 + £18, rather than the charge the question asks for.
- (b) 3.65 ≤ n < 3.75 — Rounding to 1 decimal place means n can be up to half of one decimal place, 0.05, below or above 3.7 before it would round to a different value. This gives a lower bound of 3.7 − 0.05 = 3.65 and an upper bound of 3.7 + 0.05 = 3.75. A value exactly at 3.75 would round up to 3.8, not 3.7, so the upper bound is excluded while the lower bound, 3.65, does still round to 3.7. Writing 3.65 ≤ n ≤ 3.75 wrongly includes 3.75. Writing 3.6 ≤ n < 3.8 uses a whole decimal place, 0.1, either side instead of half of one, 0.05. Writing 3.65 < n < 3.75 wrongly excludes 3.65, which does round to 3.7.
- (c) 3 × 10⁶ — Daily revenue = (4 × 10³) × 2.5 = 1 × 10⁴ (£10,000). Multiplying by the number of days, (3 × 10²), gives annual revenue = (1 × 10⁴) × (3 × 10²) = 3 × 10⁶ (£3,000,000). A candidate who forgot to multiply by the price and just multiplied the number of items by the number of days worked out (4 × 10³) × (3 × 10²) = 1.2 × 10⁶. A candidate who added the number of days to the daily revenue instead of multiplying worked out 1 × 10⁴ + 3 × 10² = 1.03 × 10⁴. A candidate who misread £2.50 as £25 worked out a daily revenue of (4 × 10³) × 25 = 1 × 10⁵, giving an annual total of (1 × 10⁵) × (3 × 10²) = 3 × 10⁷.
- (a) 7.2 × 10⁻⁴ — 0.00072 = 7.2 × 10⁻⁴, moving the decimal point 4 places to the right to reach 7.2, so the exponent is negative. Writing 7.2 × 10⁴ uses a positive exponent, which would give a number far larger than 1, not a small decimal. Writing 7.2 × 10⁻⁵ moves the point one place too many. Writing 0.72 × 10⁻³ leaves the coefficient below 1, which standard form does not allow.
- (c) 62.35 ≤ r < 62.45 — Method: with a value rounded to 1 decimal place, the error interval reaches half of 0.1 either side. Working: half of 0.1 is 0.05, so the interval runs from 62.4 − 0.05 to 62.4 + 0.05. Answer: 62.35 ≤ r < 62.45. (62 ≤ r < 63 comes from rounding to the nearest whole number instead of 1 decimal place. 62.35 ≤ r ≤ 62.45 comes from including the upper bound with ≤ instead of excluding it with <. 62.3 ≤ r < 62.5 comes from using 0.1 either side instead of half of it.)
- (c) 2.5 × 10⁶ — Divide the A values: 5 ÷ 2 = 2.5. Subtract the powers of 10: 4 − (−2) = 4 + 2 = 6. So the answer is 2.5 × 10⁶. A candidate who worked out 4 − 2 = 2, treating the subtraction of a negative as an ordinary subtraction, wrote 2.5 × 10². A candidate who subtracted in the wrong order, −2 − 4 = −6, wrote 2.5 × 10⁻⁶. A candidate who multiplied the A values instead of dividing, 5 × 2 = 10, and added the powers, 4 + (−2) = 2, then rewrote 10 × 10² in standard form as 1 × 10³.
- (d) 60 mph — Average speed = distance ÷ time, with the time measured in hours. 45 minutes is 45/60 of an hour, which is 0.75 of an hour, so the journey takes 1.75 hours. Speed = 105 ÷ 1.75 = 60 mph. 52.5 mph rounds the time up to 2 hours, 72.4 mph writes 1 hour 45 minutes as 1.45 hours, and 183.75 mph multiplies the distance by the time instead of dividing.
- (b) 18.5 ≤ T < 18.7 — Method: the error interval reaches half the rounding unit either side of the recorded value. Working: half of 0.2 is 0.1, so the interval runs from 18.6 − 0.1 to 18.6 + 0.1. Answer: 18.5 ≤ T < 18.7. (18.4 ≤ T < 18.8 comes from using the full rounding unit, 0.2, either side instead of half of it. 18.5 ≤ T ≤ 18.7 comes from including the upper bound with ≤ instead of excluding it with <. 18.6 ≤ T < 18.8 comes from treating the recorded value as the start of the interval and adding the whole rounding unit, 0.2, above it.)
Build your own mix at the worksheet builder.