Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) £4.05 — The total cost is 7 × 85p = £5.95. Josh's change is £10.00 − £5.95 = £4.05. Taking off the pounds and then only the 5p digit, £10.00 − £5.00 = £5.00 followed by £5.00 − £0.05, ignoring the 90p altogether, gives £4.95. Rounding the cost up to £6.00 and never accounting for the extra 5p at all gives £4.00. Multiplying 7 × 85 incorrectly as 605 (a slip in 7 × 5) gives a total cost of £6.05, and correctly subtracting that from £10.00 gives £3.95.
- (c) Sam is correct — The leading zeros in 0.070268 are not significant, so the first three significant figures are 7, 0 and 2. The next digit along is 6, and since 6 is 5 or more, the third significant figure rounds up from 2 to 3, giving 0.0703. This means Sam's answer is correct. Writing 0.070 keeps only 2 significant figures, one short of what was asked. Writing 0.0702 ignores the digit 6 that follows and leaves the third figure unrounded. Writing 0.0704 rounds the third figure up twice, as if a later digit had also pushed it up.
- (d) £120 — Total parts = 5 + 3 = 8, so one part is worth 320 ÷ 8 = 40 pounds. The cake sale is 3 parts, so it raised 3 × 40 = 120 pounds. £200 comes from working out the raffle's share, 5 × 40, instead of the cake sale's share. £40 comes from finding the value of one part but forgetting to multiply by 3. £192 comes from dividing the total by 5 instead of 8 to find the value of one part, 320 ÷ 5 = 64, then multiplying by 3, 3 × 64 = 192.
- (a) 8.35 ≤ L < 8.45 — Method: a length rounded to 1 decimal place lies within half of 0.1 cm, that is 0.05 cm, of the value written down. The lower limit is included because it rounds up to that value, and the upper limit is excluded because it rounds up to the next value instead. Working: 8.4 − 0.05 = 8.35 and 8.4 + 0.05 = 8.45, so a length of 8.35 cm still rounds to 8.4 cm while a length of 8.45 cm rounds to 8.5 cm. Answer: 8.35 ≤ L < 8.45. The distractors: 8.3 ≤ L < 8.5 goes a whole 0.1 cm either side instead of half of it; 8.35 < L ≤ 8.45 has the two limits the wrong way round, excluding the length that does round to 8.4 cm and including the one that does not; 8.4 ≤ L < 8.5 is the interval for a length truncated to 1 decimal place, not one rounded to it.
- (d) 40 miles — Method: round each number to 1 significant figure first, then divide to estimate the daily distance. Working: 830 rounds to 800, and 19 rounds to 20, and 800 ÷ 20 = 40, so the estimate is 40 miles per day. 41.5 miles comes from rounding only the number of days and working out 830 ÷ 20 = 41.5, without rounding the distance too. 830 miles is the total distance for the whole trek, given as the answer without dividing by the number of days at all. 4 miles comes from working out 80 ÷ 20 = 4, misplacing a digit in the rounded distance. Answer: 40 miles.
- (b) 78 hours — From 10:00 on Monday to 10:00 on Thursday is exactly 3 complete days, which is 3 × 24 = 72 hours. From 10:00 to 16:00 on the Thursday is a further 6 hours, giving a total of 72 + 6 = 78 hours. Counting Monday to Thursday as 4 full calendar days instead of 3 complete 24-hour periods gives 4 × 24 = 96 hours. Undercounting the number of complete days as 2 instead of 3 gives 2 × 24 + 6 = 54 hours. Subtracting the extra 6 hours instead of adding them to the 3 complete days gives 72 − 6 = 66 hours.
- (c) 11 — Method: work out the total number of combinations as if there were no restriction, then subtract the one combination that is not allowed. Working: without any restriction there are 4 backdrops × 3 outfits = 12 combinations. The grey backdrop with the formal suit is not allowed, removing 1 combination: 12 − 1 = 11. Answer: 11. 12 comes from forgetting to remove the combination that is not allowed. 8 comes from removing the entire formal suit outfit from the count instead of just the one combination with the grey backdrop. 10 comes from removing two combinations instead of just the one that is not allowed.
- (b) Yes — the actual mass could be as low as 995 g — Method: a mass shown to the nearest 10 g lies within half of 10 g, that is 5 g, of the figure on the display, so compare the smallest mass the bag can have with the checker's limit of 996 g. Working: 1,000 − 5 = 995, so the actual mass of the bag can be as low as 995 g, and 995 g is below the 996 g limit, so a bag showing 1,000 g on the machine can still be rejected. Answer: Yes — the actual mass could be as low as 995 g. The distractors: 990 g comes from going a whole 10 g below the display instead of half of it; 999.5 g comes from treating the display as being to the nearest gram, when it is to the nearest 10 g; the claim that the mass is exactly 1,000 g treats a rounded display as an exact measurement.
- (d) 6 × 10⁷ — 3 × 2 = 6, and 2 + 5 = 7, so (3 × 10²) × (2 × 10⁵) = 6 × 10⁷. Multiplying the exponents instead of adding them gives 2 × 5 = 10, so 6 × 10¹⁰. Adding the coefficients instead of multiplying them gives 3 + 2 = 5, so 5 × 10⁷. Subtracting the exponents instead of adding them gives 5 − 2 = 3, so 6 × 10³.
- (a) 0.5, 0.55, 0.56, 0.6, 0.601 — Compare the decimals by giving them all the same number of decimal places first: 0.600, 0.550, 0.601, 0.500, 0.560. Ordering these from smallest to largest gives 0.500, 0.550, 0.560, 0.600, 0.601, which is 0.5, 0.55, 0.56, 0.6, 0.601. Comparing the digits as though they were whole numbers, reading 0.601 as "601" and 0.5 as "5", without padding to the same number of decimal places, gives the wrong order 0.5, 0.6, 0.55, 0.56, 0.601, because it ignores the place value of each digit. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 0.601, 0.6, 0.56, 0.55, 0.5. Misreading the close values 0.55 and 0.56 and swapping them gives 0.5, 0.56, 0.55, 0.6, 0.601. So the correct order, smallest to largest, is 0.5, 0.55, 0.56, 0.6, 0.601.
- (c) 2000 mm — Put both lengths into the same unit first. There are 1000 mm in a metre, so the ribbon is 2.4 × 1000 = 2400 mm, and there are 10 mm in a centimetre, so the piece cut off is 40 × 10 = 400 mm. The length left is 2400 − 400 = 2000 mm. 2360 mm subtracts 40 mm instead of 400 mm, 200 mm works in centimetres and then labels the result as millimetres, and 2800 mm adds the piece that was cut off instead of subtracting it.
- (c) 65 cm — Method: the upper bound is half the rounding unit above the given value. Working: half of 10 cm is 5 cm, so the upper bound is 60 + 5 = 65 cm. Answer: 65 cm. (70 cm comes from adding the whole rounding unit, 10, instead of half of it. 60 cm comes from giving the rounded value itself rather than the upper bound. 55 cm comes from subtracting the half unit instead of adding it, giving the lower bound.)
- (a) 4.5 × 10⁴ — 45,000 = 4.5 × 10,000 = 4.5 × 10⁴, with the coefficient between 1 and 10 as standard form requires. Writing 45 × 10³ keeps the coefficient too large — 45 is not between 1 and 10. Writing 4.5 × 10³ undercounts the places moved, giving only 4,500. Writing 4.5 × 10⁵ overcounts the places moved, giving 450,000.
- (a) 8.15 ≤ y < 8.25 — Rounding to 1 decimal place means the error interval spans half of 0.1, so 0.05, either side of 8.2: 8.2 − 0.05 = 8.15 and 8.2 + 0.05 = 8.25. The lower bound uses ≤ because 8.15 itself rounds to 8.2, but the upper bound uses < because 8.25 would round up to 8.3. So the error interval is 8.15 ≤ y < 8.25. A candidate who used the wrong rounding band gave 8.1 ≤ y < 8.2. A candidate who used a strict inequality at both ends wrote 8.15 < y < 8.25, wrongly excluding 8.15 itself. A candidate who added the full 0.1 instead of half of it wrote 8.2 ≤ y < 8.3.
- (a) 3.8 × 10⁻³ — 0.0038 is less than 1, so the power of 10 is negative. Moving the decimal point 3 places gives A = 3.8, so 0.0038 = 3.8 × 10⁻³. A candidate who wrote 3.8 × 10³ used a positive power, which is only correct for numbers of 10 or more. A candidate who wrote 38 × 10⁻⁴ used a value of A outside the required range. A candidate who wrote 3.8 × 10⁻⁴ counted one place too many when moving the decimal point.
Build your own mix at the worksheet builder.