Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) 7.2 × 10⁻⁴ — 0.00072 = 7.2 × 10⁻⁴, moving the decimal point 4 places to the right to reach 7.2, so the exponent is negative. Writing 7.2 × 10⁴ uses a positive exponent, which would give a number far larger than 1, not a small decimal. Writing 7.2 × 10⁻⁵ moves the point one place too many. Writing 0.72 × 10⁻³ leaves the coefficient below 1, which standard form does not allow.
- (c) 8 hours 35 minutes — From 21:35 to midnight is 2 hours 25 minutes, and from midnight to 06:10 is a further 6 hours 10 minutes, giving a total of 8 hours 35 minutes. Misreading the departure time as 22:35 instead of 21:35 loses an hour from the calculation and gives 7 hours 35 minutes. Misreading the departure time as 20:35 instead of 21:35 gains an hour and gives 9 hours 35 minutes. Subtracting the times as if both fell on the same day, without crossing midnight, gives 15 hours 25 minutes.
- (b) 18.5 ≤ T < 18.7 — Method: the error interval reaches half the rounding unit either side of the recorded value. Working: half of 0.2 is 0.1, so the interval runs from 18.6 − 0.1 to 18.6 + 0.1. Answer: 18.5 ≤ T < 18.7. (18.4 ≤ T < 18.8 comes from using the full rounding unit, 0.2, either side instead of half of it. 18.5 ≤ T ≤ 18.7 comes from including the upper bound with ≤ instead of excluding it with <. 18.6 ≤ T < 18.8 comes from treating the recorded value as the start of the interval and adding the whole rounding unit, 0.2, above it.)
- (c) 0.0479 — Method: round each option to 2 significant figures and check which one gives 0.048. Working: for 0.0479, the first two significant figures are 4 and 7; the next digit is 9, so 7 rounds up to 8, giving 0.048. For 0.0485, the first two significant figures are 4 and 8; the next digit is 5, so 8 rounds up to 9, giving 0.049, not 0.048. 0.052 already has exactly 2 significant figures, 5 and 2, so it stays as 0.052 and does not round to 0.048 at all. 0.04 has only 1 significant figure, so it is already less precise than the 2 significant figures asked for. Answer: 0.0479.
- (c) 2000 mm — Put both lengths into the same unit first. There are 1000 mm in a metre, so the ribbon is 2.4 × 1000 = 2400 mm, and there are 10 mm in a centimetre, so the piece cut off is 40 × 10 = 400 mm. The length left is 2400 − 400 = 2000 mm. 2360 mm subtracts 40 mm instead of 400 mm, 200 mm works in centimetres and then labels the result as millimetres, and 2800 mm adds the piece that was cut off instead of subtracting it.
- (a) 11 — Method: list every possible total from the smallest to the largest, and count how many different values there are. Working: the smallest total is 1+1=2 and the largest is 6+6=12, and every whole number total from 2 to 12 is possible: 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12 — that is 11 different totals. Answer: 11. 36 comes from counting the number of possible dice outcomes (6×6) instead of the number of different totals. 10 comes from listing the totals but missing one from the ends of the list, for example starting at 3 instead of 2. 6 comes from counting only the number of different scores on one die, not the totals of both dice together.
- (b) £72 — One fifth of £60 = £12. New price = £60 + £12 = £72. A candidate who gives the increase instead of the new price gets £12. A candidate who subtracts the increase instead of adding it gets £60 − £12 = £48. A candidate who uses 1/4 instead of 1/5 gets £60 + £15 = £75.
- (d) −1.4, −6/5, 0, 5/4, 1.3 — Method: convert the fractions 5/4 and −6/5 to decimals so every number is written the same way, then compare all five decimals. Working: 5/4 = 1.25 and −6/5 = −1.2. Comparing −1.4, −1.2, 0, 1.25 and 1.3 in size gives the order −1.4, −1.2, 0, 1.25, 1.3. Answer: −1.4, −6/5, 0, 5/4, 1.3. −6/5, −1.4, 0, 5/4, 1.3 swaps the two negative numbers, treating −6/5 as more negative than −1.4 even though −1.2 is closer to zero than −1.4. 1.3, 5/4, 0, −6/5, −1.4 lists the numbers from largest to smallest instead of smallest to largest. −1.4, −6/5, 0, 1.3, 5/4 swaps 5/4 and 1.3, comparing the numerator 5 directly with 1.3 instead of converting 5/4 to the decimal 1.25 first.
- (a) 300 N/m² — Pressure is force ÷ area, and the unit N/m² says so: newtons divided by square metres. The calculation is 240 ÷ 0.8. Multiplying both numbers by 10 clears the decimal: 2400 ÷ 8 = 300 N/m². 192 N/m² multiplies the force by the area instead of dividing, 30 N/m² divides by 8 and so loses the decimal point, and 3000 N/m² multiplies only the force by 10 when clearing the decimal.
- (a) 7 — Convert the mixed number to an improper fraction: 5 1/4 = 21/4. Dividing by 3/4 means multiplying by its reciprocal, 4/3: 21/4 × 4/3 gives 84/12, which simplifies to 7. So exactly 7 complete pieces of 3/4 m can be cut. Ignoring the 1/4 m and dividing only the whole number, 5 ÷ 3/4, gives 20/3, which is 6 complete pieces with some wood left over. Multiplying by 3/4 instead of its reciprocal, 21/4 × 3/4, gives 63/16, which is 3 complete pieces. Misreading 5 1/4 as the fraction 5/4, then dividing by 3/4, gives 5/3, which is only 1 complete piece. So 7 complete pieces can be cut from the plank.
- (c) 12.3 ≤ t < 12.4 — Method: truncating cuts the later digits off instead of rounding them, so nothing is ever pushed upwards. The displayed value is therefore the smallest the time can be, and the time can run up to, but not reach, the next value the display can show. Working: the display reads 12.3, so the actual time is at least 12.3 seconds; as soon as the time reaches 12.3 + 0.1 = 12.4 seconds the display would read 12.4, so 12.4 is not included. Answer: 12.3 ≤ t < 12.4. The distractors: 12.25 ≤ t < 12.35 is the interval for a time rounded to 1 decimal place, and this display does not round; 12.3 < t ≤ 12.4 excludes the one value the display certainly allows and includes the one it rules out; 12.3 ≤ t ≤ 12.4 treats 12.4 seconds as possible, but at 12.4 seconds the display would no longer read 12.3.
- (b) 78 hours — From 10:00 on Monday to 10:00 on Thursday is exactly 3 complete days, which is 3 × 24 = 72 hours. From 10:00 to 16:00 on the Thursday is a further 6 hours, giving a total of 72 + 6 = 78 hours. Counting Monday to Thursday as 4 full calendar days instead of 3 complete 24-hour periods gives 4 × 24 = 96 hours. Undercounting the number of complete days as 2 instead of 3 gives 2 × 24 + 6 = 54 hours. Subtracting the extra 6 hours instead of adding them to the 3 complete days gives 72 − 6 = 66 hours.
- (b) 245 ≤ m < 255 — Method: a mass given to the nearest 10 g lies within half of 10 g, that is 5 g, of the figure written down. The lower limit is included because it rounds up to that figure, and the upper limit is excluded because it rounds up to the next multiple of 10. Working: 250 − 5 = 245 and 250 + 5 = 255, and a mass of 245 g rounds to 250 g while a mass of 255 g rounds to 260 g. Answer: 245 ≤ m < 255. The distractors: 240 ≤ m < 260 goes a whole 10 g either side instead of half of it; 245 < m ≤ 255 has the two limits the wrong way round; 240 ≤ m < 250 treats the stated 250 g as the largest mass possible, as though rounding were always upwards.
- (a) 4,000 nanometres — Method: the number of nanometres is the diameter divided by the length of one nanometre, and dividing powers of ten means subtracting the indices. Working: −6 − (−9) = 3, so 10⁻⁶ ÷ 10⁻⁹ = 10³, and the diameter is 4 × 10³ nanometres. Answer: 4,000 nanometres. The distractors: 400 nanometres comes from taking the difference between the indices as 2 instead of 3; 4 nanometres comes from changing the name of the unit without converting, leaving the coefficient untouched; 0.004 nanometres comes from dividing by 10³ instead of multiplying by it, as though a nanometre were the larger of the two units.
- (d) 340,000 — 3.4 × 10⁵ means moving the decimal point in 3.4 five places to the right, giving 340,000. Moving it only four places gives 34,000, one place short. Moving it six places gives 3,400,000, one place too many. Treating the exponent as negative instead of positive moves the point the wrong way, giving 0.000034.
Build your own mix at the worksheet builder.