Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 0.36 — Method: convert the fraction to an equivalent fraction with denominator 100, then read off the decimal. Working: 9/25 = 36/100 (multiplying numerator and denominator by 4) = 0.36. Answer: 0.36. 2.8 comes from flipping the fraction and dividing the denominator by the numerator instead: 25 ÷ 9 = 2.77…, rounded to 2.8. 0.925 comes from writing the digits of the numerator and denominator directly after the decimal point without scaling the fraction. 0.9 comes from writing the numerator straight after the decimal point, as if the denominator were 10 rather than 25.
- (d) 17 — 8 ÷ 2 = 4, then 20 − 4 = 16, then 16 + 1 = 17. Stopping after the subtraction and forgetting to add the final 1 leaves 16. Adding the 4 and the 1 together before subtracting gives 4 + 1 = 5, then 20 − 5 = 15 — the subtraction should use the 4 from the division, not a combined total. Working strictly left to right without giving division priority gives 20 − 8 = 12, then 12 ÷ 2 = 6, then 6 + 1 = 7.
- (a) 2/3 — Total parts = 6 + 4 + 5 = 15. Sopranos and altos together are not tenors: 6 + 4 = 10 parts, so the fraction is 10/15, which simplifies to 2/3. 1/3 comes from finding the fraction of tenors instead of the fraction that is not tenors. 2/5 comes from counting only the sopranos as not tenors and leaving the altos out. 4/9 comes from leaving sopranos out of the total, 4 + 5 = 9, and then using only the altos as the fraction that is not tenors.
- (b) 0.6 — Method: convert the fraction to an equivalent fraction with denominator 10, then read off the decimal. Working: 3/5 = 6/10 (multiplying numerator and denominator by 2) = 0.6. Answer: 0.6. 0.35 comes from combining the digits 3 and 5 directly after the decimal point instead of converting the fraction. 0.53 comes from writing the numerator and denominator digits in the wrong order. 1.67 comes from flipping the fraction to 5/3 before converting to a decimal.
- (b) 3.65 ≤ n < 3.75 — Rounding to 1 decimal place means n can be up to half of one decimal place, 0.05, below or above 3.7 before it would round to a different value. This gives a lower bound of 3.7 − 0.05 = 3.65 and an upper bound of 3.7 + 0.05 = 3.75. A value exactly at 3.75 would round up to 3.8, not 3.7, so the upper bound is excluded while the lower bound, 3.65, does still round to 3.7. Writing 3.65 ≤ n ≤ 3.75 wrongly includes 3.75. Writing 3.6 ≤ n < 3.8 uses a whole decimal place, 0.1, either side instead of half of one, 0.05. Writing 3.65 < n < 3.75 wrongly excludes 3.65, which does round to 3.7.
- (a) 7 — Convert the mixed number to an improper fraction: 5 1/4 = 21/4. Dividing by 3/4 means multiplying by its reciprocal, 4/3: 21/4 × 4/3 gives 84/12, which simplifies to 7. So exactly 7 complete pieces of 3/4 m can be cut. Ignoring the 1/4 m and dividing only the whole number, 5 ÷ 3/4, gives 20/3, which is 6 complete pieces with some wood left over. Multiplying by 3/4 instead of its reciprocal, 21/4 × 3/4, gives 63/16, which is 3 complete pieces. Misreading 5 1/4 as the fraction 5/4, then dividing by 3/4, gives 5/3, which is only 1 complete piece. So 7 complete pieces can be cut from the plank.
- (a) 330 ml — Correct to the nearest 20 ml means the true volume could be up to 10 ml (half of 20) either side of 340 ml. The smallest possible volume is 340 − 10 = 330 ml. A candidate who subtracted the full 20 ml instead of half of it worked out 340 − 20 = 320 ml. A candidate who added instead of subtracted, finding the largest possible volume instead of the smallest, worked out 340 + 10 = 350 ml. A candidate who halved the interval again by mistake, using 5 ml instead of 10 ml, worked out 340 − 5 = 335 ml.
- (a) 1,500 ≤ m < 2,500 — Method: a four-digit figure written to 1 significant figure has been rounded to the nearest 1,000, so the mass lies within half of 1,000, that is 500, of the figure given. Working: 2,000 − 500 = 1,500 and 2,000 + 500 = 2,500. The lower limit is included, because 1,500 kg rounds up to 2,000 kg to 1 significant figure, while 2,500 kg rounds up to 3,000 kg, so the upper limit is not. Answer: 1,500 ≤ m < 2,500. The distractors: 1,950 ≤ m < 2,050 comes from rounding to the nearest 100 instead of to 1 significant figure; 1,000 ≤ m < 3,000 goes a whole 1,000 either side instead of half of it; 1,500 < m ≤ 2,500 has the two limits the wrong way round.
- (b) 4 — Method: list the factors of each number and compare them; the highest common factor is the largest number that appears in both lists. Working: the factors of 20 are 1, 2, 4, 5, 10, 20; the factors of 32 are 1, 2, 4, 8, 16, 32. The numbers that appear in both lists are 1, 2 and 4, and the largest of these is 4. 2 is a common factor of 20 and 32 but not the largest one. 8 is a factor of 32 but not of 20, since 20 ÷ 8 is not a whole number. 160 is the lowest common multiple of 20 and 32, not their highest common factor. Answer: 4.
- (b) 2/7 — The comparison asked for is part with part, not part with whole, so the number of cars goes on the bottom. The ratio gives 2 shares of vans for every 7 shares of cars, so the vans are 2/7 of the cars. 2/9 uses the 9 shares in the whole car park as the denominator, 7/2 compares the cars with the vans, and 7/9 is the fraction of the vehicles that are cars.
- (c) 280 — Method: round each number to 1 significant figure, then multiply the rounded numbers. Working: 6.8 rounds to 7 because the next digit is 8, and 41 rounds to 40 because its next digit is 1, so the estimate is 7 × 40 = 280. Answer: 280. The distractors: 240 comes from cutting 6.8 down to 6 instead of rounding it up to 7, giving 6 × 40 = 240; 350 comes from rounding 41 up to 50 when the digit after its first significant figure is less than 5, giving 7 × 50 = 350; 28 comes from multiplying the leading digits only and losing the place value of the 40, which makes the estimate ten times too small.
- (c) 36 — Method: set the outcomes out in a grid with one die along the top and the other down the side, so that every cell of the grid is one outcome, and count the cells. Working: the red die can land in 6 ways, so the grid has 6 columns, and the blue die can also land in 6 ways, so the grid has 6 rows; the number of cells is 6 × 6 = 36. Answer: 36. The distractors: 12 comes from adding 6 and 6 instead of multiplying them; 6 comes from counting the outcomes of a single die and forgetting that the second die also has to land; 21 comes from treating the two dice as indistinguishable, so that a red 2 with a blue 3 and a red 3 with a blue 2 are counted as one outcome.
- (c) 10 — Method: the multiplication is carried out before the subtraction. Working: 4 × 2 = 8, so the calculation becomes 18 − 8 = 10. Answer: 10. The distractors: 28 comes from working from left to right, giving (18 − 4) × 2 = 14 × 2 = 28; −10 comes from subtracting the 18 from the 8 rather than the 8 from the 18, giving 8 − 18 = −10; 12 comes from reading 4 × 2 as 4 + 2 = 6 and then working out 18 − 6 = 12.
- (c) 0.94 — Method: a fraction is written as a decimal by making the denominator a power of ten, because the decimal places record tenths, hundredths and thousandths. Working: 50 × 2 = 100, so the numerator must also be multiplied by 2, giving 47 × 2 = 94 and the equivalent fraction 94/100; 94 hundredths is written with two digits after the decimal point. Answer: 0.94. The distractors: 0.47 comes from treating the denominator as though it were already 100 and writing the digits of the numerator straight after the point; 4.7 comes from dividing 47 by 10 instead of by 50; 0.094 comes from multiplying the denominator by 20 to reach 1000 but the numerator by only 2, giving 94/1000.
- (c) 0.07 — Each digit after the decimal point has a place value: the first digit is tenths, the second is hundredths, the third is thousandths. In 3.472, the 4 is in the tenths place and the 7 is in the hundredths place, so it is worth 0.07. Reading it as 7 ignores place value altogether, treating it as if it were a whole number. Reading it as 0.7 puts it one place too big, in the tenths place. Reading it as 0.007 puts it one place too small, in the thousandths place. The digit 7 in 3.472 is worth 0.07.
Build your own mix at the worksheet builder.