Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) 0.3, 32%, 7/20 — Method: convert every number to a decimal so they can be compared on the same scale. Working: 7/20 = 0.35, 0.3 stays as 0.3, and 32% = 0.32. Comparing 0.3, 0.32 and 0.35 in size gives the order 0.3, then 0.32, then 0.35. Answer: 0.3, 32%, 7/20. 7/20, 32%, 0.3 lists the numbers from largest to smallest instead of smallest to largest. 0.3, 7/20, 32% swaps 32% and 7/20, treating the fraction 7/20 as smaller even though 7/20 = 0.35 is bigger than 32% = 0.32. 32%, 0.3, 7/20 comes from moving the digits one place too far when converting the percentage, giving 0.032 instead of 0.32, which makes 32% look far smaller than it really is.
- (d) −2 — Method: place the two end values on a number line and list the integers that sit strictly between them. Working: reading from left to right the integers run −4, −3, −2, −1, so the values strictly between the ends are −3 and −2. Only one of those is offered. Answer: −2. The distractors: −5 comes from ordering negatives by the size of their digits, which wrongly places −5 to the right of −4; 0 comes from carrying on past −1 instead of stopping at it; 2 comes from ignoring the minus signs and choosing a number between 1 and 4.
- (c) 5 — 0.2 = 1/5, and turning the fraction upside down gives the reciprocal 5/1 = 5. Writing −0.2 mistakes the reciprocal for the negative of the number. Working out 1 − 0.2 = 0.8 mistakes the reciprocal for subtracting the number from 1. Writing 0.5 is the reciprocal of 2, not of 0.2 — a place-value slip that drops the decimal, since 1 ÷ 0.2 = 5 while 1 ÷ 2 = 0.5.
- (b) 750,000,000 — Method: multiplying by 10⁸ moves the decimal point eight places to the right, and every empty place is filled with a zero. Working: 10⁸ = 100,000,000, and moving the decimal point in 7.5 eight places to the right gives 7.5 × 100,000,000. Answer: 750,000,000. The distractors: 7,500,000,000 comes from removing the decimal point first to make 75 and then writing eight zeros after it, which carries the digits one place too far; 600 comes from reading 10⁸ as 10 × 8 = 80 and working out 7.5 × 80; 0.000000075 comes from moving the decimal point eight places to the left, as though the index were negative.
- (b) Yes — the actual mass could be as low as 995 g — Method: a mass shown to the nearest 10 g lies within half of 10 g, that is 5 g, of the figure on the display, so compare the smallest mass the bag can have with the checker's limit of 996 g. Working: 1,000 − 5 = 995, so the actual mass of the bag can be as low as 995 g, and 995 g is below the 996 g limit, so a bag showing 1,000 g on the machine can still be rejected. Answer: Yes — the actual mass could be as low as 995 g. The distractors: 990 g comes from going a whole 10 g below the display instead of half of it; 999.5 g comes from treating the display as being to the nearest gram, when it is to the nearest 10 g; the claim that the mass is exactly 1,000 g treats a rounded display as an exact measurement.
- (a) 2/5 — Method: find the number of vegetable plots in each allotment, add them, then divide by the total number of plots in both allotments. Working: Allotment A: 3/5 × 20 = 12 vegetable plots. Allotment B: 1/5 × 20 = 4 vegetable plots. Total vegetable plots = 12 + 4 = 16. Total plots = 20 + 20 = 40. Fraction = 16/40 = 2/5. Answer: 2/5. 3/10 comes from using only Allotment A's 12 vegetable plots over the combined total of 40 plots, forgetting to add Allotment B's vegetable plots. 1/5 comes from using only Allotment B's ratio (1:4) as the fraction of vegetables, ignoring Allotment A altogether. 3/5 comes from working out the fraction of the combined plots that grow flowers instead of vegetables.
- (d) 3/8 — Method: making half the recipe means dividing the quantity of sugar by 2. Working: 3/4 ÷ 2 = 3/8. Answer: 3/8. 3/2 comes from multiplying by 2 instead of dividing, as if doubling the recipe. 5/4 comes from adding 1/2 to 3/4 instead of halving it, confusing "half of" with "plus a half". 3/4 comes from leaving the amount unchanged, forgetting to halve it for the smaller recipe.
- (c) 9/5 — Method: the area of a rectangle is its length multiplied by its width; the decimal product is then written over a power of ten and cancelled. Working: 24 × 75 = 1800, and 2.4 and 0.75 have three decimal places between them, so 2.4 × 0.75 = 1.8; the area of the panel is 1.8 square metres, which is eighteen tenths, so it can be written as 18/10, and dividing the numerator and the denominator by 2 gives 9 over 5. Answer: 9/5. The distractors: 4/5 comes from converting only the digits after the decimal point and losing the whole one, turning 1.8 into eight tenths; 63/20 comes from adding the two sides instead of multiplying them, giving 3.15; 9/50 comes from misplacing the decimal point in the product and writing 0.18, which cancels to 9 over 50.
- (c) 18 — 45 ÷ 5 = 9, and 2 × 9 = 18. A candidate who stops after finding one fifth gets 9. A candidate who uses 3/5 instead of 2/5 gets 27. A candidate who uses 4/5 instead of 2/5 gets 36.
- (c) 600 — Method: round each number to the nearest 100, then add the rounded values. Working: 113 is nearer to 100 than to 200, so it rounds to 100; 491 is nearer to 500 than to 400, so it rounds to 500; adding those gives the estimate. Answer: 600. The distractors: 500 comes from rounding each number down to the hundred below instead of to the nearest hundred, giving 100 + 400; 700 comes from rounding each number up to the hundred above, giving 200 + 500; 604 is the exact total, worked out in full when the question asks for an estimate.
- (a) 300 N/m² — Pressure is force ÷ area, and the unit N/m² says so: newtons divided by square metres. The calculation is 240 ÷ 0.8. Multiplying both numbers by 10 clears the decimal: 2400 ÷ 8 = 300 N/m². 192 N/m² multiplies the force by the area instead of dividing, 30 N/m² divides by 8 and so loses the decimal point, and 3000 N/m² multiplies only the force by 10 when clearing the decimal.
- (b) 5 — Method: find the square root first, then divide. Working: √225 = 15, and 15 ÷ 3 = 5. Answer: 5. (75 comes from dividing 225 by 3 first and forgetting to take the square root at all. 8.7 comes from dividing 225 by 3 inside the root, √(225 ÷ 3) ≈ 8.7, instead of taking the root first. 45 comes from misreading the divisor as 5 instead of 3, working out 225 ÷ 5 = 45.)
- (d) 36 — To find 3/8 of 96, divide by the denominator and multiply by the numerator: 96 ÷ 8 = 12, and 12 × 3 = 36. Dividing 96 by the numerator instead of the denominator, 96 ÷ 3 = 32, uses the wrong part of the fraction. Using 3/4 instead of 3/8, perhaps misreading the denominator, gives 96 × 3/4 = 72. Finding 96 ÷ 8 = 12 correctly but forgetting to multiply by the numerator 3 leaves just 12 as the final answer.
- (a) 25 — Reverse the operations in reverse order: undo the subtraction by adding 6, then undo the division by multiplying by 5. −1 + 6 = 5, so the number divided by 5 equals 5, and 5 × 5 = 25 — checking, 25 ÷ 5 − 6 = 5 − 6 = −1. A candidate who subtracted 6 again instead of adding worked out −1 − 6 = −7, then −7 × 5 = −35. A candidate who multiplied by 5 before undoing the subtraction, doing the inverse operations in the wrong order, worked out −1 × 5 = −5, then −5 + 6 = 1. A candidate who multiplied by 5 but forgot to undo the subtraction at all worked out −1 × 5 = −5 and stopped there.
- (b) −0.7 < −0.25 — Method: compare the two negative decimals by their distance from zero on a number line. Working: −0.7 is 0.7 away from zero and −0.25 is 0.25 away from zero, so −0.7 is further from zero in the negative direction, making it the smaller number. Answer: −0.7 < −0.25 is true. "−0.7 > −0.25" comes from comparing 0.7 and 0.25 as if both numbers were positive, ignoring the negative signs. "−0.7 = −0.25" comes from assuming the two numbers are equal because they are both negative decimals. "−0.7 ≥ −0.25" combines the false statement "−0.7 > −0.25" with the false statement "−0.7 = −0.25".
Build your own mix at the worksheet builder.