Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) 0.024 cm — Method: significant figures are counted from the first non-zero digit; the zeros in front of it only fix the place value and are not significant. Working: in 0.02384 the first significant figure is 2 and the second is 3, so the rounding is decided by the next digit, 8. As 8 is 5 or more, the second significant figure goes up from 3 to 4, in the same place value. Answer: 0.024 cm. The distractors: 0.023 cm comes from chopping the 84 off instead of rounding it; 0.02 cm comes from counting the leading zeros as significant figures, so the 2 is taken as the second figure and the rounding stops there; 0.0238 cm is 0.02384 correct to 3 significant figures, one figure too many.
- (a) Yes, because 120 ends in 0 — Method: a whole number divides exactly by 5 when its last digit is 5 or 0, so look at the final digit. Working: the final digit of 120 is 0, so 120 is a multiple of 5; the division confirms it, since 5 × 24 = 120 with nothing left over. Answer: Yes, because 120 ends in 0. The distractors: the option that says yes because 120 is even reaches the right conclusion from the wrong test, since being even is the test for divisibility by 2, and 14 is even but is not a multiple of 5; saying no because 5 does not divide into 12 comes from ignoring the final digit and testing only the leading digits; saying no because the digits add to 3 applies the digit-sum test, which works for 3 and for 9 but not for 5.
- (d) 60 — Method: a percentage acts as an operator, so finding 20% of an amount means multiplying it by 20/100, which cancels to 1/5. Working: 20% = 20/100 = 1/5, and 300 ÷ 5 = 60. Answer: 60 seats. The distractors: 15 comes from reading 20% as one twentieth and working out 300 ÷ 20 = 15; 30 comes from finding 10% of 300 and stopping there instead of doubling it; 6 comes from converting 20% to 0.02 rather than 0.2, giving 0.02 × 300 = 6.
- (b) 9/4 — Method: write the whole part as a fraction with the same denominator, then add the fraction part to it. Working: there are 4 quarters in 1 whole, so 2 wholes are 2 × 4 = 8 quarters; adding the 1 quarter that is already there gives 8 + 1 = 9 quarters over a denominator of 4. Answer: 9/4. The distractors: 3/4 comes from adding the whole number to the numerator, as 2 + 1, instead of multiplying it by the denominator first; 7/4 comes from multiplying correctly but then subtracting the numerator, as 2 × 4 − 1; 5/4 comes from multiplying the numerator by the denominator instead of the whole number, as 1 × 4 + 1.
- (b) −2 — Method: the multiplication is carried out before the addition, and a negative multiplied by a positive is negative. Working: (−3) × 4 = −12, so the calculation becomes −12 + 10 = −2. Answer: −2. The distractors: 22 comes from ignoring the minus sign and working out 3 × 4 + 10 = 22; −42 comes from adding before multiplying, giving (4 + 10) × (−3) = 14 × (−3) = −42; −22 comes from adding 12 and 10 and then writing a minus sign in front of the total, instead of moving 10 places up from −12.
- (c) 12 — Method: a square root asks which positive number multiplied by itself gives the number under the root sign. Working: 11 × 11 = 121, which is too small, and 12 × 12 = 144. Answer: 12. The distractors: 14 comes from recalling the wrong square fact, since 14 × 14 = 196; 36 comes from dividing 144 by 4 instead of taking a square root; 72 comes from halving 144, treating a square root as a halving.
- (d) 3/10 — Total parts = 7 + 3 = 10. Gold beads are 3 of those 10 parts, so the fraction is 3/10. 7/10 comes from finding the fraction of red beads instead of gold beads. 7/3 comes from writing the ratio itself as a fraction, without adding the parts to find the total. 3/7 comes from comparing gold beads with red beads instead of with the total number of beads.
- (b) 1 : 2 — 2/5 of 50 is 20, so there are 20 red counters and 50 − 20 = 30 blue counters. Taking 5 red counters out leaves 15 red and 30 blue, so red : blue = 15 : 30. Dividing both parts by 15 gives 1 : 2. 2 : 3 is the ratio before any counters are removed, 2 : 1 has the two parts the wrong way round, and 4 : 5 comes from taking the 5 counters out of the blue instead of the red.
- (a) 12 — Compare the powers of each prime that appears in both factorisations. In 2² × 3² and 2² × 3 × 7, the prime 2 appears with power 2 in both, and the prime 3 appears with power 2 in one and only power 1 in the other — take the lower power, 3¹. Multiplying the shared primes at their lower powers, 2² × 3, gives 12. Using power 1 for both primes instead of comparing the powers properly, 2 × 3, gives 6, which misses that 2 is common at power 2, not power 1. Multiplying the primes at their higher powers and including 7, which only appears in 84, gives 2² × 3² × 7, which comes to 252 — this is the lowest common multiple, not the highest common factor. Only spotting that 3 is a common prime and overlooking that 2 is common as well gives 3. So the highest common factor of 36 and 84 is 12.
- (a) They cannot both be describing the same path — Jon's measurement means the true length, l, satisfies 11.5 m ≤ l < 12.5 m. Mia's measurement means the true length satisfies 12.55 m ≤ l < 12.65 m. These two ranges do not overlap, so the two measurements cannot both be describing the same path. 'They must both be describing the same path' ignores that the two ranges do not overlap at all. 'Jon's measurement must be wrong' wrongly assumes Jon is the one at fault, when the mismatch does not show which measurement, if either, is wrong. 'Mia's measurement must be wrong' makes the same unjustified assumption in the other direction.
- (a) 14 — Multiply both numbers by 10 to clear the decimals: 8.4 becomes 84 and 0.6 becomes 6. Then divide: 84 ÷ 6 = 14, so 14 complete pieces can be cut. Scaling only the divisor by 10 and leaving the dividend as 8.4 gives 8.4 ÷ 6 = 1.4, which rounds down to 1 complete piece — the dividend was never converted. Scaling only the dividend by 10 and leaving the divisor as 0.6 gives 84 ÷ 0.6 = 140. Rounding the divisor from 0.6 to 0.7 before dividing, trading accuracy for a rounder number, gives 8.4 ÷ 0.7 = 12. So 14 complete pieces of ribbon can be cut.
- (c) 2000 mm — Put both lengths into the same unit first. There are 1000 mm in a metre, so the ribbon is 2.4 × 1000 = 2400 mm, and there are 10 mm in a centimetre, so the piece cut off is 40 × 10 = 400 mm. The length left is 2400 − 400 = 2000 mm. 2360 mm subtracts 40 mm instead of 400 mm, 200 mm works in centimetres and then labels the result as millimetres, and 2800 mm adds the piece that was cut off instead of subtracting it.
- (a) 5 — Method: each index is worked out first, and subtracting a negative number is the same as adding the positive. Working: (−2)³ = (−2) × (−2) × (−2) = −8 and (−3)² = (−3) × (−3) = 9, while − (−4) becomes + 4, so the calculation becomes −8 + 9 + 4 = 5. Answer: 5. The distractors: −13 comes from taking (−3)² as −9, giving −8 − 9 + 4 = −13; −3 comes from reading − (−4) as − 4, giving −8 + 9 − 4 = −3; 21 comes from treating every power of a negative number as positive, so that (−2)³ is taken as 8 and the calculation becomes 8 + 9 + 4 = 21.
- (b) Yes — the actual mass could be as low as 995 g — Method: a mass shown to the nearest 10 g lies within half of 10 g, that is 5 g, of the figure on the display, so compare the smallest mass the bag can have with the checker's limit of 996 g. Working: 1,000 − 5 = 995, so the actual mass of the bag can be as low as 995 g, and 995 g is below the 996 g limit, so a bag showing 1,000 g on the machine can still be rejected. Answer: Yes — the actual mass could be as low as 995 g. The distractors: 990 g comes from going a whole 10 g below the display instead of half of it; 999.5 g comes from treating the display as being to the nearest gram, when it is to the nearest 10 g; the claim that the mass is exactly 1,000 g treats a rounded display as an exact measurement.
- (c) −2 — On a number line, negative numbers get smaller as their size (ignoring the sign) gets bigger, so −2 is closest to zero and is the largest of the four. A candidate who ignores the negative signs and orders the numbers as if they were positive, largest digit first, would pick −9 as the 'largest'. Continuing that same reversed ranking, the next number in digit order is −7. The number one step further along that same reversed ranking is −4, still short of the true largest value, −2.
Build your own mix at the worksheet builder.