Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 1/4 — A negative index means the reciprocal of the positive power, so 2⁻² = 1 ÷ 2² = 1/4. Treating the negative sign as making the answer negative instead gives −(2²) = −4. Ignoring the negative sign altogether gives just 2² = 4. Finding the reciprocal correctly but then also applying a negative sign gives −1/4.
- (d) −8, −3, 0, 2, 5 — Method: place the numbers on a number line and read them from left to right. Working: the negative numbers −8 and −3 come before 0, with −8 further left than −3 because it is further from zero in the negative direction; then 0, then the positive numbers 2 and 5 in increasing size. Answer: −8, −3, 0, 2, 5. −3, −8, 0, 2, 5 swaps −3 and −8, putting the negative number closer to zero first. 5, 2, 0, −3, −8 lists the numbers from largest to smallest instead of smallest to largest. −8, −3, 2, 0, 5 puts 2 before 0, treating positive numbers as if they always come before zero.
- (d) 1,000 — Method: round each number to 1 significant figure, then multiply the rounded values. Working: 49 rounds to 50 and 21 rounds to 20, and 50 × 20 = 1,000 because 5 × 2 = 10 and the two rounded numbers carry one zero each. Answer: 1,000. The distractors: 800 comes from rounding 49 down to 40 instead of to the nearest ten; 1,500 comes from rounding 21 up to 30 rather than down to 20; 1,029 is the exact product 49 × 21, worked out in full when the question asks for an estimate.
- (c) 6 — Method: the first significant figure is the first non-zero digit; round using the digit after it to decide whether to round up or down. Working: the first significant figure of 6.283 is the 6; the next digit is 2, which rounds down, so 6.283 rounds to 6. 6.3 comes from rounding to 2 significant figures instead of 1. 10 comes from rounding up to the nearest 10 instead of finding 1 significant figure of the number itself. 0.6 comes from misplacing the decimal point after rounding. Answer: 6.
- (a) The tape can only give the length to the nearest centimetre — Method: a measurement should never be written to a finer degree of accuracy than the instrument used can read. Working: the tape is marked in centimetres, so the smallest division Leah can read is 1 cm, which is 0.01 m and two decimal places in metres; writing 7.3157 m claims the length to the nearest tenth of a millimetre, four decimal places, which the markings cannot support. A record of 7.32 m, to the nearest centimetre, is what this tape justifies. Answer: The tape can only give the length to the nearest centimetre. The distractors: the nearest millimetre contradicts the markings described in the question, which are centimetres, and would still claim more accuracy than the tape offers; the rule that a length in metres must be written to 2 decimal places borrows the habit of writing money to the penny, when the accuracy of a length depends on the instrument; rounding to the nearest metre would throw away accuracy the tape genuinely provides.
- (c) −1 — Method: find each cube root separately, keeping its sign, and then add the two results. Working: (−3) × (−3) × (−3) = −27, so ∛(−27) = −3, and 2 × 2 × 2 = 8, so ∛8 = 2. Adding gives −3 + 2 = −1. Answer: −1. The distractors: 5 comes from taking the cube root of a negative number as positive, giving 3 + 2; −5 comes from reading the minus sign as applying to the whole sum and working out −(3 + 2); −6 comes from multiplying the two roots, −3 × 2, instead of adding them.
- (a) 20 — Method: round each number to 1 significant figure, then divide. Working: 397 rounds to 400 and 21 rounds to 20, so the estimate is 400 ÷ 20 = 20. Answer: 20. The distractors: 19 comes from not estimating at all, since 397 ÷ 21 = 18.9 to 1 decimal place, which rounds to 19, while the question asks for an estimate from rounded numbers; 200 comes from dividing 400 by 2 instead of by 20, losing the place value of the rounded divisor; 2 comes from dividing the leading digits only and losing the place value of both numbers.
- (d) 60 mph — Average speed = distance ÷ time, with the time measured in hours. 45 minutes is 45/60 of an hour, which is 0.75 of an hour, so the journey takes 1.75 hours. Speed = 105 ÷ 1.75 = 60 mph. 52.5 mph rounds the time up to 2 hours, 72.4 mph writes 1 hour 45 minutes as 1.45 hours, and 183.75 mph multiplies the distance by the time instead of dividing.
- (b) 2/7 — The comparison asked for is part with part, not part with whole, so the number of cars goes on the bottom. The ratio gives 2 shares of vans for every 7 shares of cars, so the vans are 2/7 of the cars. 2/9 uses the 9 shares in the whole car park as the denominator, 7/2 compares the cars with the vans, and 7/9 is the fraction of the vehicles that are cars.
- (c) 31 — Method: work out each power separately, remembering that any non-zero base raised to the power 0 is 1 and a base raised to the power 1 is itself, then add the three values. Working: 5⁰ = 1, 5¹ = 5 and 5² = 25, so the total is 1 + 5 + 25 = 31. Answer: 31. The distractors: 30 comes from taking 5⁰ as 0 instead of 1; 35 comes from taking 5⁰ as 5, treating a zero index as leaving the base unchanged; 125 comes from adding the indices first, as though the three terms were being multiplied, and working out 5³.
- (c) −5 ≤ −5 — The symbol ≤ means 'less than or equal to', and −5 is equal to −5, so this statement is true. −3 ≥ −1 is false: a candidate who ignores the negative signs and compares 3 with 1 would wrongly think −3 is the bigger number, but on the number line −3 is smaller than −1. 0.4 < 2/5 is false because 2/5 converts to exactly 0.4, so the two values are equal, not one strictly less than the other — a candidate who assumes a fraction is automatically bigger than a similar-looking decimal without converting it would miss this. 7/10 ≤ 0.6 is false because 7/10 converts to 0.7, which is bigger than 0.6; a candidate who misplaces the decimal point and converts 7/10 as 0.07 would wrongly believe this statement is true.
- (b) 2² × 3 × 5 — Repeatedly divide 60 by prime numbers: 60 ÷ 2 = 30, 30 ÷ 2 = 15, 15 ÷ 3 = 5, and 5 is itself prime. So 60 is 2 × 2 × 3 × 5, which in index notation is 2² × 3 × 5. Stopping the factor tree after only three divisions and writing 2 × 3 × 5 misses that the 2 divides in twice, and gives only 30, not 60. Squaring the 3 as well as the 2 gives 2² × 3² × 5, which comes to 180, far too big. Squaring the 5 instead of the 2 gives 2 × 3 × 5², which comes to 150, also too big. So 60 = 2² × 3 × 5.
- (b) 25 — Method: check the calculator answer by following the order of operations — each power is worked out before the addition. Working: 4² = 4 × 4 = 16 and 3² = 3 × 3 = 9, and 16 + 9 = 25. Answer: 25. The distractors: 49 is the value Freya wrote down and comes from adding first and then squaring, working out (4 + 3)² instead of 4² + 3²; 14 comes from doubling each number instead of squaring it, adding 8 and 6; 12 comes from multiplying 4 by 3 instead of squaring each number and adding the results.
- (a) 7.2 × 10⁻⁴ — 0.00072 = 7.2 × 10⁻⁴, moving the decimal point 4 places to the right to reach 7.2, so the exponent is negative. Writing 7.2 × 10⁴ uses a positive exponent, which would give a number far larger than 1, not a small decimal. Writing 7.2 × 10⁻⁵ moves the point one place too many. Writing 0.72 × 10⁻³ leaves the coefficient below 1, which standard form does not allow.
- (c) 2.6 × 10⁵ — In standard form, A must satisfy 1 ≤ A < 10. Moving the decimal point in 260,000 to just after the 2 gives A = 2.6, and the decimal point moved 5 places, so 260,000 = 2.6 × 10⁵. A candidate who wrote 26 × 10⁴ used a value of A outside the required range, even though it has the same overall value. A candidate who wrote 2.6 × 10⁶ counted one place too many when moving the decimal point. A candidate who wrote 0.26 × 10⁶ used a value of A below 1, again outside the required range.
Build your own mix at the worksheet builder.