Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 5 × 10⁻³ — Method: in standard form the coefficient must be at least 1 and less than 10, and for a number smaller than 1 the index is negative and counts the places the decimal point moves to the right. Working: the only significant digit is 5, so the coefficient is 5; moving the decimal point in 0.005 three places to the right gives 5, so the index is −3. Answer: 5 × 10⁻³. The distractors: 0.5 × 10⁻² is the same value written the wrong way, because 0.5 is smaller than 1 and so is not an allowed coefficient; 5 × 10⁻² comes from counting the two zeros after the decimal point instead of the three places the point moves; 5 × 10³ comes from taking the index as positive, which describes a number in the thousands rather than one smaller than 1.
- (a) 7.5 × 10⁴ — Standard form is A × 10ⁿ, where A is between 1 and 10 (1 ≤ A < 10) and n is an integer — 7.5 × 10⁴ satisfies all of this. 12 × 10³ fails because 12 is not below 10. 0.5 × 10⁴ fails because 0.5 is not at least 1. 6.2 × 4⁵ fails because standard form always uses a power of 10, not a power of 4.
- (a) 2 — Method: systematically try each possible number of 20p coins, starting from one, and check whether the amount left over can be made exactly using whole 10p coins. Working: one 20p coin leaves 40p, made from four 10p coins — valid. Two 20p coins leave 20p, made from two 10p coins — valid. Three 20p coins leave 0p, which needs zero 10p coins — not valid, since at least one 10p coin is required. So there are 2 different ways. Answer: 2. 3 comes from counting the case of three 20p coins and no 10p coins as if it were allowed, even though at least one 10p coin is required. 4 comes from ignoring the 'at least one of each' condition altogether and counting every way of making 60p, including three 20p coins with no 10p coins and six 10p coins with no 20p coins. 1 comes from finding only one of the two valid combinations and stopping the systematic list too early.
- (a) 40 — Multiply the number of choices for each item: 4 × 5 × 2 = 40. 11 comes from adding the three numbers instead of multiplying them. 20 comes from multiplying only the crisps and chocolate bars, 4 × 5, and forgetting the drink. 10 comes from multiplying only the chocolate bars and drinks, 5 × 2, and forgetting the crisps.
- (a) 2 × 3² × 5 — Method: divide repeatedly by the smallest prime number until only prime factors remain. Working: 90 ÷ 2 = 45, 45 ÷ 3 = 15, 15 ÷ 3 = 5, and 5 is prime, so 90 = 2 × 3 × 3 × 5, written as 2 × 3² × 5. 2 × 3 × 15 stops before the 15 is broken down into 3 × 5, so it is not fully factorised. 3 × 3 × 10 stops before the 10 is broken down into 2 × 5. 2 × 45 stops after only one division. Answer: 2 × 3² × 5.
- (a) 1/2, 3/5, 2/3, 5/6 — Convert all four fractions to a common denominator of 30: 2/3 is 20/30, 3/5 is 18/30, 5/6 is 25/30, and 1/2 is 15/30. Ordering by these numerators, smallest to largest, gives 15/30, 18/30, 20/30, 25/30, which is 1/2, 3/5, 2/3, 5/6. Ordering by the size of the numerator in the original fractions, 1, 2, 3, 5, rather than converting to a common denominator, gives the wrong order 1/2, 2/3, 3/5, 5/6, because it ignores that the denominators are different. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 5/6, 2/3, 3/5, 1/2. Using the rule "the bigger the denominator, the smaller the fraction" to place the last two, so that 5/6 is put below 2/3 because 6 is bigger than 3, gives 1/2, 3/5, 5/6, 2/3 — that rule only holds when the numerators are the same, and here 20/30 really is smaller than 25/30. So the correct order, smallest to largest, is 1/2, 3/5, 2/3, 5/6.
- (d) £143 — From 09:15 to 12:45 is 3 hours 30 minutes, which is 3.5 hours. The charge for the time is 3.5 × £28 = £98, and the call-out fee is added on once: £98 + £45 = £143. £98 leaves out the call-out fee altogether, £129 charges for 3 hours instead of 3.5 hours, and £255.50 adds the fee to the hourly rate before multiplying, which charges the £45 for every hour.
- (d) 1/4 — Method: count the digits after the decimal point to choose a denominator that is a power of ten, then cancel the fraction by the highest common factor of the numerator and the denominator. Working: 0.25 has two digits after the point, so 0.25 is 25 hundredths and can be written as 25/100; the highest common factor of 25 and 100 is 25, and 25 ÷ 25 = 1 with 100 ÷ 25 = 4. Answer: 1/4. The distractors: 2/5 comes from reading the two digits after the point as a numerator and a denominator and writing 2 over 5; 1/25 comes from putting 1 over the digits after the point, as though 0.25 meant one twenty-fifth; 1/40 comes from miscounting the decimal places and using a denominator of 1000, giving 25/1000, which cancels by 25 to 1/40.
- (c) 9/10 — Method: write the decimal over 10 using its one decimal place. Working: 0.9 = 9/10, which is already in its simplest form since 9 and 10 share no common factor. Answer: 9/10. The student's fraction, 9/100, comes from always writing the denominator as 100, regardless of how many decimal places the number actually has. 9 comes from dropping the decimal point altogether and treating 0.9 as the whole number 9. 1/9 comes from flipping the correct fraction upside down.
- (c) 0.024 — Multiply the digits ignoring the decimal points: 6 × 4 = 24. Count the total number of decimal places in the two numbers being multiplied: 0.6 has 1 decimal place and 0.04 has 2, giving 3 in total. Place the decimal point in 24 so that there are 3 digits after it: 0.024. Counting only 2 decimal places instead of 3 gives 0.24. Counting 4 decimal places instead of 3 gives 0.0024. Counting only 1 decimal place instead of 3 — in effect moving the point in just one of the two numbers, as if the calculation were 6 × 0.4 — gives 2.4. So 0.6 × 0.04 = 0.024.
- (c) 5 — 0.2 = 1/5, and turning the fraction upside down gives the reciprocal 5/1 = 5. Writing −0.2 mistakes the reciprocal for the negative of the number. Working out 1 − 0.2 = 0.8 mistakes the reciprocal for subtracting the number from 1. Writing 0.5 is the reciprocal of 2, not of 0.2 — a place-value slip that drops the decimal, since 1 ÷ 0.2 = 5 while 1 ÷ 2 = 0.5.
- (c) 3.95 — The digit after the second decimal place is 7, which is 5 or more, so round the second decimal place up: 3.947 rounds to 3.95. A candidate who truncated instead of rounding, simply cutting off after 2 decimal places, wrote 3.94. A candidate who rounded to 1 decimal place instead of 2 wrote 3.9. A candidate who rounded up but mishandled the carry wrote 4.0.
- (c) 0.0065 — Leading zeros are never significant, so counting from the first non-zero digit, the first two significant figures of 0.006482 are 6 and 4. Look at the next digit along, 8, to decide whether the second figure rounds up: since 8 is 5 or more, the 4 rounds up to 5, giving 0.0065. Rounding to 2 decimal places instead of 2 significant figures gives 0.01, which answers a different question. Wrongly counting one of the leading zeros as a significant figure and stopping one figure short gives 0.006. Keeping an extra digit, as in 0.00648, gives 3 significant figures rather than 2.
- (c) 2/5 — To find a fraction of a fraction, multiply them together: 3/5 × 2/3 = 6/15, which simplifies to 2/5. Multiplying only the numerators, 3 × 2 = 6, but adding the denominators, 5 + 3 = 8, instead of multiplying them gives 6/8, which simplifies to 3/4. Using only the fraction who study French, 3/5, and ignoring that a further fraction of them also study Spanish gives 3/5. Dividing by 2/3 instead of multiplying by it, using its reciprocal 3/2, gives 3/5 × 3/2 = 9/10.
- (b) 1.45 ≤ m < 1.55 — The flour's mass is labelled 1.5 kg, correct to the nearest 0.1 kg, so half of 0.1 kg is added to and subtracted from 1.5 kg to find the interval: 1.5 − 0.05 = 1.45 and 1.5 + 0.05 = 1.55, giving 1.45 ≤ m < 1.55. '1.4 ≤ m < 1.6' comes from taking the whole 0.1 kg as the margin either side, instead of half of it. '1.45 < m ≤ 1.55' comes from writing the inequality signs the wrong way round — the lower bound should be included and the upper bound excluded, not the other way round. '1.45 ≤ m ≤ 1.55' comes from including the upper bound, when the convention is that the upper bound is never actually reached.
Build your own mix at the worksheet builder.