Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) 3 — Method: list all valid two-digit numbers that can be made without starting with 0, then keep only the ones that are multiples of 5. Working: the two-digit numbers possible are 30, 35, 50 and 53. A number is a multiple of 5 only if it ends in 0 or 5: 30 ends in 0, 35 ends in 5, 50 ends in 0, but 53 ends in 3. So there are 3 multiples of 5. Answer: 3. 4 comes from including 53 as a multiple of 5 without checking that its last digit is not 0 or 5. 2 comes from leaving out 50, wrongly assuming 0 cannot be used as the second digit either. 6 comes from listing every two-digit arrangement of the three digits, including ones that start with 0, without applying either restriction.
- (a) 12 — Method: for any two numbers, their highest common factor multiplied by their lowest common multiple equals the product of the two numbers. This holds because the HCF collects every prime factor the two numbers share, and the LCM collects every prime factor that appears in either number, so between them they use each prime factor of the two numbers exactly once — the same primes as the product. Working: 4 × 60 = 240, and 240 ÷ 20 = 12. 15 comes from working out 60 ÷ 4 = 15, dividing the wrong pair of numbers. 16 comes from working out 20 − 4 = 16, subtracting the highest common factor instead of using the product rule. 240 is 4 × 60, the product of the highest common factor and the lowest common multiple, left un-divided by 20. Answer: 12.
- (c) 2 — First write 1 1/2 as an improper fraction, 3/2. To divide by 3/4, multiply by its reciprocal, 4/3: 3/2 × 4/3 = 12/6 = 2. Dropping the whole number and dividing only the fractional part, 1/2 ÷ 3/4 = 1/2 × 4/3, gives 2/3. Multiplying by 3/4 directly instead of using its reciprocal, 3/2 × 3/4, gives 9/8. Using the reciprocal of the first fraction instead of the second, 2/3 × 3/4, gives 1/2.
- (b) 3/50 — Method: write the decimal over the power of ten that matches the number of digits after the point, counting every digit including a zero, then divide the numerator and the denominator by their highest common factor. Working: 0.06 has two digits after the point, so it is 6 hundredths and can be written as 6/100; the highest common factor of 6 and 100 is 2, and 6 ÷ 2 = 3 with 100 ÷ 2 = 50. Answer: 3/50. The distractors: 3/5 comes from ignoring the zero straight after the point and converting 0.6 instead, giving 6/10, which cancels to 3/5; 3/500 comes from counting three decimal places instead of two and writing 6/1000, which cancels to 3/500; 1/6 comes from putting 1 over the digits after the point, as though 0.06 meant one sixth.
- (a) 36 — Method: for the highest common factor, take the LOWER power of each prime that appears in both numbers. Working: for 2, the lower power is 2² (from 108); for 3, the lower power is 3² (from 72), so the highest common factor is 2² × 3² = 4 × 9 = 36. 216 comes from taking the higher power of each prime instead, 2³ × 3³ = 8 × 27 = 216, which gives the lowest common multiple, not the highest common factor. 108 is simply one of the two numbers, not their highest common factor. 6 comes from multiplying the primes without any powers at all, 2 × 3 = 6. Answer: 36.
- (d) 8 — Method: the square root of a number is the value that multiplies by itself to give that number. Working: 8 × 8 = 64, so √64 = 8. 32 comes from working out 64 ÷ 2 = 32, halving the number instead of finding its square root. 4 is the cube root of 64, since 4 × 4 × 4 = 64, not the square root. 16 comes from working out 8 × 2 = 16, doubling the correct answer by mistake. Answer: 8.
- (a) x⁶ — Method: work through the powers in order — multiplying powers of the same base means adding indices, and dividing powers of the same base means subtracting indices. Working: first, x⁵ × x³ = x⁸ (adding 5 and 3); then x⁸ ÷ x² = x⁶ (subtracting 2 from 8). x⁴ comes from swapping the two rules — subtracting for the multiplication, 5 − 3 = 2, and then adding for the division, 2 + 2 = 4. x¹⁰ comes from adding all three indices, 5 + 3 + 2 = 10, treating the division the same as a multiplication. 6x comes from correctly reaching a total index of 6 but then writing it as a coefficient of x instead of as its power. Answer: x⁶.
- (b) 1 — Any non-zero number raised to the power 0 equals 1, so 7⁰ = 1. Writing 0 confuses this rule with multiplying by zero. Writing 7 mistakes the power of 0 for leaving the base unchanged, as if nothing happened. Writing 1/7 confuses the zero index with a negative one — it is 7⁻¹ that equals 1/7, while 7⁰ equals 1.
- (b) 9/25 — Method: write the decimal over the matching power of ten, then divide the numerator and the denominator by their highest common factor. Working: 0.36 has two digits after the point, so 0.36 = 36/100; the highest common factor of 36 and 100 is 4, and 36 ÷ 4 = 9 with 100 ÷ 4 = 25; since 9 and 25 share no factor greater than 1, the fraction is fully cancelled. Answer: 9/25. The distractors: 3/10 comes from reading only the first digit after the point and converting 0.3; 9/50 comes from dividing the numerator by 4 but the denominator by only 2; 36/10 comes from counting one decimal place instead of two and writing the digits over 10.
- (b) 18.5 ≤ T < 18.7 — Method: the error interval reaches half the rounding unit either side of the recorded value. Working: half of 0.2 is 0.1, so the interval runs from 18.6 − 0.1 to 18.6 + 0.1. Answer: 18.5 ≤ T < 18.7. (18.4 ≤ T < 18.8 comes from using the full rounding unit, 0.2, either side instead of half of it. 18.5 ≤ T ≤ 18.7 comes from including the upper bound with ≤ instead of excluding it with <. 18.6 ≤ T < 18.8 comes from treating the recorded value as the start of the interval and adding the whole rounding unit, 0.2, above it.)
- (a) 7 — Method: BIDMAS deals with the index first, then the multiplication, then the subtraction. Working: (−2)² = (−2) × (−2) = 4, then 3 × 4 = 12, and finally 12 − 5 = 7. Answer: 7. The distractors: −17 comes from squaring only the 2 and keeping the minus sign, giving 3 × (−4) = −12 and then −12 − 5 = −17; 31 comes from multiplying before applying the index, giving (3 × (−2))² = (−6)² = 36 and then 36 − 5 = 31; −3 comes from carrying out the subtraction before the multiplication, giving 3 × (4 − 5) = 3 × (−1) = −3.
- (d) 10 — Method: picking 3 flowers from 5 leaves 2 flowers behind, so counting the different pairs that could be left out counts the bunches, and those pairs can be listed systematically. Working: number the flowers 1 to 5; the first flower can be left out alongside any of the 4 flowers after it, the second alongside any of the 3 after it, the third alongside any of the 2 after it and the fourth alongside the last one, so the number of pairs left out is 4 + 3 + 2 + 1 = 10. Answer: 10. The distractors: 60 comes from working out 5 × 4 × 3 and treating the three picks as an ordered selection when the order does not matter; 30 comes from dividing that product by 2 instead of by the 6 orders in which three chosen flowers could have been picked; 15 comes from multiplying the 5 flowers by the 3 flowers picked instead of counting the selections.
- (d) 7/20 — Method: write the decimal over the power of ten that matches the number of digits after the point, then divide the numerator and the denominator by their highest common factor. Working: 0.35 has two digits after the point, so it is 35 hundredths and can be written as 35/100; the highest common factor of 35 and 100 is 5, and 35 ÷ 5 = 7 with 100 ÷ 5 = 20. Answer: 7/20. The distractors: 3/10 comes from reading only the first digit after the point and converting 0.3; 7/25 comes from dividing the numerator by 5 but the denominator by 4, using a different factor on the top and on the bottom; 35/10 comes from counting one decimal place instead of two and writing the digits over 10.
- (d) 4 13/15 — Convert to fifteenths: 1/5 is equivalent to 3/15 (multiply by 3/3), and 2/3 is equivalent to 10/15 (multiply by 5/5), so 3 1/5 is equivalent to 3 3/15 and 1 2/3 is equivalent to 1 10/15. Add the whole numbers (3 + 1 = 4) and the fractions (3/15 + 10/15 = 13/15), giving 4 13/15. A candidate who adds the numerators and denominators straight across, treating 1/5 + 2/3 as (1+2)/(5+3), gets a fraction part of 3/8, giving 4 3/8. A candidate who adds the fraction parts correctly but forgets to add the second whole number gets 3 13/15. A candidate who adds the whole numbers but copies the first fraction across without ever adding 2/3 to it gets 4 1/5.
- (d) −1.7 — Since the numbers have different signs, find the difference between their sizes: 4.5 − 2.8 = 1.7, then keep the sign of the number further from zero. So −4.5 + 2.8 = −1.7. A candidate who drops the negative sign gets 1.7. A candidate who adds the magnitudes instead of finding the difference gets −(4.5 + 2.8) = −7.3. A candidate who takes the smaller digit from the larger in the tenths column, doing 8 − 5 = 3 instead of borrowing to make 15 − 8 = 7, gets 2.3 and so −2.3.
Build your own mix at the worksheet builder.