Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) £6 — 10% of £40 is £4, and 5% of £40 is half of that, £2. Adding these gives 15% of £40 = £4 + £2 = £6. Finding only the 10% part and stopping there gives £4. Finding only the 5% part and stopping there gives £2. Multiplying 40 by 15 without dividing by 100 gives £600, which treats the percentage as if it were a whole number multiplier.
- (a) 2/5 — The ratio 2:3 has 2 + 3 = 5 parts in total, and the larger plot is 3 of those parts. Since the larger plot is 18 m², each part is 18 ÷ 3 = 6 m², so the total area is 5 × 6 = 30 m² and the smaller plot is 2 × 6 = 12 m². The fraction of the total area taken up by the smaller plot is 12/30, which simplifies to 2/5. Giving the fraction for the larger plot instead of the smaller one gives 3/5. Comparing the smaller plot to the larger plot instead of to the total area gives 2/3. Assuming the two plots split the area evenly, ignoring the given ratio altogether, gives 1/2.
- (c) 0.0065 — Leading zeros are never significant, so counting from the first non-zero digit, the first two significant figures of 0.006482 are 6 and 4. Look at the next digit along, 8, to decide whether the second figure rounds up: since 8 is 5 or more, the 4 rounds up to 5, giving 0.0065. Rounding to 2 decimal places instead of 2 significant figures gives 0.01, which answers a different question. Wrongly counting one of the leading zeros as a significant figure and stopping one figure short gives 0.006. Keeping an extra digit, as in 0.00648, gives 3 significant figures rather than 2.
- (b) 14 — Method: the greatest number of identical rows is the highest common factor of the two bulb totals, found by taking every prime factor the two totals share. Working: 42 = 2 × 3 × 7 and 56 = 2 × 2 × 2 × 7, so the prime factors common to both are 2 and 7, giving a highest common factor of 2 × 7 = 14. 2 comes from taking only the common factor 2 and forgetting the common factor 7. 7 comes from taking only the common factor 7 and forgetting the common factor 2. 168 is the lowest common multiple of 42 and 56, not their highest common factor. Answer: 14.
- (a) 3/13 — Vegetables are 9 of the 9 + 4 = 13 parts, so vegetables are 9/13 of the plot. Potatoes are a third of the vegetable section, so potatoes are 1/3 of 9/13, which is 9/39, simplifying to 3/13, of the whole plot. 9/13 comes from stopping after finding the fraction of the plot that is vegetables, without taking the further third for potatoes. 1/3 gives the fraction of the vegetable section that is potatoes, not the fraction of the whole plot. 4/39 comes from taking a third of the flowers' fraction, 4/13, instead of the vegetables' fraction.
- (d) 2³ × 5² — Method: divide repeatedly by the smallest prime number, then write any repeated prime using a power. Working: 200 ÷ 2 = 100, 100 ÷ 2 = 50, 50 ÷ 2 = 25, 25 ÷ 5 = 5, and 5 is prime, so 200 = 2 × 2 × 2 × 5 × 5, written as 2³ × 5². 2² × 5³ swaps the two powers, giving 4 × 125 = 500, not 200. 2³ × 5 leaves out one of the two 5s, giving 8 × 5 = 40, not 200. 2 × 5³ leaves out two of the three 2s, giving 2 × 125 = 250, not 200. Answer: 2³ × 5².
- (c) 12.3 ≤ t < 12.4 — Method: truncating cuts the later digits off instead of rounding them, so nothing is ever pushed upwards. The displayed value is therefore the smallest the time can be, and the time can run up to, but not reach, the next value the display can show. Working: the display reads 12.3, so the actual time is at least 12.3 seconds; as soon as the time reaches 12.3 + 0.1 = 12.4 seconds the display would read 12.4, so 12.4 is not included. Answer: 12.3 ≤ t < 12.4. The distractors: 12.25 ≤ t < 12.35 is the interval for a time rounded to 1 decimal place, and this display does not round; 12.3 < t ≤ 12.4 excludes the one value the display certainly allows and includes the one it rules out; 12.3 ≤ t ≤ 12.4 treats 12.4 seconds as possible, but at 12.4 seconds the display would no longer read 12.3.
- (a) 30 cm — The tile's side length must be a common factor of 90 and 120. The factors of 90 include 1, 2, 3, 5, 6, 9, 10, 15, 18, 30, 45, 90; the factors of 120 include 1, 2, 3, 4, 5, 6, 8, 10, 12, 15, 20, 24, 30, 40, 60, 120. The highest number common to both lists is 30, so the largest square tile has a side length of 30 cm. Picking 15 cm, a common factor but not the largest, gives tiles that are smaller than necessary. Picking 10 cm, also a common factor but smaller still, wastes even more of the possible tile size. Working out the lowest common multiple instead of the highest common factor gives 360 cm, a length far bigger than either side of the patio. So the largest square tile Ben can use has a side length of 30 cm.
- (d) 25,000 — Method: to round to the nearest 1,000, look at the hundreds digit; 5 or more sends the thousands digit up, less than 5 leaves it where it is, and every digit below the thousands becomes zero. Working: 24,681 has 4 in the thousands place and 6 in the hundreds place. As 6 is 5 or more, the 4 thousands go up to 5 thousands and the hundreds, tens and units are replaced by zeros. Answer: 25,000. The distractors: 24,000 comes from cutting the last three digits off instead of rounding, which leaves the thousands digit untouched; 24,700 is 24,681 rounded to the nearest 100, a finer degree of accuracy than the question asks for; 20,000 is 24,681 rounded to the nearest 10,000, a coarser degree of accuracy.
- (a) −22 — Method: both multiplications are carried out before the addition, and a positive multiplied by a negative is negative. Working: (−3) × 4 = −12 and 2 × (−5) = −10, so the calculation becomes −12 + (−10) = −22. Answer: −22. The distractors: 22 comes from ignoring the minus signs and working out 3 × 4 + 2 × 5 = 22; 50 comes from working from left to right with no priority at all, giving −12 + 2 = −10 and then −10 × (−5) = 50; −2 comes from taking 2 × (−5) as +10, so that −12 + 10 = −2.
- (c) −5 — Method: the bracket is worked out first, then the multiplication and the division, which stand as separate parts, and the subtraction that joins them is carried out last; subtracting a negative is the same as adding. Working: (−3) + 5 = 2, so the product is 2 × (−4) = −8; the division gives (−6) ÷ 2 = −3; joining them gives −8 − (−3) = −8 + 3 = −5. Answer: −5. The distractors: −11 comes from taking away 3 instead of taking away −3, giving −8 − 3 = −11; −1 comes from working from left to right once the bracket is done, giving −8 − (−6) = −2 and then −2 ÷ 2 = −1; 11 comes from treating the first product as positive because it was worked out from a bracket, giving 8 − (−3) = 11.
- (d) 10π cm — Method: for a circle, circumference = π × diameter. Working: circumference = π × 10 = 10π cm. Answer: 10π cm. 20π cm comes from using the formula 2 × π × radius but plugging in the diameter as if it were the radius: 2 × π × 10 = 20π. 25π cm comes from confusing circumference with area, using π × radius² with radius 5: π × 5² = 25π. 5π cm comes from halving the diameter and then multiplying by π, as if circumference were π × radius: π × 5 = 5π.
- (b) No — their possible jump lengths do not overlap — Method: each recorded jump stands for the lengths within half of 0.1 m, that is 0.05 m, of the figure recorded, and Priya is right only if the two ranges overlap. Working: Priya's jump is at least 3.8 − 0.05 = 3.75 m and below 3.85 m, because a jump of 3.85 m would have been recorded as 3.9 m; Nadia's jump is at least 3.85 m and below 3.9 + 0.05 = 3.95 m. Every length Priya could have jumped is below 3.85 m and every length Nadia could have jumped is at least 3.85 m, so Nadia jumped further whatever the exact lengths were. Answer: No — their possible jump lengths do not overlap. The distractors: the reason that a recorded jump is exactly the length jumped reaches the same verdict by treating a rounded record as exact, which is the idea this question tests; both jumps being 3.85 m would put 3.85 m inside Priya's range, when a jump of that length is recorded as 3.9 m; Priya jumping up to 3.9 m goes a whole 0.1 m above her record instead of half of it.
- (b) 6.2 ≤ x < 6.3 — Truncating simply cuts off the digits after the required decimal place instead of rounding them, so every value from 6.2 up to (but not reaching) 6.3 truncates to 6.2. This gives the error interval 6.2 ≤ x < 6.3, with no allowance made on the lower side because truncation never rounds a smaller value up into this interval. Using 6.15 ≤ x < 6.25 applies the rounding rule of going half a unit either side, which does not apply to truncation. Writing 6.1 < x ≤ 6.2 puts the interval below 6.2 instead of above it. Writing 6.2 ≤ x ≤ 6.3 wrongly includes 6.3, which truncates down to itself, not to 6.2.
- (a) 6 × 10² metres — Method: distance = speed × time, so multiply the coefficients and add the indices. Working: 3 × 2 = 6 for the coefficients, and 8 + (−6) = 2 for the indices; 6 lies between 1 and 10, so the coefficient needs no adjustment. Answer: 6 × 10² metres, which is 600 metres. The distractors: 5 × 10² metres comes from adding the coefficients, 3 + 2, instead of multiplying them; 6 × 10¹⁴ metres comes from subtracting the indices, 8 − (−6), which is the rule for dividing rather than for multiplying; 6 × 10⁻⁴⁸ metres comes from multiplying the indices, 8 × (−6), instead of adding them.
Build your own mix at the worksheet builder.