Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) £7.25 — Find the total cost of the books first: 3 × 4.25 = 12.75, so the books cost £12.75 in total. Subtract this from the £20 note: 20.00 − 12.75 = 7.25, so the change is £7.25. Stopping after finding the cost and not subtracting it from £20 gives £12.75, which is the amount spent, not the change. Borrowing correctly in the pence column but forgetting to reduce the pounds column by 1 gives £8.25 instead of £7.25. Multiplying 3 × 4.25 as 12.25 instead of 12.75, a multiplication slip, makes the change come out £0.50 too high, at £7.75. So Jack receives £7.25 change.
- (d) 1.6 × 10⁵ — 5.6 ÷ 3.5 = 1.6, and 7 − 2 = 5, so the average turnover per shop is 1.6 × 10⁵ pounds. Multiplying the exponents instead of subtracting them gives 7 × 2 = 14, so 1.6 × 10¹⁴. Adding the exponents instead of subtracting them gives 7 + 2 = 9, so 1.6 × 10⁹. Subtracting the coefficients instead of dividing them gives 5.6 − 3.5 = 2.1, so 2.1 × 10⁵.
- (c) An under-estimate, by 8 — Method: work out the exact product, then compare it with the estimate; an estimate that is smaller than the exact value is an under-estimate, and the difference between them is the size of the error. Working: 48 × 21 = 48 × 20 + 48 = 960 + 48 = 1,008, and 1,008 − 1,000 = 8, so the estimate falls short. Answer: an under-estimate, by 8. The distractors: an over-estimate by 8 has the size of the error right but the direction wrong, and comes from assuming that rounding 48 up to 50 must push the estimate above the exact value, without allowing for 21 being rounded down; an over-estimate by 19 comes from working out 48 × 21 as 48 × 20 + 21 = 981, adding a 21 where another 48 belongs; the claim that the estimate is exactly right comes from arguing that one number was rounded up and the other down, so the two changes must cancel.
- (b) 6.2 ≤ x < 6.3 — Truncating simply cuts off the digits after the required decimal place instead of rounding them, so every value from 6.2 up to (but not reaching) 6.3 truncates to 6.2. This gives the error interval 6.2 ≤ x < 6.3, with no allowance made on the lower side because truncation never rounds a smaller value up into this interval. Using 6.15 ≤ x < 6.25 applies the rounding rule of going half a unit either side, which does not apply to truncation. Writing 6.1 < x ≤ 6.2 puts the interval below 6.2 instead of above it. Writing 6.2 ≤ x ≤ 6.3 wrongly includes 6.3, which truncates down to itself, not to 6.2.
- (c) £47.00 — First apply the 20% reduction: £65 × 0.8 = £52.00. Then take off the further £5: £52.00 − £5 = £47.00. Treating the 20% as a flat £20 rather than a percentage of the price, £65 − £20 − £5, gives £40.00. Applying the 20% reduction correctly but forgetting to take off the extra £5 leaves £52.00. Taking off the £5 first and then applying the 20% reduction to the smaller amount, (£65 − £5) × 0.8, gives £48.00.
- (c) 24 — Method: round each number to the nearest whole number, then multiply the rounded values. Working: 6.4 rounds to 6 (nearest whole number) and 3.9 rounds to 4 (nearest whole number). 6 × 4 = 24. Answer: 24. 18 comes from rounding 3.9 down to 3 instead of up to the nearest whole number, 4, giving 6 × 3. 28 comes from rounding 6.4 up to 7 instead of down to the nearest whole number, 6, giving 7 × 4. 25 is the exact value of 6.4 × 3.9, which is 24.96, rounded to the nearest whole number after multiplying, rather than estimated by rounding first.
- (c) 5/8 — Method: write the decimal over 1000 using its three decimal places, then simplify. Working: 0.625 = 625/1000 = 5/8 (dividing both numerator and denominator by 125). Answer: 5/8. 25/4 comes from writing the decimal over 100 instead of 1000, as if there were only two decimal places. 31/50 comes from rounding 0.625 to 0.62 before converting. 8/5 comes from simplifying correctly to 5/8 and then writing the fraction upside down.
- (b) No — their possible jump lengths do not overlap — Method: each recorded jump stands for the lengths within half of 0.1 m, that is 0.05 m, of the figure recorded, and Priya is right only if the two ranges overlap. Working: Priya's jump is at least 3.8 − 0.05 = 3.75 m and below 3.85 m, because a jump of 3.85 m would have been recorded as 3.9 m; Nadia's jump is at least 3.85 m and below 3.9 + 0.05 = 3.95 m. Every length Priya could have jumped is below 3.85 m and every length Nadia could have jumped is at least 3.85 m, so Nadia jumped further whatever the exact lengths were. Answer: No — their possible jump lengths do not overlap. The distractors: the reason that a recorded jump is exactly the length jumped reaches the same verdict by treating a rounded record as exact, which is the idea this question tests; both jumps being 3.85 m would put 3.85 m inside Priya's range, when a jump of that length is recorded as 3.9 m; Priya jumping up to 3.9 m goes a whole 0.1 m above her record instead of half of it.
- (c) 25/36 — Method: square a fraction by squaring its numerator and its denominator separately, then add the two results over a common denominator. Working: (2/3)² = 4/9 and (1/2)² = 1/4; the lowest common denominator of 9 and 4 is 36, so 4/9 = 16/36 and 1/4 = 9/36, and 16 + 9 = 25. Answer: 25/36. The distractors: 49/36 comes from adding the two fractions first and squaring the total, giving (7/6)²; 5/13 comes from squaring correctly but then adding the numerators and the denominators, as (4 + 1)/(9 + 4); 7/3 comes from doubling each fraction instead of squaring it, giving 4/3 + 1.
- (c) 3.95 — The digit after the second decimal place is 7, which is 5 or more, so round the second decimal place up: 3.947 rounds to 3.95. A candidate who truncated instead of rounding, simply cutting off after 2 decimal places, wrote 3.94. A candidate who rounded to 1 decimal place instead of 2 wrote 3.9. A candidate who rounded up but mishandled the carry wrote 4.0.
- (d) 10π cm — Method: for a circle, circumference = π × diameter. Working: circumference = π × 10 = 10π cm. Answer: 10π cm. 20π cm comes from using the formula 2 × π × radius but plugging in the diameter as if it were the radius: 2 × π × 10 = 20π. 25π cm comes from confusing circumference with area, using π × radius² with radius 5: π × 5² = 25π. 5π cm comes from halving the diameter and then multiplying by π, as if circumference were π × radius: π × 5 = 5π.
- (a) −22 — Method: both multiplications are carried out before the addition, and a positive multiplied by a negative is negative. Working: (−3) × 4 = −12 and 2 × (−5) = −10, so the calculation becomes −12 + (−10) = −22. Answer: −22. The distractors: 22 comes from ignoring the minus signs and working out 3 × 4 + 2 × 5 = 22; 50 comes from working from left to right with no priority at all, giving −12 + 2 = −10 and then −10 × (−5) = 50; −2 comes from taking 2 × (−5) as +10, so that −12 + 10 = −2.
- (a) 8.35 ≤ L < 8.45 — Method: a length rounded to 1 decimal place lies within half of 0.1 cm, that is 0.05 cm, of the value written down. The lower limit is included because it rounds up to that value, and the upper limit is excluded because it rounds up to the next value instead. Working: 8.4 − 0.05 = 8.35 and 8.4 + 0.05 = 8.45, so a length of 8.35 cm still rounds to 8.4 cm while a length of 8.45 cm rounds to 8.5 cm. Answer: 8.35 ≤ L < 8.45. The distractors: 8.3 ≤ L < 8.5 goes a whole 0.1 cm either side instead of half of it; 8.35 < L ≤ 8.45 has the two limits the wrong way round, excluding the length that does round to 8.4 cm and including the one that does not; 8.4 ≤ L < 8.5 is the interval for a length truncated to 1 decimal place, not one rounded to it.
- (c) 2/3 — Method: fractions with the same denominator are added by adding the numerators and leaving the denominator alone, because the parts are already the same size. Working: 1/3 + 1/3 has numerators 1 + 1 = 2 and the denominator stays as 3, giving 2/3. Answer: 2/3. The distractors: 2/6 comes from adding the denominators as well as the numerators, 1 + 1 over 3 + 3; 2/9 comes from adding the numerators but multiplying the denominators, 1 + 1 over 3 × 3; 1/9 comes from multiplying throughout instead of adding, 1 × 1 over 3 × 3.
- (d) 11 mm — Method: for a square, the side length is the square root of the area. Working: 11 × 11 = 121, so the side length is 11 mm. 60.5 mm comes from working out 121 ÷ 2 = 60.5, halving the area instead of finding its square root. 242 mm comes from working out 121 × 2 = 242, doubling the area instead of finding its square root. 22 mm comes from working out 11 × 2 = 22, doubling the correct side length. Answer: 11 mm.
Build your own mix at the worksheet builder.