Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) £177.60 — Total raised = 240 × £1.85 = £444.00. The hospital receives 40% of this: £444.00 × 0.4 = £177.60. A candidate who works out the remaining 60% instead of the 40% given away gets £266.40. A candidate who forgets to find the percentage and gives the full total gets £444.00. A candidate who halves 40% by mistake and uses 20% gets £88.80.
- (c) 25/36 — Method: square a fraction by squaring its numerator and its denominator separately, then add the two results over a common denominator. Working: (2/3)² = 4/9 and (1/2)² = 1/4; the lowest common denominator of 9 and 4 is 36, so 4/9 = 16/36 and 1/4 = 9/36, and 16 + 9 = 25. Answer: 25/36. The distractors: 49/36 comes from adding the two fractions first and squaring the total, giving (7/6)²; 5/13 comes from squaring correctly but then adding the numerators and the denominators, as (4 + 1)/(9 + 4); 7/3 comes from doubling each fraction instead of squaring it, giving 4/3 + 1.
- (a) 8.15 ≤ y < 8.25 — Rounding to 1 decimal place means the error interval spans half of 0.1, so 0.05, either side of 8.2: 8.2 − 0.05 = 8.15 and 8.2 + 0.05 = 8.25. The lower bound uses ≤ because 8.15 itself rounds to 8.2, but the upper bound uses < because 8.25 would round up to 8.3. So the error interval is 8.15 ≤ y < 8.25. A candidate who used the wrong rounding band gave 8.1 ≤ y < 8.2. A candidate who used a strict inequality at both ends wrote 8.15 < y < 8.25, wrongly excluding 8.15 itself. A candidate who added the full 0.1 instead of half of it wrote 8.2 ≤ y < 8.3.
- (a) 1,850 — Method: find the error interval, then check which value falls outside it. Working: half of 100 is 50, so the actual number of visitors, v, satisfies 1,750 ≤ v < 1,850. 1,850 sits exactly on the excluded upper boundary, since a value of 1,850 would round to 1,900, not 1,800. Answer: 1,850. (1,750 is a genuine possible value — it sits at the included lower boundary. 1,799 is a genuine possible value, just below the upper boundary. 1,760 is a genuine possible value, well inside the interval.)
- (c) 3.05 kg — There are 1000 g in 1 kg, so 450 g = 450 ÷ 1000 = 0.45 kg. The total mass is 0.45 + 2.6 = 3.05 kg. 7.1 kg divides the grams by 100 instead of 1000, 2.645 kg divides them by 10 000, and 452.6 kg adds the two numbers without converting the grams at all.
- (b) No — their possible jump lengths do not overlap — Method: each recorded jump stands for the lengths within half of 0.1 m, that is 0.05 m, of the figure recorded, and Priya is right only if the two ranges overlap. Working: Priya's jump is at least 3.8 − 0.05 = 3.75 m and below 3.85 m, because a jump of 3.85 m would have been recorded as 3.9 m; Nadia's jump is at least 3.85 m and below 3.9 + 0.05 = 3.95 m. Every length Priya could have jumped is below 3.85 m and every length Nadia could have jumped is at least 3.85 m, so Nadia jumped further whatever the exact lengths were. Answer: No — their possible jump lengths do not overlap. The distractors: the reason that a recorded jump is exactly the length jumped reaches the same verdict by treating a rounded record as exact, which is the idea this question tests; both jumps being 3.85 m would put 3.85 m inside Priya's range, when a jump of that length is recorded as 3.9 m; Priya jumping up to 3.9 m goes a whole 0.1 m above her record instead of half of it.
- (b) 9 g/cm³ — Method: density = mass ÷ volume. Working: 540 ÷ 60 = 9. Answer: 9 g/cm³. (0.11 g/cm³ comes from dividing the volume by the mass instead of the mass by the volume. 480 g/cm³ comes from subtracting the volume from the mass instead of dividing. 32400 g/cm³ comes from multiplying the mass by the volume instead of dividing.)
- (a) 1/16 — Method: terms can only be subtracted once they share a denominator, so write every term over the largest denominator, 16, and then subtract the numerators in order from left to right. Working: 1 = 16/16, 1/2 = 8/16, 1/4 = 4/16 and 1/8 = 2/16, so the numerators give 16 − 8 − 4 − 2 − 1 = 1, over a denominator of 16. Answer: 1/16. The distractors: 1/8 comes from stopping one term early, after 16 − 8 − 4 − 2 = 2; 3/16 comes from a sign slip on the last term, adding it instead of subtracting it, which gives 2 + 1 = 3; 15/16 comes from working from the right-hand end as though the last four terms were bracketed together, so that only a single sixteenth is taken away from 1.
- (a) 2/5 — Method: find the number of vegetable plots in each allotment, add them, then divide by the total number of plots in both allotments. Working: Allotment A: 3/5 × 20 = 12 vegetable plots. Allotment B: 1/5 × 20 = 4 vegetable plots. Total vegetable plots = 12 + 4 = 16. Total plots = 20 + 20 = 40. Fraction = 16/40 = 2/5. Answer: 2/5. 3/10 comes from using only Allotment A's 12 vegetable plots over the combined total of 40 plots, forgetting to add Allotment B's vegetable plots. 1/5 comes from using only Allotment B's ratio (1:4) as the fraction of vegetables, ignoring Allotment A altogether. 3/5 comes from working out the fraction of the combined plots that grow flowers instead of vegetables.
- (a) 0.55, 58%, 3/5 — Converting all three to decimals: 3/5 = 0.6, 0.55 stays as 0.55, and 58% = 0.58. In order from smallest to largest, this is 0.55, then 58%, then 3/5. Writing the numbers in the reverse order, largest to smallest, gives 3/5, 58%, 0.55. Misconverting 3/5 as 0.5 instead of 0.6 makes it appear smaller than both other values, giving the order 3/5, 0.55, 58%. Misconverting 58% as 0.058 instead of 0.58, by moving the decimal point two extra places, makes it appear smallest of the three, giving the order 58%, 0.55, 3/5.
- (d) −8, −3, 0, 2, 5 — Method: place the numbers on a number line and read them from left to right. Working: the negative numbers −8 and −3 come before 0, with −8 further left than −3 because it is further from zero in the negative direction; then 0, then the positive numbers 2 and 5 in increasing size. Answer: −8, −3, 0, 2, 5. −3, −8, 0, 2, 5 swaps −3 and −8, putting the negative number closer to zero first. 5, 2, 0, −3, −8 lists the numbers from largest to smallest instead of smallest to largest. −8, −3, 2, 0, 5 puts 2 before 0, treating positive numbers as if they always come before zero.
- (a) 7.5 × 10⁴ — Standard form is A × 10ⁿ, where A is between 1 and 10 (1 ≤ A < 10) and n is an integer — 7.5 × 10⁴ satisfies all of this. 12 × 10³ fails because 12 is not below 10. 0.5 × 10⁴ fails because 0.5 is not at least 1. 6.2 × 4⁵ fails because standard form always uses a power of 10, not a power of 4.
- (a) −22 — Method: both multiplications are carried out before the addition, and a positive multiplied by a negative is negative. Working: (−3) × 4 = −12 and 2 × (−5) = −10, so the calculation becomes −12 + (−10) = −22. Answer: −22. The distractors: 22 comes from ignoring the minus signs and working out 3 × 4 + 2 × 5 = 22; 50 comes from working from left to right with no priority at all, giving −12 + 2 = −10 and then −10 × (−5) = 50; −2 comes from taking 2 × (−5) as +10, so that −12 + 10 = −2.
- (c) > — Method: fractions with the same denominator are made of parts of the same size, so compare how many of those parts each fraction has. Working: both fractions are elevenths, and 6 elevenths is 2 more elevenths than 4 elevenths, so the fraction on the left is the larger one. The symbol must have its point facing the smaller side. Answer: >. The distractors: < comes from comparing the numerators the wrong way round, as though a larger numerator gave a smaller fraction; = comes from seeing the same denominator in both fractions and concluding that the fractions themselves are the same size; ≤ comes from working out the direction correctly but then picking the wrong symbol for it, reading it as though it meant 'is greater than or equal to'; ≤ means 'is less than or equal to', and 6 elevenths is neither less than nor equal to 4 elevenths.
- (a) 10π cm — The circumference of a circle is found from C = 2 × π × r. With a radius of 5 cm, this gives C = 2 × π × 5 = 10π cm. Using the radius directly in the formula without doubling it gives 5π cm, missing the factor of 2. Using the formula for area, π × r², instead of circumference gives 25π cm, which is also the wrong units for a length. Doubling the radius to get a diameter of 10 and then applying the circumference formula a second time gives 20π cm, doubling the answer that is already correct.
Build your own mix at the worksheet builder.