Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) 2/25 — Method: write the decimal over 100 using its two decimal places, then simplify. Working: 0.08 = 8/100 = 2/25 (dividing both numerator and denominator by 4). Answer: 2/25. The student's fraction, 8/10, comes from ignoring the zero in the tenths column and reading 0.08 as though it were 0.8; it simplifies to 4/5. 1/125 comes from writing the decimal over 1000 instead of 100, as if there were three decimal places. 25/2 comes from flipping the correct fraction upside down.
- (d) the first mark after 0 — Method: when a unit length is split into equal parts, each gap is one part of the whole, so 1/4 is one gap along from 0. Working: four equal parts means each gap measures 1/4, so the marks after 0 stand for 1/4, 2/4, 3/4 and 4/4. One gap along from 0 is therefore the mark for 1/4. Answer: the first mark after 0. The distractors: the second mark after 0 comes from counting 0 itself as the first mark; the third mark after 0 comes from counting back from the 1 end instead of forward from 0; the fourth mark after 0 comes from reading the 4 in the denominator as the number of the mark rather than the number of parts.
- (a) 8,350 — Rounding to the nearest 100 means the true number can be up to half of 100, which is 50, below the recorded figure before it would round down to a lower hundred. The smallest possible number is therefore 8,400 − 50 = 8,350. Adding 50 instead of subtracting it gives 8,450, which is the upper end of the interval rather than the smallest value, and 8,450 is not itself possible because it would round up to 8,500. Subtracting a whole 100 instead of half of it gives 8,300, going too far below the recorded value. Subtracting 10 instead of half of the rounding unit gives 8,390, treating the rounding unit as 100 but the tolerance as only 10.
- (d) 60 — Method: a percentage acts as an operator, so finding 20% of an amount means multiplying it by 20/100, which cancels to 1/5. Working: 20% = 20/100 = 1/5, and 300 ÷ 5 = 60. Answer: 60 seats. The distractors: 15 comes from reading 20% as one twentieth and working out 300 ÷ 20 = 15; 30 comes from finding 10% of 300 and stopping there instead of doubling it; 6 comes from converting 20% to 0.02 rather than 0.2, giving 0.02 × 300 = 6.
- (c) 0.024 — Multiply the digits ignoring the decimal points: 6 × 4 = 24. Count the total number of decimal places in the two numbers being multiplied: 0.6 has 1 decimal place and 0.04 has 2, giving 3 in total. Place the decimal point in 24 so that there are 3 digits after it: 0.024. Counting only 2 decimal places instead of 3 gives 0.24. Counting 4 decimal places instead of 3 gives 0.0024. Counting only 1 decimal place instead of 3 — in effect moving the point in just one of the two numbers, as if the calculation were 6 × 0.4 — gives 2.4. So 0.6 × 0.04 = 0.024.
- (a) 2/5 — The ratio 2:3 has 2 + 3 = 5 parts in total, and the larger plot is 3 of those parts. Since the larger plot is 18 m², each part is 18 ÷ 3 = 6 m², so the total area is 5 × 6 = 30 m² and the smaller plot is 2 × 6 = 12 m². The fraction of the total area taken up by the smaller plot is 12/30, which simplifies to 2/5. Giving the fraction for the larger plot instead of the smaller one gives 3/5. Comparing the smaller plot to the larger plot instead of to the total area gives 2/3. Assuming the two plots split the area evenly, ignoring the given ratio altogether, gives 1/2.
- (c) 8 hours 35 minutes — From 21:35 to midnight is 2 hours 25 minutes, and from midnight to 06:10 is a further 6 hours 10 minutes, giving a total of 8 hours 35 minutes. Misreading the departure time as 22:35 instead of 21:35 loses an hour from the calculation and gives 7 hours 35 minutes. Misreading the departure time as 20:35 instead of 21:35 gains an hour and gives 9 hours 35 minutes. Subtracting the times as if both fell on the same day, without crossing midnight, gives 15 hours 25 minutes.
- (a) 11.5 ≤ L < 12.5 — Rounding to the nearest centimetre means L can be up to half a centimetre below or above 12 before it would round to a different whole number. Half of 1 cm is 0.5 cm, so the lower bound is 12 − 0.5 = 11.5 and the upper bound is 12 + 0.5 = 12.5. A value exactly at the upper bound, 12.5, would round up to 13, not 12, so 12.5 itself is excluded, giving 11.5 ≤ L < 12.5. Writing 11.5 ≤ L ≤ 12.5 wrongly includes 12.5 on both ends. Writing 11 ≤ L < 13 uses a whole centimetre either side instead of half a centimetre. Writing 11.5 < L < 12.5 wrongly excludes the lower bound, which is a value that does round to 12.
- (b) −0.7 < −0.25 — Method: compare the two negative decimals by their distance from zero on a number line. Working: −0.7 is 0.7 away from zero and −0.25 is 0.25 away from zero, so −0.7 is further from zero in the negative direction, making it the smaller number. Answer: −0.7 < −0.25 is true. "−0.7 > −0.25" comes from comparing 0.7 and 0.25 as if both numbers were positive, ignoring the negative signs. "−0.7 = −0.25" comes from assuming the two numbers are equal because they are both negative decimals. "−0.7 ≥ −0.25" combines the false statement "−0.7 > −0.25" with the false statement "−0.7 = −0.25".
- (b) 2/7 — The comparison asked for is part with part, not part with whole, so the number of cars goes on the bottom. The ratio gives 2 shares of vans for every 7 shares of cars, so the vans are 2/7 of the cars. 2/9 uses the 9 shares in the whole car park as the denominator, 7/2 compares the cars with the vans, and 7/9 is the fraction of the vehicles that are cars.
- (b) 31 — Method: a prime number has exactly two factors, 1 and itself, so check each number between 30 and 40 for other factors. Working: 3 × 11 = 33, so 33 is not prime. 2 × 17 = 34, so 34 is not prime. 4 × 9 = 36, so 36 is not prime. 31 has no factors other than 1 and 31, so it is prime. Answer: 31.
- (a) 12 — Compare the powers of each prime that appears in both factorisations. In 2² × 3² and 2² × 3 × 7, the prime 2 appears with power 2 in both, and the prime 3 appears with power 2 in one and only power 1 in the other — take the lower power, 3¹. Multiplying the shared primes at their lower powers, 2² × 3, gives 12. Using power 1 for both primes instead of comparing the powers properly, 2 × 3, gives 6, which misses that 2 is common at power 2, not power 1. Multiplying the primes at their higher powers and including 7, which only appears in 84, gives 2² × 3² × 7, which comes to 252 — this is the lowest common multiple, not the highest common factor. Only spotting that 3 is a common prime and overlooking that 2 is common as well gives 3. So the highest common factor of 36 and 84 is 12.
- (a) 2/5 — Method: find the number of vegetable plots in each allotment, add them, then divide by the total number of plots in both allotments. Working: Allotment A: 3/5 × 20 = 12 vegetable plots. Allotment B: 1/5 × 20 = 4 vegetable plots. Total vegetable plots = 12 + 4 = 16. Total plots = 20 + 20 = 40. Fraction = 16/40 = 2/5. Answer: 2/5. 3/10 comes from using only Allotment A's 12 vegetable plots over the combined total of 40 plots, forgetting to add Allotment B's vegetable plots. 1/5 comes from using only Allotment B's ratio (1:4) as the fraction of vegetables, ignoring Allotment A altogether. 3/5 comes from working out the fraction of the combined plots that grow flowers instead of vegetables.
- (c) 2/5 — To find a fraction of a fraction, multiply them together: 3/5 × 2/3 = 6/15, which simplifies to 2/5. Multiplying only the numerators, 3 × 2 = 6, but adding the denominators, 5 + 3 = 8, instead of multiplying them gives 6/8, which simplifies to 3/4. Using only the fraction who study French, 3/5, and ignoring that a further fraction of them also study Spanish gives 3/5. Dividing by 2/3 instead of multiplying by it, using its reciprocal 3/2, gives 3/5 × 3/2 = 9/10.
- (a) 36 — Method: for the highest common factor, take the LOWER power of each prime that appears in both numbers. Working: for 2, the lower power is 2² (from 108); for 3, the lower power is 3² (from 72), so the highest common factor is 2² × 3² = 4 × 9 = 36. 216 comes from taking the higher power of each prime instead, 2³ × 3³ = 8 × 27 = 216, which gives the lowest common multiple, not the highest common factor. 108 is simply one of the two numbers, not their highest common factor. 6 comes from multiplying the primes without any powers at all, 2 × 3 = 6. Answer: 36.
Build your own mix at the worksheet builder.