Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) 0.6 — Method: convert the fraction to an equivalent fraction with denominator 10, then read off the decimal. Working: 3/5 = 6/10 (multiplying numerator and denominator by 2) = 0.6. Answer: 0.6. 0.35 comes from combining the digits 3 and 5 directly after the decimal point instead of converting the fraction. 0.53 comes from writing the numerator and denominator digits in the wrong order. 1.67 comes from flipping the fraction to 5/3 before converting to a decimal.
- (c) 0.7, 0.72, 3/4 — Method: numbers written in different forms cannot be compared as they stand, so every fraction is turned into a decimal by dividing the numerator by the denominator, and the decimals are then compared place by place from the left. Working: 3/4 means 3 ÷ 4 = 0.75, so the three values to compare are 0.7, 0.75 and 0.72; written to two decimal places they are 0.70, 0.75 and 0.72, and the hundredths digits 0, 5 and 2 put 0.70 first, 0.72 next and 0.75 last; written again in the forms the question used, the order from smallest is 0.7, then 0.72, then 3/4. Answer: 0.7, 0.72, 3/4. The distractors: 3/4, 0.7, 0.72 comes from turning 3/4 into 0.34 by writing the numerator and the denominator as the two digits after the point, which makes the fraction the smallest of the three; 0.72, 3/4, 0.7 comes from the belief that the more digits a decimal has the smaller it must be, which puts both 0.72 and 0.75 below 0.7 and 0.72 below 0.75; 3/4, 0.72, 0.7 comes from comparing the three values correctly but listing them largest first, against an instruction to start with the smallest.
- (c) 9π cm² — The area of a circle is π × r². With a radius of 3 cm this is π × 3² = 9π cm², and this is exact because π has not been replaced by any approximation. Writing 28.3 cm² replaces π with a rounded decimal value, 3.14, and then rounds the result again, so it is only an approximation. Writing 28.26 cm² uses π ≈ 3.14 without a final rounding step, but this is still only an approximation of 9π, not the exact value. Writing 27 cm² comes from replacing π with the rough approximation 3, which is even further from the true value.
- (a) £6 — 10% of £40 is £4, and 5% of £40 is half of that, £2. Adding these gives 15% of £40 = £4 + £2 = £6. Finding only the 10% part and stopping there gives £4. Finding only the 5% part and stopping there gives £2. Multiplying 40 by 15 without dividing by 100 gives £600, which treats the percentage as if it were a whole number multiplier.
- (b) 24 — List multiples of 8 and of 12: multiples of 8 are 8, 16, 24, 32; multiples of 12 are 12, 24, 36. The lowest number in both lists is 24, so the lighthouses next flash together after 24 minutes. Multiplying the two numbers together, 8 × 12, gives 96, which double-counts the common factor of 4 shared by 8 and 12. Working out the highest common factor instead of the lowest common multiple gives 4, far too soon a time for both lighthouses to line up again. Adding the two numbers, 8 + 12, gives 20, which is not even a multiple of either 8 or 12. So the lighthouses next flash together after 24 minutes.
- (a) 7 — Dividing by 0.1 is the same as multiplying by 10, so 0.7 ÷ 0.1 = 7. Meera's answer of 0.07 comes from dividing 0.7 by 10 instead of by 0.1, the wrong way round. A candidate who confuses 0.1 with 0.01 multiplies by 100 instead of 10 and gets 70. A candidate who thinks dividing by a number less than 1 does not change the value gets 0.7.
- (d) −1.4, −6/5, 0, 5/4, 1.3 — Method: convert the fractions 5/4 and −6/5 to decimals so every number is written the same way, then compare all five decimals. Working: 5/4 = 1.25 and −6/5 = −1.2. Comparing −1.4, −1.2, 0, 1.25 and 1.3 in size gives the order −1.4, −1.2, 0, 1.25, 1.3. Answer: −1.4, −6/5, 0, 5/4, 1.3. −6/5, −1.4, 0, 5/4, 1.3 swaps the two negative numbers, treating −6/5 as more negative than −1.4 even though −1.2 is closer to zero than −1.4. 1.3, 5/4, 0, −6/5, −1.4 lists the numbers from largest to smallest instead of smallest to largest. −1.4, −6/5, 0, 1.3, 5/4 swaps 5/4 and 1.3, comparing the numerator 5 directly with 1.3 instead of converting 5/4 to the decimal 1.25 first.
- (c) 27 — Each of the 3 digits can be chosen independently for each of the 3 positions, so multiply: 3 × 3 × 3 = 27. 9 comes from multiplying only two of the three positions, 3 × 3, and forgetting the third. 6 comes from working out 3 × 2 × 1 = 6, which counts codes where digits do not repeat, but the question allows repeated digits. 3 comes from considering only one digit position.
- (d) 60 mph — Average speed = distance ÷ time, with the time measured in hours. 45 minutes is 45/60 of an hour, which is 0.75 of an hour, so the journey takes 1.75 hours. Speed = 105 ÷ 1.75 = 60 mph. 52.5 mph rounds the time up to 2 hours, 72.4 mph writes 1 hour 45 minutes as 1.45 hours, and 183.75 mph multiplies the distance by the time instead of dividing.
- (a) 300 — Method: round each number to 1 significant figure, then divide the rounded values. Working: 8,900 rounds to 9,000 and 29 rounds to 30; cancelling a zero from each gives 900 ÷ 3. Answer: 300. The distractors: 450 comes from rounding 29 down to 20 instead of to the nearest ten, giving 9,000 ÷ 20; 3,000 comes from rounding 29 to 3 rather than to 30, a place-value slip that divides by a number ten times too small; 307 is the exact quotient rounded to the nearest whole number, worked out in full when the question asks for an estimate.
- (b) −5 — Using the order of operations, work out the multiplication first: 4 × (−2) = −8. Then 3 + (−8) = −5. A candidate who adds before multiplying gets (3 + 4) × (−2) = −14. A candidate who drops the negative sign on the multiplication gets 3 + 4 × 2 = 11. A candidate who works out the multiplication correctly but gives that as the final answer, forgetting to combine it with the 3, gets −8.
- (a) They cannot both be describing the same path — Jon's measurement means the true length, l, satisfies 11.5 m ≤ l < 12.5 m. Mia's measurement means the true length satisfies 12.55 m ≤ l < 12.65 m. These two ranges do not overlap, so the two measurements cannot both be describing the same path. 'They must both be describing the same path' ignores that the two ranges do not overlap at all. 'Jon's measurement must be wrong' wrongly assumes Jon is the one at fault, when the mismatch does not show which measurement, if either, is wrong. 'Mia's measurement must be wrong' makes the same unjustified assumption in the other direction.
- (a) −108 — Method: a power is worked out before any minus sign written in front of it, while a minus sign inside the brackets is part of the base. Working: (−3)⁴ = 81, because four negative factors multiply to a positive result, so −(−3)⁴ = −81. (−3)³ = −27, because three negative factors multiply to a negative result. Adding gives −81 + (−27) = −108. Answer: −108. The distractors: 54 comes from attaching the leading minus sign to the base, working out (−(−3))⁴ = 81 and then adding −27; −54 comes from taking (−3)³ as +27, forgetting that an odd power keeps the negative sign; 108 comes from believing that any power of a negative number is positive and that the leading minus belongs to the base, giving 81 + 27.
- (a) 0.5, 0.55, 0.56, 0.6, 0.601 — Compare the decimals by giving them all the same number of decimal places first: 0.600, 0.550, 0.601, 0.500, 0.560. Ordering these from smallest to largest gives 0.500, 0.550, 0.560, 0.600, 0.601, which is 0.5, 0.55, 0.56, 0.6, 0.601. Comparing the digits as though they were whole numbers, reading 0.601 as "601" and 0.5 as "5", without padding to the same number of decimal places, gives the wrong order 0.5, 0.6, 0.55, 0.56, 0.601, because it ignores the place value of each digit. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 0.601, 0.6, 0.56, 0.55, 0.5. Misreading the close values 0.55 and 0.56 and swapping them gives 0.5, 0.56, 0.55, 0.6, 0.601. So the correct order, smallest to largest, is 0.5, 0.55, 0.56, 0.6, 0.601.
- (d) 11 mm — Method: for a square, the side length is the square root of the area. Working: 11 × 11 = 121, so the side length is 11 mm. 60.5 mm comes from working out 121 ÷ 2 = 60.5, halving the area instead of finding its square root. 242 mm comes from working out 121 × 2 = 242, doubling the area instead of finding its square root. 22 mm comes from working out 11 × 2 = 22, doubling the correct side length. Answer: 11 mm.
Build your own mix at the worksheet builder.