Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 125 — Method: a number cubed means multiplying the number by itself three times. Working: 5 × 5 × 5 = 125. 15 comes from working out 5 × 3 = 15, multiplying by the index instead of cubing. 8 comes from working out 5 + 3 = 8 instead of cubing. 53 comes from writing the base and the index next to each other instead of carrying out the calculation. Answer: 125.
- (a) 0.5, 0.55, 0.56, 0.6, 0.601 — Compare the decimals by giving them all the same number of decimal places first: 0.600, 0.550, 0.601, 0.500, 0.560. Ordering these from smallest to largest gives 0.500, 0.550, 0.560, 0.600, 0.601, which is 0.5, 0.55, 0.56, 0.6, 0.601. Comparing the digits as though they were whole numbers, reading 0.601 as "601" and 0.5 as "5", without padding to the same number of decimal places, gives the wrong order 0.5, 0.6, 0.55, 0.56, 0.601, because it ignores the place value of each digit. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 0.601, 0.6, 0.56, 0.55, 0.5. Misreading the close values 0.55 and 0.56 and swapping them gives 0.5, 0.56, 0.55, 0.6, 0.601. So the correct order, smallest to largest, is 0.5, 0.55, 0.56, 0.6, 0.601.
- (c) 0.36 — Method: convert the fraction to an equivalent fraction with denominator 100, then read off the decimal. Working: 9/25 = 36/100 (multiplying numerator and denominator by 4) = 0.36. Answer: 0.36. 2.8 comes from flipping the fraction and dividing the denominator by the numerator instead: 25 ÷ 9 = 2.77…, rounded to 2.8. 0.925 comes from writing the digits of the numerator and denominator directly after the decimal point without scaling the fraction. 0.9 comes from writing the numerator straight after the decimal point, as if the denominator were 10 rather than 25.
- (d) −2 — Method: place the two end values on a number line and list the integers that sit strictly between them. Working: reading from left to right the integers run −4, −3, −2, −1, so the values strictly between the ends are −3 and −2. Only one of those is offered. Answer: −2. The distractors: −5 comes from ordering negatives by the size of their digits, which wrongly places −5 to the right of −4; 0 comes from carrying on past −1 instead of stopping at it; 2 comes from ignoring the minus signs and choosing a number between 1 and 4.
- (c) 9/5 — Method: the area of a rectangle is its length multiplied by its width; the decimal product is then written over a power of ten and cancelled. Working: 24 × 75 = 1800, and 2.4 and 0.75 have three decimal places between them, so 2.4 × 0.75 = 1.8; the area of the panel is 1.8 square metres, which is eighteen tenths, so it can be written as 18/10, and dividing the numerator and the denominator by 2 gives 9 over 5. Answer: 9/5. The distractors: 4/5 comes from converting only the digits after the decimal point and losing the whole one, turning 1.8 into eight tenths; 63/20 comes from adding the two sides instead of multiplying them, giving 3.15; 9/50 comes from misplacing the decimal point in the product and writing 0.18, which cancels to 9 over 50.
- (c) 11 — Method: work out the total number of combinations as if there were no restriction, then subtract the one combination that is not allowed. Working: without any restriction there are 4 backdrops × 3 outfits = 12 combinations. The grey backdrop with the formal suit is not allowed, removing 1 combination: 12 − 1 = 11. Answer: 11. 12 comes from forgetting to remove the combination that is not allowed. 8 comes from removing the entire formal suit outfit from the count instead of just the one combination with the grey backdrop. 10 comes from removing two combinations instead of just the one that is not allowed.
- (a) 8.35 ≤ L < 8.45 — Method: a length rounded to 1 decimal place lies within half of 0.1 cm, that is 0.05 cm, of the value written down. The lower limit is included because it rounds up to that value, and the upper limit is excluded because it rounds up to the next value instead. Working: 8.4 − 0.05 = 8.35 and 8.4 + 0.05 = 8.45, so a length of 8.35 cm still rounds to 8.4 cm while a length of 8.45 cm rounds to 8.5 cm. Answer: 8.35 ≤ L < 8.45. The distractors: 8.3 ≤ L < 8.5 goes a whole 0.1 cm either side instead of half of it; 8.35 < L ≤ 8.45 has the two limits the wrong way round, excluding the length that does round to 8.4 cm and including the one that does not; 8.4 ≤ L < 8.5 is the interval for a length truncated to 1 decimal place, not one rounded to it.
- (a) 1,500 ≤ m < 2,500 — Method: a four-digit figure written to 1 significant figure has been rounded to the nearest 1,000, so the mass lies within half of 1,000, that is 500, of the figure given. Working: 2,000 − 500 = 1,500 and 2,000 + 500 = 2,500. The lower limit is included, because 1,500 kg rounds up to 2,000 kg to 1 significant figure, while 2,500 kg rounds up to 3,000 kg, so the upper limit is not. Answer: 1,500 ≤ m < 2,500. The distractors: 1,950 ≤ m < 2,050 comes from rounding to the nearest 100 instead of to 1 significant figure; 1,000 ≤ m < 3,000 goes a whole 1,000 either side instead of half of it; 1,500 < m ≤ 2,500 has the two limits the wrong way round.
- (c) 27 — Each of the 3 digits can be chosen independently for each of the 3 positions, so multiply: 3 × 3 × 3 = 27. 9 comes from multiplying only two of the three positions, 3 × 3, and forgetting the third. 6 comes from working out 3 × 2 × 1 = 6, which counts codes where digits do not repeat, but the question allows repeated digits. 3 comes from considering only one digit position.
- (d) 0.3 — Converting the fractions to decimals, 1/4 = 0.25 and 2/5 = 0.4, so any decimal between 0.25 and 0.4 is a valid answer, and 0.3 fits. Confusing 1/4 with 1/5 and converting it as 0.2 instead of 0.25 gives a value below the true lower bound. Confusing 2/5 with 1/2 and converting it as 0.5 instead of 0.4 gives a value above the true upper bound. Converting the fractions correctly but choosing a decimal above the true upper bound of 0.4 instead of between the two values gives 0.45.
- (c) £384.00 — Adding 20% VAT means multiplying the price by 1.2: £320 × 1.2 = £384.00. Treating the 20% as a flat £20 rather than a percentage of the price, £320 + £20, gives £340.00. Working out the VAT amount alone, £320 × 0.2 = £64.00, and stopping there without adding it back to the original price gives just the VAT, not the total price. Misplacing the decimal point and using 2% instead of 20%, £320 × 1.02, gives £326.40.
- (a) 7 — Method: BIDMAS deals with the index first, then the multiplication, then the subtraction. Working: (−2)² = (−2) × (−2) = 4, then 3 × 4 = 12, and finally 12 − 5 = 7. Answer: 7. The distractors: −17 comes from squaring only the 2 and keeping the minus sign, giving 3 × (−4) = −12 and then −12 − 5 = −17; 31 comes from multiplying before applying the index, giving (3 × (−2))² = (−6)² = 36 and then 36 − 5 = 31; −3 comes from carrying out the subtraction before the multiplication, giving 3 × (4 − 5) = 3 × (−1) = −3.
- (d) 2/25 — Method: write the decimal over 100 using its two decimal places, then simplify. Working: 0.08 = 8/100 = 2/25 (dividing both numerator and denominator by 4). Answer: 2/25. The student's fraction, 8/10, comes from ignoring the zero in the tenths column and reading 0.08 as though it were 0.8; it simplifies to 4/5. 1/125 comes from writing the decimal over 1000 instead of 100, as if there were three decimal places. 25/2 comes from flipping the correct fraction upside down.
- (b) 0.6 — Method: convert the fraction to an equivalent fraction with denominator 10, then read off the decimal. Working: 3/5 = 6/10 (multiplying numerator and denominator by 2) = 0.6. Answer: 0.6. 0.35 comes from combining the digits 3 and 5 directly after the decimal point instead of converting the fraction. 0.53 comes from writing the numerator and denominator digits in the wrong order. 1.67 comes from flipping the fraction to 5/3 before converting to a decimal.
- (c) 5 × 10⁶ — Method: standard form is written as A × 10ⁿ, where A is at least 1 and less than 10 and n counts the places the decimal point moves. Working: the digits of 5,000,000 give a coefficient of A = 5, and the decimal point travels from the end of 5,000,000 until it sits just after the 5, a move of 6 places, so n = 6. Answer: 5 × 10⁶. The distractors: 50 × 10⁵ comes from stopping before the coefficient has been brought into range, and 50 is not less than 10, so it is not standard form; 5 × 10⁷ comes from counting the seven digits of 5,000,000 instead of the six places the decimal point moves; 5 × 10⁻⁶ comes from making the index negative because the decimal point was carried to the left, when a negative index belongs to a number smaller than 1.
Build your own mix at the worksheet builder.