Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) £3.70 — Work in one unit throughout. 45p is £0.45, so three pens cost 3 × £0.45 = £1.35. Adding the notebook gives £1.35 + £2.35 = £3.70. £2.80 is the cost of one pen and the notebook, so the multiplication by 3 has been left out; £8.40 multiplies the notebook by 3 as well as the pens; £15.85 comes from reading 45p as £4.50.
- (d) 1 7/12 — Method: convert both mixed numbers to improper fractions with a common denominator, then subtract. Working: 3 1/4 = 39/12 and 1 2/3 = 20/12, so 39/12 − 20/12 = 19/12 = 1 7/12. Answer: 1 7/12. Chloe's method, subtracting whole numbers (3−1=2) and fraction parts (2/3−1/4=5/12) separately without exchanging, gives 2 5/12. 1 3/4 comes from converting 2/3 to twelfths incorrectly as 6/12 instead of 8/12, then subtracting. 8 comes from converting both mixed numbers to improper fractions correctly (13/4 and 5/3) but then subtracting numerators and denominators separately: (13−5)/(4−3) = 8/1.
- (b) 6 — List the factors of each number: the factors of 12 are 1, 2, 3, 4, 6 and 12; the factors of 18 are 1, 2, 3, 6, 9 and 18. The common factors are 1, 2, 3 and 6, and the highest of these is 6. Picking 2, a common factor but not the largest, gives an answer that is too small. Picking 3, also a common factor but still not the largest, gives another answer that is too small. Working out the lowest common multiple instead of the highest common factor gives 36. So the highest common factor of 12 and 18 is 6.
- (d) 1.2 × 10⁵ — 4 × 3 = 12, and 3 + 1 = 4, giving 12 × 10⁴ — but 12 is not between 1 and 10, so this must be rewritten as 1.2 × 10⁵. Stopping at 12 × 10⁴ without rewriting it leaves the coefficient out of range. Rewriting 12 as 1.2 but leaving the exponent at 4 instead of increasing it to 5 gives 1.2 × 10⁴, which is ten times too small. Adding the coefficients instead of multiplying them gives 4 + 3 = 7, so 7 × 10⁴.
- (b) 9 g/cm³ — Method: density = mass ÷ volume. Working: 540 ÷ 60 = 9. Answer: 9 g/cm³. (0.11 g/cm³ comes from dividing the volume by the mass instead of the mass by the volume. 480 g/cm³ comes from subtracting the volume from the mass instead of dividing. 32400 g/cm³ comes from multiplying the mass by the volume instead of dividing.)
- (c) 9 — Method: factors come in pairs that multiply to give the number, so work through the pairs in order; a factor paired with itself is counted only once. Working: the pairs are 1 × 100, 2 × 50, 4 × 25, 5 × 20 and 10 × 10. The first four pairs give eight different factors, and the last pair adds only one more, so the factors are 1, 2, 4, 5, 10, 20, 25, 50 and 100. Answer: 9. The distractors: 10 comes from counting the pair 10 × 10 as two separate factors; 8 comes from leaving 1 out of the list, on the view that 1 is not a proper factor; 4 comes from writing 100 = 2² × 5² and multiplying the two indices together instead of adding 1 to each index first.
- (d) 19 — 2² = 4, then 4 × 4 = 16, then 3 + 16 = 19. Adding before multiplying gives 3 + 4 = 7, then 7 × 4 = 28 — multiplication comes before addition. Squaring the product instead of just the 2 gives 4 × 2 = 8, then 8² = 64, then 3 + 64 = 67. Working strictly left to right throughout gives 3 + 4 = 7, then 7 × 2 = 14, then 14² = 196.
- (a) 2/5 — The ratio 2:3 has 2 + 3 = 5 parts in total, and the larger plot is 3 of those parts. Since the larger plot is 18 m², each part is 18 ÷ 3 = 6 m², so the total area is 5 × 6 = 30 m² and the smaller plot is 2 × 6 = 12 m². The fraction of the total area taken up by the smaller plot is 12/30, which simplifies to 2/5. Giving the fraction for the larger plot instead of the smaller one gives 3/5. Comparing the smaller plot to the larger plot instead of to the total area gives 2/3. Assuming the two plots split the area evenly, ignoring the given ratio altogether, gives 1/2.
- (a) 8.35 ≤ L < 8.45 — Method: a length rounded to 1 decimal place lies within half of 0.1 cm, that is 0.05 cm, of the value written down. The lower limit is included because it rounds up to that value, and the upper limit is excluded because it rounds up to the next value instead. Working: 8.4 − 0.05 = 8.35 and 8.4 + 0.05 = 8.45, so a length of 8.35 cm still rounds to 8.4 cm while a length of 8.45 cm rounds to 8.5 cm. Answer: 8.35 ≤ L < 8.45. The distractors: 8.3 ≤ L < 8.5 goes a whole 0.1 cm either side instead of half of it; 8.35 < L ≤ 8.45 has the two limits the wrong way round, excluding the length that does round to 8.4 cm and including the one that does not; 8.4 ≤ L < 8.5 is the interval for a length truncated to 1 decimal place, not one rounded to it.
- (a) 4/9 — Method: write the number of parts for the photos being compared over the number of parts for the photos they are being compared to. Working: black-and-white photos are 4 parts and colour photos are 9 parts, so black-and-white photos as a fraction of colour photos is 4/9. Answer: 4/9. 9/4 comes from writing the ratio the wrong way round, comparing colour to black-and-white instead of black-and-white to colour. 4/13 comes from comparing black-and-white photos to the total number of photos (4+9=13) instead of to the colour photos. 9/13 comes from comparing colour photos to the total number of photos instead of black-and-white to colour.
- (b) 90 km/h — To convert metres per second to kilometres per hour, multiply by 3.6 (there are 3600 seconds in an hour and 1000 metres in a kilometre, and 3600 ÷ 1000 = 3.6): 25 × 3.6 = 90 km/h. Dividing by 3.6 instead of multiplying gives 25 ÷ 3.6 = 6.9 km/h (to 1 d.p.). Multiplying by 60 instead of 3.6, confusing the conversion from seconds to minutes with the conversion to hours, gives 25 × 60 = 1500 km/h. Multiplying by 3600 to convert seconds to hours but forgetting to convert metres to kilometres gives 25 × 3600 = 90000, which is a speed in metres per hour, not kilometres per hour.
- (c) 3 × 10⁶ — Daily revenue = (4 × 10³) × 2.5 = 1 × 10⁴ (£10,000). Multiplying by the number of days, (3 × 10²), gives annual revenue = (1 × 10⁴) × (3 × 10²) = 3 × 10⁶ (£3,000,000). A candidate who forgot to multiply by the price and just multiplied the number of items by the number of days worked out (4 × 10³) × (3 × 10²) = 1.2 × 10⁶. A candidate who added the number of days to the daily revenue instead of multiplying worked out 1 × 10⁴ + 3 × 10² = 1.03 × 10⁴. A candidate who misread £2.50 as £25 worked out a daily revenue of (4 × 10³) × 25 = 1 × 10⁵, giving an annual total of (1 × 10⁵) × (3 × 10²) = 3 × 10⁷.
- (b) £35 — Method: round each price to the nearest pound, then add the rounded prices. Working: £9.95 rounds to £10, £19.90 rounds to £20 and £4.99 rounds to £5, and £10 + £20 + £5 gives the estimate. Answer: £35. The distractors: £40 comes from rounding each price up to the nearest £10 rather than to the nearest pound, giving £10 + £20 + £10; £32 comes from cutting the pence off each price instead of rounding it, giving £9 + £19 + £4; £34.84 is the exact total, worked out in full when the question asks for an estimate.
- (a) 0 — Method: BIDMAS works through the index first, then the multiplication, then the subtraction. Working: 5² = 25, then 4 × 25 = 100, and finally 100 − 100 = 0. Answer: 0. The distractors: 2400 comes from working from left to right and subtracting first, giving (100 − 4) × 25 = 96 × 25 = 2400; −300 comes from multiplying before applying the index, giving (4 × 5)² = 20² = 400 and then 100 − 400 = −300; 60 comes from reading 5² as 5 × 2 = 10, so that 4 × 10 = 40 and 100 − 40 = 60.
- (d) 0.3 — Converting the fractions to decimals, 1/4 = 0.25 and 2/5 = 0.4, so any decimal between 0.25 and 0.4 is a valid answer, and 0.3 fits. Confusing 1/4 with 1/5 and converting it as 0.2 instead of 0.25 gives a value below the true lower bound. Confusing 2/5 with 1/2 and converting it as 0.5 instead of 0.4 gives a value above the true upper bound. Converting the fractions correctly but choosing a decimal above the true upper bound of 0.4 instead of between the two values gives 0.45.
Build your own mix at the worksheet builder.