Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) 7 — Dividing by 0.1 is the same as multiplying by 10, so 0.7 ÷ 0.1 = 7. Meera's answer of 0.07 comes from dividing 0.7 by 10 instead of by 0.1, the wrong way round. A candidate who confuses 0.1 with 0.01 multiplies by 100 instead of 10 and gets 70. A candidate who thinks dividing by a number less than 1 does not change the value gets 0.7.
- (a) 28.8 km/h — A compound unit is converted one part at a time. There are 3600 seconds in an hour, so in one hour the cyclist travels 8 × 3600 = 28 800 metres. There are 1000 metres in a kilometre, so 28 800 m = 28 800 ÷ 1000 = 28.8 km/h. 28 800 km/h leaves the distance in metres, 0.48 km/h converts the seconds to minutes rather than to hours, and 2.22 km/h divides by 3.6 instead of multiplying.
- (c) 22 — Without restriction there are 6 × 4 = 24 combinations. Two specific combinations are not available, so subtract 2: 24 − 2 = 22. 24 comes from ignoring the restriction completely. 23 comes from subtracting only 1 of the 2 excluded combinations. 18 comes from removing the whole sport trim level, 6 × 3 = 18, instead of removing just the two excluded combinations.
- (a) 2/5 — The ratio 2:3 has 2 + 3 = 5 parts in total, and the larger plot is 3 of those parts. Since the larger plot is 18 m², each part is 18 ÷ 3 = 6 m², so the total area is 5 × 6 = 30 m² and the smaller plot is 2 × 6 = 12 m². The fraction of the total area taken up by the smaller plot is 12/30, which simplifies to 2/5. Giving the fraction for the larger plot instead of the smaller one gives 3/5. Comparing the smaller plot to the larger plot instead of to the total area gives 2/3. Assuming the two plots split the area evenly, ignoring the given ratio altogether, gives 1/2.
- (a) 4,000 nanometres — Method: the number of nanometres is the diameter divided by the length of one nanometre, and dividing powers of ten means subtracting the indices. Working: −6 − (−9) = 3, so 10⁻⁶ ÷ 10⁻⁹ = 10³, and the diameter is 4 × 10³ nanometres. Answer: 4,000 nanometres. The distractors: 400 nanometres comes from taking the difference between the indices as 2 instead of 3; 4 nanometres comes from changing the name of the unit without converting, leaving the coefficient untouched; 0.004 nanometres comes from dividing by 10³ instead of multiplying by it, as though a nanometre were the larger of the two units.
- (a) 9 °C — Method: the fall is the difference between the two readings, so subtract the lower reading from the higher one; subtracting a negative number is the same as adding its positive. Working: 3 − (−6) = 3 + 6 = 9. Counting it out, the temperature drops 3 degrees to reach zero and a further 6 degrees below zero. Answer: 9 °C. The distractors: −9 °C comes from subtracting the readings the wrong way round, as −6 − 3, and reporting a fall as a negative amount; 3 °C comes from ignoring the minus sign and working out 6 − 3; 6 °C comes from counting only the part of the fall that happens below zero and forgetting the 3 degrees above it.
- (c) 280 — Method: round each number to 1 significant figure, then multiply the rounded numbers. Working: 6.8 rounds to 7 because the next digit is 8, and 41 rounds to 40 because its next digit is 1, so the estimate is 7 × 40 = 280. Answer: 280. The distractors: 240 comes from cutting 6.8 down to 6 instead of rounding it up to 7, giving 6 × 40 = 240; 350 comes from rounding 41 up to 50 when the digit after its first significant figure is less than 5, giving 7 × 50 = 350; 28 comes from multiplying the leading digits only and losing the place value of the 40, which makes the estimate ten times too small.
- (a) 25 — Reverse the operations in reverse order: undo the subtraction by adding 6, then undo the division by multiplying by 5. −1 + 6 = 5, so the number divided by 5 equals 5, and 5 × 5 = 25 — checking, 25 ÷ 5 − 6 = 5 − 6 = −1. A candidate who subtracted 6 again instead of adding worked out −1 − 6 = −7, then −7 × 5 = −35. A candidate who multiplied by 5 before undoing the subtraction, doing the inverse operations in the wrong order, worked out −1 × 5 = −5, then −5 + 6 = 1. A candidate who multiplied by 5 but forgot to undo the subtraction at all worked out −1 × 5 = −5 and stopped there.
- (b) 1 — Any non-zero number raised to the power 0 equals 1, so 7⁰ = 1. Writing 0 confuses this rule with multiplying by zero. Writing 7 mistakes the power of 0 for leaving the base unchanged, as if nothing happened. Writing 1/7 confuses the zero index with a negative one — it is 7⁻¹ that equals 1/7, while 7⁰ equals 1.
- (a) 0.0069 — Leading zeros are not significant, so the significant figures in 0.006852 start at 6: 6, 8, 5, 2. Rounding to 2 significant figures means keeping 6 and 8, and looking at the next digit, 5, to decide whether to round up. Since 5 rounds up, the second significant figure increases from 8 to 9: 0.006852 rounds to 0.0069. A candidate who rounded to 1 significant figure instead of 2 wrote 0.007. A candidate who rounded to 3 significant figures instead of 2 wrote 0.00685. A candidate who did not round up despite the next digit being 5 wrote 0.0068.
- (c) −1 — Method: find each cube root separately, keeping its sign, and then add the two results. Working: (−3) × (−3) × (−3) = −27, so ∛(−27) = −3, and 2 × 2 × 2 = 8, so ∛8 = 2. Adding gives −3 + 2 = −1. Answer: −1. The distractors: 5 comes from taking the cube root of a negative number as positive, giving 3 + 2; −5 comes from reading the minus sign as applying to the whole sum and working out −(3 + 2); −6 comes from multiplying the two roots, −3 × 2, instead of adding them.
- (d) 0.3 — Converting the fractions to decimals, 1/4 = 0.25 and 2/5 = 0.4, so any decimal between 0.25 and 0.4 is a valid answer, and 0.3 fits. Confusing 1/4 with 1/5 and converting it as 0.2 instead of 0.25 gives a value below the true lower bound. Confusing 2/5 with 1/2 and converting it as 0.5 instead of 0.4 gives a value above the true upper bound. Converting the fractions correctly but choosing a decimal above the true upper bound of 0.4 instead of between the two values gives 0.45.
- (a) 49 — Method: 7² means 7 multiplied by itself. Working: 7 × 7 = 49. Answer: 49. 14 comes from working out 7 × 2, treating the power 2 as a number to multiply by rather than an instruction to multiply 7 by itself. 77 comes from writing the digit 7 twice side by side, treating the power as an instruction to repeat the digit rather than to multiply. 9 comes from working out 7 + 2, adding the base and the power instead of multiplying the base by itself.
- (d) 1050 ml — Convert both amounts to millilitres: 1.8 litres = 1800 ml and 3/4 litre = 750 ml. Subtracting gives 1800 − 750 = 1050 ml. Confusing 3/4 with 75% and converting it as 75 ml instead of 750 ml gives 1800 − 75 = 1725 ml. Adding the amount poured out instead of subtracting it gives 1800 + 750 = 2550 ml. Misreading 1.8 litres as 0.8 litres, losing the whole litre, gives 800 − 750 = 50 ml.
- (b) 1 : 2 — 2/5 of 50 is 20, so there are 20 red counters and 50 − 20 = 30 blue counters. Taking 5 red counters out leaves 15 red and 30 blue, so red : blue = 15 : 30. Dividing both parts by 15 gives 1 : 2. 2 : 3 is the ratio before any counters are removed, 2 : 1 has the two parts the wrong way round, and 4 : 5 comes from taking the 5 counters out of the blue instead of the red.
Build your own mix at the worksheet builder.