Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 7.9 m — Method: the iteration converges on the width of the plot, so run the formula three times from the starting value and then add 4 m, because the length is 4 m greater than the width. Working: x₁ = √(30 − 4 × 3) = √18 = 4.24264…; x₂ = √(30 − 4 × 4.24264…) = √13.02943… = 3.60963…; x₃ = √(30 − 4 × 3.60963…) = √15.56147… = 3.94480…. The estimate for the length is 3.94480… + 4 = 7.94480…, which is 7.9 m correct to 1 decimal place. Answer: 7.9 m. The iteration is still oscillating at x₃, so this is the estimate that three uses of the formula give, not a settled value. The distractors: 3.9 m is x₃ itself, the width, given by a candidate who runs the iteration correctly and then stops before the step the question actually asks for; 7.6 m uses x₂ in place of x₃, one use of the formula short, and then adds the 4 m correctly; 15.8 m multiplies the width by 4 instead of adding 4 m to it, reading greater than as a multiplier.
- (d) x + y = 7 — The midpoint of AB is (−1 + 5)/2, (2 + 8)/2, which is (2, 5). The gradient of AB is (8 − 2)/(5 − (−1)) = 6/6 = 1. The perpendicular bisector has gradient −1 and passes through (2, 5): y − 5 = −(x − 2), which rearranges to x + y = 7. Distractor routes: x − y = −3 uses the gradient of AB itself, 1, rather than its negative reciprocal, giving a line PARALLEL to AB through the midpoint instead of perpendicular to it. x + y = 12 comes from adding the y-coordinates, 2 + 8 = 10, but forgetting to divide by 2, using the midpoint (2, 10) instead of (2, 5). x + y = 4 comes from using A's x-coordinate, −1, directly instead of averaging it with B's, giving the point (−1, 5) instead of the true midpoint (2, 5).
- (c) 12 cm — For a square, area = side². So side² = 144, giving side = ±12. Since a length must be positive, the side length is 12 cm. A candidate who gives both square roots without rejecting the negative one, which cannot be a length, answers 12 cm or −12 cm. A candidate who halves 144 instead of taking its square root gets 72 cm. A candidate who divides 144 by 4, confusing the area formula with a perimeter calculation, gets 36 cm.
- (a) t = 0 or t = 4 — The ball is at ground level exactly when h = 0. From the table, h = 0 at t = 0 and at t = 4, so those are the two times. Distractor origins: t = 1 or t = 3 picks the times with equal (but non-zero) height instead of ground level; t = 2 picks the time of maximum height instead of ground level; t = 0 finds only the starting time and misses the second one.
- (d) 8 — Working backwards by halving (undoing the doubling), one 4-hour step at a time: 9,600 (20 h) → 4,800 (16 h) → 2,400 (12 h) → 1,200 (8 h) → 600 (4 h) → 300 (0 h). Reading these in time order — 300, 600, 1,200, 2,400, 4,800, 9,600 at 0, 4, 8, 12, 16, 20 hours — the population is still at or below 1,000 at 4 hours (600) and first goes above 1,000 at 8 hours (1,200). So the recorded population first exceeds 1,000 at 8 hours. Answering 20 just reads off the time stated in the question, without working out when the threshold was actually first crossed — wrong, because 9,600 is only the value AT 20 hours, not necessarily the first time the population passed 1,000. Answering 0 comes from recovering the starting population by dividing 9,600 by 5 (the number of 4-hour gaps up to 20 hours) instead of by 2⁵ = 32 (the correct number of halvings), giving a wrongly-inflated starting value of 9,600 ÷ 5 = 1,920 — already above 1,000 at 0 hours — wrong, because doubling means the value must be halved five times, dividing by 2 five times (2⁵ = 32), not divided once by the number of gaps. Answering 12 comes from halving back only twice, from 9,600 to 4,800 (16 h) to 2,400 (12 h), and stopping there because 2,400 is already above 1,000, without checking that 1,200 at 8 hours is also above 1,000 and occurs earlier — wrong, because the FIRST recorded time above 1,000 is the earliest such time, not the first one reached while working backwards from 20 hours.
- (d) It crosses the x-axis at x = 3 and x = −3. — y = x² − 9 factorises as (x − 3)(x + 3), since 9 = 3², so the curve crosses the x-axis at x = 3 and x = −3. Saying it crosses once at x = 9 mistakes the constant term for a root directly, without taking its square root. Saying it crosses at x = 9 and x = −9 makes the same mistake but adds a sign either way. Saying it does not cross the x-axis confuses the y-intercept, which is negative at (0, −9), with the number of times the curve meets the x-axis — a negative y-intercept combined with an upward-opening curve guarantees it crosses the x-axis twice.
- (d) w ≤ 630 — 'No more than 630 kg' means the weight can be exactly 630 kg or anything less, so the correct inequality is w ≤ 630, using 'less than or equal to' to include the limit itself. Writing w < 630 excludes 630 kg itself, as though the limit could not be reached exactly. Writing w ≥ 630 reverses the direction, describing a minimum weight rather than a maximum. Writing w > 630 both reverses the direction and excludes the boundary value. The inequality describing the lift's weight limit is w ≤ 630.
- (c) 5(x + y − 1) — Method: take out the highest common factor of all three terms and divide every term by it, the number term included. Working: the highest common factor of 5x, 5y and −5 is 5; dividing gives 5x ÷ 5 = x, 5y ÷ 5 = y and −5 ÷ 5 = −1, so the bracket holds x + y − 1. Answer: 5(x + y − 1), which multiplies back out to 5x + 5y − 5. The distractors: 5(x + y + 1) comes from dividing −5 by 5 and losing the minus sign; 5(x + y − 5) comes from dividing only the terms containing a letter by 5 and carrying the −5 into the bracket unchanged; 5(xy − 1) comes from collecting the unlike terms 5x and 5y as 5xy before factorising.
- (d) $y = x^2 + 3$ — Method: a point lies on a curve only if substituting its x-coordinate into the equation gives back its y-coordinate, so read one or two points off curve B and test each equation. Working: curve B crosses the y-axis at (0, 3), and its lowest point is also (0, 3); substituting x = 0 into y = x² + 3 gives 0² + 3 = 3, which matches. Checking a second point: at x = 2 curve B is at y = 7, and 2² + 3 = 4 + 3 = 7, which matches as well. Answer: curve B has equation y = x² + 3. Distractor refutation: y = x² − 3 comes from reading the 3 as a move down instead of a move up; substituting x = 0 gives −3, so that curve would cross the y-axis three squares below the origin, while curve B crosses it three squares above. y = (x − 3)² comes from putting the 3 inside the brackets; substituting x = 0 gives (−3)² = 9, and that curve's lowest point is at (3, 0), three squares to the right along the x-axis, whereas curve B has its lowest point on the y-axis. y = x² + 3x comes from attaching the 3 to the x term instead of writing it on its own; substituting x = 0 gives 0² + 3 × 0 = 0, so that curve passes through the origin, and curve B does not pass through the origin.
- (d) 28 — The height decreases by 8 cm at each bounce after the first, so the nth bounce reaches 60−(n−1)×8 cm. For the 5th bounce: 60−4×8=60−32=28. A candidate who subtracts 8 one time too many, five times instead of four, would compute 60−5×8=20. A candidate who adds the decrease instead of subtracting it, a sign error, would compute 60+4×8=92. A candidate who works out only the total decrease and forgets to include the starting height of 60 cm would compute just 5×8=40.
- (b) 6x − 3 = 4x + 9 — Method: multiply every term inside the bracket by the number outside it; the right-hand side stays as it is given. Working: 3 × 2x = 6x and 3 × (−1) = −3, so 3(2x − 1) = 6x − 3. Answer: 6x − 3 = 4x + 9. 6x − 1 = 4x + 9 comes from multiplying only the 2x by 3 and leaving the −1 unchanged. 5x − 3 = 4x + 9 comes from adding the 3 to the 2 instead of multiplying, treating 3 × 2x as (3 + 2)x = 5x. 6x − 4 = 4x + 9 comes from working out 3 × (−1) as −1 − 3 = −4 instead of 3 × (−1) = −3.
- (b) 2x + 3 — fg(x) means f(g(x)): apply g first, then apply f to the result. g(x) = 2x, so f(g(x)) = f(2x) = 2x + 3. Writing 2x + 6 comes from working out gf(x) instead — g(f(x)) = g(x + 3) = 2(x + 3) = 2x + 6 — which applies the functions in the wrong order. Writing 3x + 3 comes from adding f(x) and g(x) together, (x + 3) + 2x = 3x + 3, instead of composing them. Writing 2x² + 6x comes from multiplying f(x) and g(x) together, (x + 3)(2x) = 2x² + 6x, instead of substituting one into the other.
- (c) 6 — Method: substitute the value, work out the top of the fraction first, then the division, and add the 3 last. Working: the top gives 10 − 4 = 6, dividing by 2 gives 6 ÷ 2 = 3, and adding 3 gives 3 + 3 = 6. Answer: 6. The distractors: 11 comes from dividing only the 4 by 2 instead of the whole of the top, giving 10 − 2 + 3; 4.5 comes from dividing the + 3 by 2 as well, giving (10 − 4 + 3) ÷ 2; 0 comes from subtracting the wrong way round on the top, giving (4 − 10) ÷ 2 = −3 and then −3 + 3.
- (b) y = 2x and y = −(1/2)x + 1 — Method: two lines are perpendicular when the product of their gradients is −1, so the gradient of each line is read from the number multiplying x and the two are multiplied together. Working: for y = 2x and y = −(1/2)x + 1 the gradients are 2 and −1/2, and 2 × (−1/2) = −1, so that pair is perpendicular. Answer: y = 2x and y = −(1/2)x + 1. The distractors: the pair y = 2x and y = 2x + 1 has equal gradients, whose product is 4, so those two lines are parallel and never meet, and they are chosen by a candidate applying the parallel condition; the pair y = 2x and y = −2x + 1 comes from changing the sign of the gradient without turning it upside down, and its product is −4; the pair y = 2x and y = (1/2)x + 1 comes from turning the gradient upside down without changing its sign, and its product is 1.
- (d) 40 m — Each trapezium has width 2. Its area is width × the average of its two heights. Strip 1: average of 0 and 5 is 2.5, so area = 2 × 2.5 = 5. Strip 2: average of 5 and 9 is 7, so area = 2 × 7 = 14. Strip 3: average of 9 and 12 is 10.5, so area = 2 × 10.5 = 21. Total distance = 5 + 14 + 21 = 40 m. Leaving out the division by 2 in the averaging step doubles every strip, giving 80 m instead of 40 m. Using only the LEFT height of each strip as a rectangle, 0 × 2 + 5 × 2 + 9 × 2 = 28, or only the RIGHT height, 5 × 2 + 9 × 2 + 12 × 2 = 52, both ignore that the graph curves between the two ends of each strip — always average the two heights of a trapezium, never use just one of them.
Build your own mix at the worksheet builder.