Geometry and measures worksheet — GCSE Higher

1.Shape S is enlarged by a scale factor of −3 about a fixed centre. Which statement correctly describes the image compared to the original shape?

2.p is the column vector with top number 2 and bottom number 3. q is the column vector with top number −1 and bottom number 4. Work out 2p + q, giving your answer as a column vector in the form (top, bottom).

3.A sector of a circle has radius 8 cm and takes up three-quarters of the full circle. Work out the perimeter of the sector, in terms of π.

4.A rectangle has vertices at (2, 1), (9, 1), (9, 5) and (2, 5). Work out the area of the rectangle.

5.A tank holds 3.2 m³ of water. Work out this volume in litres.

6.A landscaper marks out two triangular flower beds using stakes and a tape measure. Bed 1 has two edges of 5 m and 7 m, meeting at a corner with a marked angle of 60° between them. Bed 2 has edges of 5 m and 7 m, meeting at a corner also marked at 60° between them. The landscaper wants to check the two beds will be exactly the same size and shape using only these three measurements. Which condition proves the two beds are congruent?

7.Lines JK and LM are parallel. A straight line crosses JK at point P and crosses LM at point Q. Angle KPQ = 118°. Angle KPQ and angle MQP are co-interior (allied) angles. Work out angle MQP.

8.A support strut for a shed roof is in the shape of a right-angled triangle. The two shorter sides of the strut are 5 m and 9 m. Work out the length of the sloping strut (the hypotenuse). Give your answer correct to 1 decimal place.

9.In triangle ABC the angle at C is 90°, AC = 8 cm and the angle at A is 30°. Work out the length of BC. Give your answer to 1 decimal place.

10.A cable supporting a flagpole is anchored to the ground 5 m from the base of the pole. The cable makes an angle of 60° with the ground. Using the exact value of tan 60°, work out the exact height of the flagpole.

11.Two metal window frames are checked before installation. Frame A has edges of 40 cm and 65 cm, with a marked angle of 35° at the far end of the 65 cm edge, away from where the two given edges meet. Frame B has matching edges of 40 cm and 65 cm, with a matching 35° angle in the same position. The fitter wants to know if these measurements alone guarantee the two frames are congruent. What should the fitter be told?

12.Two straight roads cross at a junction. The angle between them, measured with a protractor, is 118°. What is the size of the angle vertically opposite to it?

13.Triangle A has vertices (2, 1), (5, 1) and (2, 4). It is translated by the vector (−3, 2) and the image is then reflected in the x-axis. Work out the coordinates of the image of (5, 1).

14.A solid cone has a base radius of 6 cm and a vertical height of 10 cm. Work out the volume of the cone. Use π = 3.14 and give your answer correct to 1 decimal place.

15.Two traffic cones are geometrically similar. The smaller cone has height 6 m and the larger cone has height 9 m. Work out the ratio of the volume of the smaller cone to the volume of the larger cone, giving your answer in the form a : b in its simplest form.