Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 93.9975 — Each measurement was rounded to 1 decimal place, so the error is half of 0.1: length is 12.35 ≤ L < 12.45, and width is 7.45 ≤ W < 7.55. The upper bound for the area comes from multiplying the upper bounds of both dimensions: 12.45 × 7.55 = 93.9975 m². Using the lower bound of both dimensions instead, 12.35 × 7.45 = 92.0075 m², gives the lower bound of the area rather than the upper one. Multiplying the two given rounded values directly, 12.4 × 7.5 = 93, forgets that a rounded measurement is not exact and needs its own error interval. Bounding only the length and leaving the width at its given value, 12.45 × 7.5 = 93.375, misses that the width also has an upper bound of its own.
- (b) 4 m — Blue fabric is 3 parts and this equals 1.5 m, so one part is 1.5 ÷ 3 = 0.5 m. Yellow fabric is 5 parts, so it is 5 × 0.5 = 2.5 m. The total length is 1.5 + 2.5 = 4 m. 2.5 m is the length of yellow fabric only, without adding the blue fabric back in. 1.5 m is just the given length of blue fabric, with the yellow fabric never worked out. 2.4 m comes from swapping the ratio, treating blue as 5 parts and yellow as 3 parts, giving one part as 1.5 ÷ 5 = 0.3 m and yellow as 3 × 0.3 = 0.9 m, then adding 1.5 + 0.9 = 2.4.
- (c) −28 — 6² = 36 and 4³ = 64. Work out 36 − 64 = −28. A candidate who subtracts in the wrong order gets 64 − 36 = 28. A candidate who adds instead of subtracting gets 36 + 64 = 100. A candidate who multiplies the base by the exponent instead of raising the power (6 × 2 − 4 × 3 = 12 − 12) gets 0.
- (c) x⁽²⁄³⁾ — Method: a root can be written as a fractional index, with the root's index as the denominator and the power inside the root as the numerator. Working: the cube root gives a denominator of 3 and the square inside gives a numerator of 2, so ∛(x²) = x⁽²⁄³⁾. Answer: x⁽²⁄³⁾. The distractors: x⁽³⁄²⁾ comes from writing the fraction upside down, with the root's index on top; x⁽¹⁄⁶⁾ comes from treating the square as a second root and multiplying 1/3 by 1/2; x⁶ comes from multiplying the root's index by the power, 3 × 2, and keeping the result as a whole-number index.
- (c) 5 × 10⁻³ — Method: in standard form the coefficient must be at least 1 and less than 10, and for a number smaller than 1 the index is negative and counts the places the decimal point moves to the right. Working: the only significant digit is 5, so the coefficient is 5; moving the decimal point in 0.005 three places to the right gives 5, so the index is −3. Answer: 5 × 10⁻³. The distractors: 0.5 × 10⁻² is the same value written the wrong way, because 0.5 is smaller than 1 and so is not an allowed coefficient; 5 × 10⁻² comes from counting the two zeros after the decimal point instead of the three places the point moves; 5 × 10³ comes from taking the index as positive, which describes a number in the thousands rather than one smaller than 1.
- (b) 5 — Method: find the square root first, then divide. Working: √225 = 15, and 15 ÷ 3 = 5. Answer: 5. (75 comes from dividing 225 by 3 first and forgetting to take the square root at all. 8.7 comes from dividing 225 by 3 inside the root, √(225 ÷ 3) ≈ 8.7, instead of taking the root first. 45 comes from misreading the divisor as 5 instead of 3, working out 225 ÷ 5 = 45.)
- (a) 13 °C — Method: subtract the lowest temperature from the highest temperature to find the difference. Working: the highest temperature is 6 °C and the lowest is −7 °C. Difference = 6 − (−7) = 6 + 7 = 13. Answer: 13 °C. 8 °C comes from using −2 °C as the lowest temperature instead of −7 °C: 6 − (−2) = 8. 5 °C comes from finding the difference between the two negative temperatures instead of the highest and lowest: −2 − (−7) = 5. −1 °C comes from adding the highest and lowest temperatures instead of subtracting: 6 + (−7) = −1.
- (b) 7 — Method: trap the number between the two square numbers on either side of it, then decide which of them it is nearer to. Working: 6² = 36 and 7² = 49, so √45 lies between 6 and 7; 49 − 45 = 4 while 45 − 36 = 9, so 45 is nearer to 49. Answer: 7. The distractors: 6 comes from taking the square number below 45 and stopping there, without checking which of 36 and 49 is nearer; 22.5 comes from halving 45 instead of looking for the number that multiplies by itself to give 45; 2,025 comes from squaring 45 instead of taking its square root.
- (b) 1 — Method: BIDMAS deals with the index before the subtraction, and a negative number multiplied by itself gives a positive result. Working: (−2)² = (−2) × (−2) = 4, so the calculation becomes 4 − 3 = 1. Answer: 1. The distractors: −7 comes from squaring only the 2 and leaving the minus sign outside the index, giving −(2²) − 3 = −4 − 3 = −7; −1 comes from subtracting the square from 3 instead of 3 from the square, giving 3 − 4 = −1; 25 comes from carrying out the subtraction before the index, giving (−2 − 3)² = (−5)² = 25.
- (a) 3 — Method: the fourth root of a number is the positive value that gives that number when it is multiplied by itself four times. Working: 2 × 2 × 2 × 2 = 16, which is too small, and 3 × 3 × 3 × 3 = 9 × 9 = 81. Answer: 3. The distractors: 9 comes from taking the square root of 81 instead of its fourth root; 4.5 comes from taking the square root and then halving it, as though a fourth root were half a square root; 20.25 comes from dividing 81 by 4, treating the root's index as a divisor.
- (c) 0.001 — Method: a negative index means 'one over' the positive power, so $10^{-3}$ means one over $10^{3}$. Working: ten cubed is 1000, and one over 1000 is 0.001. 1000 comes from ignoring the negative sign and working out ten cubed instead of its reciprocal. −1000 comes from ignoring what the negative index does to the size, while still writing a negative sign on the large value. −0.001 comes from correctly finding the size, 0.001, but wrongly keeping a negative sign because the index was negative. Answer: 0.001.
- (b) 30 — 70 is close to the perfect square 64, so √70 ≈ 8. 65 is close to the perfect cube 64, so ∛65 ≈ 4. Multiplying these estimates: 8 × 4 = 32, which rounds to 30 to 1 significant figure. Estimating ∛65 as 5 instead of 4, perhaps by confusing it with the nearby cube 125 = 5³ rather than the much closer 64 = 4³, and then multiplying by 8, gives 8 × 5 = 40. Adding the two estimates instead of multiplying them, 8 + 4 = 12, rounds to 10 to 1 significant figure. Rounding both estimates up to the next whole number using the wrong nearby power for each, taking √70 as 9 and ∛65 as 5, gives 9 × 5 = 45, which rounds to 50 to 1 significant figure.
- (a) 6 — Method: the two scoops sit in different places on the cone, so a cone is an ordered choice; the possibilities can be listed systematically or counted by multiplying the choices available at each stage. Working: there are 3 flavours for the bottom scoop, and once that flavour is used only 2 flavours remain for the top scoop, so there are 3 × 2 = 6 cones; listing them confirms this, since vanilla on the bottom allows mango or pistachio on top, mango on the bottom allows vanilla or pistachio, and pistachio on the bottom allows vanilla or mango. Answer: 6. The distractors: 3 comes from treating the two scoops as interchangeable, so that vanilla under mango and mango under vanilla are counted as one cone; 9 comes from allowing the same flavour to be used for both scoops, giving 3 × 3; 5 comes from adding the 3 choices for the bottom scoop to the 2 choices left for the top scoop instead of multiplying them.
- (a) 2/3 — Total parts = 6 + 4 + 5 = 15. Sopranos and altos together are not tenors: 6 + 4 = 10 parts, so the fraction is 10/15, which simplifies to 2/3. 1/3 comes from finding the fraction of tenors instead of the fraction that is not tenors. 2/5 comes from counting only the sopranos as not tenors and leaving the altos out. 4/9 comes from leaving sopranos out of the total, 4 + 5 = 9, and then using only the altos as the fraction that is not tenors.
- (a) 8.35 ≤ L < 8.45 — Method: a length rounded to 1 decimal place lies within half of 0.1 cm, that is 0.05 cm, of the value written down. The lower limit is included because it rounds up to that value, and the upper limit is excluded because it rounds up to the next value instead. Working: 8.4 − 0.05 = 8.35 and 8.4 + 0.05 = 8.45, so a length of 8.35 cm still rounds to 8.4 cm while a length of 8.45 cm rounds to 8.5 cm. Answer: 8.35 ≤ L < 8.45. The distractors: 8.3 ≤ L < 8.5 goes a whole 0.1 cm either side instead of half of it; 8.35 < L ≤ 8.45 has the two limits the wrong way round, excluding the length that does round to 8.4 cm and including the one that does not; 8.4 ≤ L < 8.5 is the interval for a length truncated to 1 decimal place, not one rounded to it.
Build your own mix at the worksheet builder.