Printable · GCSE Foundation · ages 14-16
Number worksheet — GCSE Foundation
Fifteen questions across the number statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Number worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) 24.69 — To round to 2 decimal places, look only at the third decimal digit to decide whether the second decimal digit rounds up. In 24.6851 the third decimal digit is 5, and since 5 is 5 or more, the second decimal digit rounds up from 8 to 9, giving 24.69. Rounding to 1 decimal place instead of 2 gives 24.7, one place value too coarse. Keeping the third decimal digit rather than dropping it gives 24.685, which is 3 decimal places. Looking at the fourth decimal digit, 1, instead of the third one, and wrongly deciding that no rounding is needed, leaves the length unrounded at 24.68.
- (a) The tape can only give the length to the nearest centimetre — Method: a measurement should never be written to a finer degree of accuracy than the instrument used can read. Working: the tape is marked in centimetres, so the smallest division Leah can read is 1 cm, which is 0.01 m and two decimal places in metres; writing 7.3157 m claims the length to the nearest tenth of a millimetre, four decimal places, which the markings cannot support. A record of 7.32 m, to the nearest centimetre, is what this tape justifies. Answer: The tape can only give the length to the nearest centimetre. The distractors: the nearest millimetre contradicts the markings described in the question, which are centimetres, and would still claim more accuracy than the tape offers; the rule that a length in metres must be written to 2 decimal places borrows the habit of writing money to the penny, when the accuracy of a length depends on the instrument; rounding to the nearest metre would throw away accuracy the tape genuinely provides.
- (a) 20 — Method: round each number to 1 significant figure, then divide. Working: 397 rounds to 400 and 21 rounds to 20, so the estimate is 400 ÷ 20 = 20. Answer: 20. The distractors: 19 comes from not estimating at all, since 397 ÷ 21 = 18.9 to 1 decimal place, which rounds to 19, while the question asks for an estimate from rounded numbers; 200 comes from dividing 400 by 2 instead of by 20, losing the place value of the rounded divisor; 2 comes from dividing the leading digits only and losing the place value of both numbers.
- (c) 125 — Method: a number cubed means multiplying the number by itself three times. Working: 5 × 5 × 5 = 125. 15 comes from working out 5 × 3 = 15, multiplying by the index instead of cubing. 8 comes from working out 5 + 3 = 8 instead of cubing. 53 comes from writing the base and the index next to each other instead of carrying out the calculation. Answer: 125.
- (a) 17 — Method: work out each power separately, then combine them as the question asks. Working: $2^3 = 8$ and $3^2 = 9$, and 8 + 9 = 17. 72 comes from working out 8 × 9 = 72, multiplying the two powers instead of adding them. 12 comes from misreading the powers as repeated multiplication of the base by the index, 2 × 3 + 3 × 2 = 6 + 6 = 12. −1 comes from working out 8 − 9 = −1, subtracting the powers instead of adding them. Answer: 17.
- (a) £6 — 10% of £40 is £4, and 5% of £40 is half of that, £2. Adding these gives 15% of £40 = £4 + £2 = £6. Finding only the 10% part and stopping there gives £4. Finding only the 5% part and stopping there gives £2. Multiplying 40 by 15 without dividing by 100 gives £600, which treats the percentage as if it were a whole number multiplier.
- (b) £3.70 — Work in one unit throughout. 45p is £0.45, so three pens cost 3 × £0.45 = £1.35. Adding the notebook gives £1.35 + £2.35 = £3.70. £2.80 is the cost of one pen and the notebook, so the multiplication by 3 has been left out; £8.40 multiplies the notebook by 3 as well as the pens; £15.85 comes from reading 45p as £4.50.
- (d) 11 mm — Method: for a square, the side length is the square root of the area. Working: 11 × 11 = 121, so the side length is 11 mm. 60.5 mm comes from working out 121 ÷ 2 = 60.5, halving the area instead of finding its square root. 242 mm comes from working out 121 × 2 = 242, doubling the area instead of finding its square root. 22 mm comes from working out 11 × 2 = 22, doubling the correct side length. Answer: 11 mm.
- (d) 0.024 cm — Method: significant figures are counted from the first non-zero digit; the zeros in front of it only fix the place value and are not significant. Working: in 0.02384 the first significant figure is 2 and the second is 3, so the rounding is decided by the next digit, 8. As 8 is 5 or more, the second significant figure goes up from 3 to 4, in the same place value. Answer: 0.024 cm. The distractors: 0.023 cm comes from chopping the 84 off instead of rounding it; 0.02 cm comes from counting the leading zeros as significant figures, so the 2 is taken as the second figure and the rounding stops there; 0.0238 cm is 0.02384 correct to 3 significant figures, one figure too many.
- (c) 1,000 m² — Method: round each length to 1 significant figure, then use area of a rectangle = length × width on the rounded lengths. Working: 19.6 m rounds to 20 m and 48.3 m rounds to 50 m, so the estimate is 20 × 50 = 1,000 and the area is about 1,000 m². Answer: 1,000 m². The distractors: 800 m² comes from rounding 48.3 down to 40 when the digit after its first significant figure is 8 and sends it up to 50, giving 20 × 40 = 800; 140 m² is the perimeter of the rounded rectangle, 2 × 20 + 2 × 50 = 140, not its area; 70 m² comes from adding the rounded lengths, 20 + 50 = 70, instead of multiplying them.
- (c) 2/3 — Method: fractions with the same denominator are added by adding the numerators and leaving the denominator alone, because the parts are already the same size. Working: 1/3 + 1/3 has numerators 1 + 1 = 2 and the denominator stays as 3, giving 2/3. Answer: 2/3. The distractors: 2/6 comes from adding the denominators as well as the numerators, 1 + 1 over 3 + 3; 2/9 comes from adding the numerators but multiplying the denominators, 1 + 1 over 3 × 3; 1/9 comes from multiplying throughout instead of adding, 1 × 1 over 3 × 3.
- (c) 12 — Method: division and multiplication have equal priority, so they are carried out in the order they are written, from left to right; a negative divided by a negative is positive. Working: (−36) ÷ (−6) = 6, and then 6 × 2 = 12. Answer: 12. The distractors: 3 comes from carrying out the multiplication first, (−6) × 2 = −12 followed by (−36) ÷ (−12) = 3; −12 comes from treating a negative divided by a negative as negative, giving −6 and then −6 × 2 = −12; 6 comes from stopping at the division and never carrying out the multiplication by 2.
- (a) 0.08 — Method: decimal places are counted from the decimal point, including any zeros straight after it, so rounding to 2 decimal places is decided by the digit in the third decimal place. Working: 0.0759 has 7 in the second decimal place and 5 in the third, and 5 counts as rounding up, so the 7 goes up to 8. Answer: 0.08. The distractors: 0.07 comes from chopping the digits after the second decimal place off instead of rounding them; 0.076 is 0.0759 correct to 2 significant figures rather than 2 decimal places, because the zeros in front of the 7 are not significant figures; 0.1 is 0.0759 rounded to 1 decimal place, a coarser degree of accuracy than the question asks for.
- (d) the first mark after 0 — Method: when a unit length is split into equal parts, each gap is one part of the whole, so 1/4 is one gap along from 0. Working: four equal parts means each gap measures 1/4, so the marks after 0 stand for 1/4, 2/4, 3/4 and 4/4. One gap along from 0 is therefore the mark for 1/4. Answer: the first mark after 0. The distractors: the second mark after 0 comes from counting 0 itself as the first mark; the third mark after 0 comes from counting back from the 1 end instead of forward from 0; the fourth mark after 0 comes from reading the 4 in the denominator as the number of the mark rather than the number of parts.
- (b) 9/25 — Method: write the decimal over the matching power of ten, then divide the numerator and the denominator by their highest common factor. Working: 0.36 has two digits after the point, so 0.36 = 36/100; the highest common factor of 36 and 100 is 4, and 36 ÷ 4 = 9 with 100 ÷ 4 = 25; since 9 and 25 share no factor greater than 1, the fraction is fully cancelled. Answer: 9/25. The distractors: 3/10 comes from reading only the first digit after the point and converting 0.3; 9/50 comes from dividing the numerator by 4 but the denominator by only 2; 36/10 comes from counting one decimal place instead of two and writing the digits over 10.
Build your own mix at the worksheet builder.